An experimental investigation of stability and operation of a biogas fueled porous burner

Abstract Porous media combustion constitutes a particularly attractive technology, allowing operation in ultra-lean combustion regimes with excellent fuel interchangeability and low levels of pollutant emissions. This work presents a comprehensive experimental characterization of a state-of-the-art porous burner fuelled with a simulated biogas mixture, in terms of thermal efficiency and pollutant emissions. The combustor is a rectangular two-layer porous burner with an Al 2 O 3 flame trap and a 10 ppi (pores per inch) SiSiC foam. The burner was operated with a mixture of 60% methane and 40% carbon dioxide. An extensive stability mapping was performed in order to establish the range of operation in terms of thermal loads and mixture equivalence ratios. Gas and solid phase temperature profiles were measured using thermocouples and infrared thermography respectively, and gaseous emissions were quantified using an online gas analyser sampling system and a gas chromatographer. The results revealed wide stability with respect to thermal loads, low NO x and CO levels, and negligible hydrocarbon emissions. The effects of CO 2 addition on burner operation and efficiency, the relative impact of thermal load on temperature and emission values with respect to equivalence ratio were investigated. The comparably strong physical effect of the CO 2 addition was discussed against its chemical impact on the processes.

[1]  Dimosthenis Trimis,et al.  Combustion in a Porous Medium-Advances and Applications , 1996 .

[2]  Isaac F. Silvera,et al.  Temperature dependence of the emissivity of platinum in the IR. , 2008, The Review of scientific instruments.

[3]  P. Muthukumar,et al.  Development of novel porous radiant burners for LPG cooking applications , 2013 .

[4]  Dimosthenis Trimis,et al.  Heat transfer analysis of a two-dimensional rectangular porous radiant burner , 2006 .

[5]  Janet L. Ellzey,et al.  Numerical study of the effects of material properties on flame stabilization in a porous burner , 2003 .

[6]  M. Abdul Mujeebu,et al.  Applications of porous media combustion technology - A review , 2009 .

[7]  Dimosthenis Trimis,et al.  Combustion of Low Calorific Gases from Landfills and Waste Pyrolysis Using Porous Medium Burner Technology , 2006 .

[8]  Dimosthenis Trimis,et al.  Numerical and experimental investigation of matrix-stabilized methane/air combustion in porous inert media , 2000 .

[9]  M. Founti,et al.  A Detailed Kinetic Modeling Study of Benzene Oxidation and Combustion in Premixed Flames and Ideal Reactors , 2011 .

[10]  Andrew T. Harris,et al.  Porous burners for lean-burn applications , 2008 .

[11]  J. Wunning,et al.  Flameless oxidation to reduce thermal no-formation , 1997 .

[12]  R. Echigo,et al.  An analysis of flame stabilization mechanism in radiation burners , 1991 .

[13]  J. Howell,et al.  Experimental and Numerical Study of Premixed Combustion Within Nonhomogeneous Porous Ceramics , 1993 .

[14]  Masashi Katsuki,et al.  Advanced low NOx combustion using highly preheated air , 2001 .

[15]  K. Cen,et al.  Gas and solid phase temperature measurements of porous media combustion , 2011 .

[16]  J. Pereira,et al.  Calculation of premixed combustion within inert porous media with model parametric uncertainty quantification , 2011 .

[17]  Epaminondas Mastorakos,et al.  Hydrogen production from rich combustion in porous media , 2005 .

[18]  W. Hsieh,et al.  Experimental investigation of combustion in porous heating burners , 2004 .

[19]  Robert W. Dibble,et al.  Gas temperature above a porous radiant burner: Comparison of measurements and model predictions , 1996 .

[20]  M. Modest.  Radiative heat transfer , 1993 .

[21]  A. Leipertz,et al.  Non-intrusive gas-phase temperature measurements inside a porous burner using dual-pump CARS , 2009 .

[22]  T. W. Tong,et al.  An experimental and theoretical study of porous radiant burner performance , 1991 .

[23]  Jose C. F. Pereira,et al.  Comparison of four combustion models for simulating the premixed combustion in inert porous media , 1998 .

[24]  Jose C. F. Pereira,et al.  A numerical study of the stability of one-dimensional laminar premixed flames in inert porous media , 2008 .

[25]  Ø. Skreiberg,et al.  A comparison of low-NOx burners for combustion of methane and hydrogen mixtures , 2002 .

[26]  J. Ellzey,et al.  COMPUTATIONAL AND EXPERIMENTAL STUDY OF A TWO-SECTION POROUS BURNER , 2004 .

[27]  A. Leipertz,et al.  Investigation of porous media combustion by coherent anti-Stokes Raman spectroscopy , 2010 .

[28]  Dennis Y.C. Leung,et al.  A review of biomass-derived fuel processors for fuel cell systems , 2009 .

[29]  Ryozo Echigo,et al.  Superadiabatic combustion in a porous medium , 1993 .

[30]  Ya-Ling He,et al.  Experimental Study of Biogas Combustion in a Two-Layer Packed Bed Burner , 2011 .

[31]  Mário Costa,et al.  Non-uniform velocity profile mechanism for flame stabilization in a porous radiant burner , 2011 .

[32]  Bassam B. Dally,et al.  Investigation of NOx conversion characteristics in a porous medium , 2008 .

[33]  E. Mastorakos,et al.  Syngas production from liquid fuels in a non-catalytic porous burner , 2011 .

[34]  Maria A. Founti,et al.  Porous burners for low emission combustion: An experimental investigation , 2012 .