3D heat transfer analysis in a loop heat pipe evaporator with a fully saturated wick

Abstract A practical quasi three-dimensional numerical model is developed to investigate the heat and mass transfer in a square flat evaporator of a loop heat pipe with a fully saturated wicking structure. The conjugate heat transfer problem is coupled with a detailed mass transfer in the wick structure, and incorporated with the phase change occurring at the liquid–vapor interface. The three-dimensional governing equations for the heat and mass transfer (continuity, Darcy and energy) are developed, with specific attention given to the wick region. By comparing the results of the numerical simulations and the experimental tests, the local heat transfer mechanisms are revealed, through the obtained temperature distribution and the further derived evaporation rates along the liquid–vapor interface. The results indicate that the model developed herein can provide an insight in understanding the thermal characteristics of loop heat pipes during steady-state operation, especially at low heat loads.

[1]  G. Peterson,et al.  3-Dimensional numerical optimization of silicon-based high performance parallel microchannel heat sink with liquid flow , 2007 .

[2]  Yu.F. Maydanik,et al.  Loop heat pipes , 2005 .

[3]  A. S. Demidov,et al.  Investigation of heat and mass transfer in the evaporation zone of a heat pipe operating by the ‘inverted meniscus’ principle , 1994 .

[4]  M. A. Chernysheva,et al.  Operating temperature and distribution of a working fluid in LHP , 2007 .

[5]  Jocelyn Bonjour,et al.  Parametric analysis of loop heat pipe operation: a literature review , 2007 .

[6]  Marc Prat,et al.  Heat and mass transfer with phase change in aporous structure partially heated: continuum model andpore network simulations , 1999 .

[7]  Y. Maydanik,et al.  Miniature loop heat pipes - a promising means for cooling electronics , 2005, The Ninth Intersociety Conference on Thermal and Thermomechanical Phenomena In Electronic Systems (IEEE Cat. No.04CH37543).

[8]  S. Chi.  Heat pipe theory and practice , 1976 .

[9]  Guiping Lin,et al.  Mathematical modeling of steady-state operation of a loop heat pipe , 2009 .

[10]  John Goldak,et al.  Numerical analysis of heat and mass transfer in the capillary structure of a loop heat pipe , 2006 .

[11]  Daming Wang,et al.  Experimental studies on a high performance compact loop heat pipe with a square flat evaporator , 2010 .

[12]  Jentung Ku,et al.  Operating Characteristics of Loop Heat Pipes , 1999 .

[13]  Aliakbar Akbarzadeh,et al.  Effect of Wick Characteristics on the Thermal Performance of the Miniature Loop Heat Pipe , 2009 .

[14]  M. A. Chernysheva,et al.  Numerical simulation of transient heat and mass transfer in a cylindrical evaporator of a loop heat pipe , 2008 .

[15]  P. Cheng,et al.  Three-dimensional analysis of heat transfer in a micro-heat sink with single phase flow , 2004 .

[16]  G. Peterson,et al.  Development of a Robust Miniature Loop Heat Pipe for High Power Chip Cooling , 2009 .

[17]  Yiding Cao,et al.  Conjugate analysis of a flat-plate type evaporator for capillary pumped loops with three-dimensional vapor flow in the groove , 1994 .