A Study on Crack Damage Stress Thresholds of Different Rock Types Based on Uniaxial Compression Tests

When rock samples are loaded until macroscopic fractures develop, the failure process can be divided into several stages based on axial and lateral strain responses or the acoustic emission sequence during uniaxial compression tests. Several stress thresholds may be identified: the crack closure stress σcc, crack initiation stress σci, crack damage stress σcd, and uniaxial compressive strength σucs; these may be used as a warning indicator for rock rupture. We investigated the crack damage stress σcd, its threshold, and a possible relationship between σcd and the uniaxial compressive strength. The σcd of different rock types were compiled from previous studies based on uniaxial compression tests. The results showed that the overall averages and standard deviations of σcd/σucs for igneous, metamorphic, and sedimentary rocks were ~0.78 (±0.11), ~0.85 (±0.11), and ~0.73 (±0.18), respectively. There were no significant differences in σcd/σucs between the different rock types, except that the sedimentary rock had a slightly larger standard deviation attributed to the variation of porosity in the samples, while the metamorphic rock had higher average σcd/σucs resulting from the small statistical sample size. By excluding the higher-porosity (>10 %) rock samples, the averages and standard deviations of σcd/σucs for igneous, metamorphic, and sedimentary rocks were ~0.78 (±0.09), ~0.85 (±0.09), and ~0.78 (±0.11), respectively. The results imply that the rock origin process (i.e., igneous, metamorphic, and sedimentary) has a minimal effect on σcd/σucs. The ratio σcd/σucs could be an essential intrinsic property for low-porosity rocks, which could be used in rock engineering for predicting the failure process.

[1]  Valentin Gischig,et al.  Experimental Study of the Brittle Behavior of Clay shale in Rapid Unconfined Compression , 2011 .

[2]  Ming Cai,et al.  Generalized crack initiation and crack damage stress thresholds of brittle rock masses near underground excavations , 2004 .

[3]  B. Stimpson,et al.  CHANGES IN ACOUSTIC EVENT PROPERTIES WITH PROGRESSIVE FRACTURE DAMAGE , 1997 .

[4]  Zhang Yong-xing.  EXPERIMENTAL INVESTIGATIONS ON STATIC LOADING RATE EFFECTS ON MECHANICAL PROPERTIES AND ENERGY MECHANISM OF COARSE CRYSTAL GRAIN MARBLE UNDER UNIAXIAL COMPRESSION , 2012 .

[5]  Chuangbing Zhou,et al.  Experimental investigation and micromechanical analysis of damage and permeability variation in brittle rocks , 2010 .

[6]  M. Dusseault,et al.  Effect of strain rate on the mechanical properties of salt rock , 2011 .

[7]  M. S. Diederichsa,et al.  Damage initiation and propagation in hard rock during tunnelling and the influence of near-face stress rotation , 2004 .

[8]  Dian-Qing Li,et al.  Micromechanical analysis of anisotropic damage and its influence on effective thermal conductivity in brittle rocks , 2012 .

[9]  Soo-Ho Chang,et al.  Estimation of cracking and damage mechanisms in rock under triaxial compression by moment tensor analysis of acoustic emission , 2004 .

[10]  Tong Liu,et al.  A method for assessment of excavation damaged zone (EDZ) of a rock mass and its application to a dam foundation case , 2009 .

[11]  C. Martin,et al.  Evaluation of Methods for Determining Crack Initiation in Compression Tests on Low-Porosity Rocks , 2012, Rock Mechanics and Rock Engineering.

[12]  Erling Nordlund,et al.  Failure process analysis of spalling failure—Comparison of laboratory test and numerical modelling data , 2012 .

[13]  C. D. Martin,et al.  Estimating the potential for spalling around a deep nuclear waste repository in crystalline rock , 2009 .

[14]  Z. T. Bieniawski,et al.  Mechanism of brittle fracture of rockPart Itheory of the fracture process , 1967 .

[15]  N. Cristescu.  New Trends in Rock Mechanics , 2002 .

[16]  F. Pellet,et al.  Mechanical damage of an anisotropic porous rock in cyclic triaxial tests , 2002 .

[17]  F. Pellet,et al.  Mechanical damage of a crystalline rock having experienced ultra high deviatoric stress up to 1.7 GPa , 2011 .

[18]  V. Palchik,et al.  Crack damage stress as a composite function of porosity and elastic matrix stiffness in dolomites and limestones , 2002 .

[19]  Dragan Grgic,et al.  Estimation of the damage of a porous limestone using continuous wave velocity measurements during uniaxial creep tests , 2012 .

[20]  R. Siddique,et al.  Damage in granite under heating/cooling cycles and water freeze-thaw condition , 2008 .

[22]  Françoise Homand,et al.  Damage-induced permeability changes in granite: a case example at the URL in Canada , 2001 .

[23]  Erik Eberhardt,et al.  Quantifying progressive pre-peak brittle fracture damage in rock during uniaxial compression , 1999 .

[24]  N. D. Cristescu,et al.  Viscoplastic creep of rocks around horizontal tunnels , 1985 .

[25]  Håkan Stille,et al.  The Äspö Pillar Stability Experiment: Part II—Rock mass response to coupled excavation-induced and thermal-induced stresses , 2009 .

[26]  Z. T. Bieniawski,et al.  Mechanism of brittle fracture of rockPart IIexperimental studies , 1967 .

[27]  Liming Wu,et al.  Fracture development in shale and its relationship to gas accumulation , 2012 .

[28]  E. Z. Lajtai,et al.  The evolution of brittle fracture in rocks , 1974, Journal of the Geological Society.

[29]  Yun Lin,et al.  Stress–strain–electrical resistance effects and associated state equations for uniaxial rock compression , 2004 .

[30]  C. Martin,et al.  The strength of massive Lac du Bonnet granite around underground openings , 1993 .

[31]  Jian-Fu Shao,et al.  Influences of chemical degradation on mechanical behaviour of a limestone , 2011 .

[32]  Y. Hatzor,et al.  Microstructure effects on microcracking and brittle failure of dolomites , 1997 .

[33]  C. Scholz,et al.  Dilatancy in the fracture of crystalline rocks , 1966 .

[34]  E. Z. Lajtai,et al.  Modeling the stress–strain diagram for brittle rock loaded in compression , 1998 .

[35]  C. A. Tang,et al.  Time-dependent strength degradation of granite , 2009 .

[36]  G. Bäckblom,et al.  Recent experiments in hard rocks to study the excavation response: Implications for the performance of a nuclear waste geological repository , 1999 .

[37]  Ton Wildenborg,et al.  Underground geological storage , 2005 .

[38]  Jian Zhao,et al.  Micromechanical modelling of the mechanical properties of a granite under dynamic uniaxial compressive loads , 2000 .

[39]  H. Kern,et al.  Development of damage and permeability in deforming rock salt , 2001 .

[40]  N. A. Chandler,et al.  The progressive fracture of Lac du Bonnet granite , 1994 .

[41]  J. Shao,et al.  Evolution of poroelastic properties and permeability in damaged sandstone , 2010 .

[42]  E. Rutter.  Experimental Rock Deformation—the Brittle Field , 1979 .

[43]  T. Reuschlé,et al.  A pore crack model for the mechanical behaviour of porous granular rocks in the brittle deformation regime , 2004 .

[44]  B. Stimpson,et al.  Identifying crack initiation and propagation thresholds in brittle rock , 1998 .

[45]  E. Eberhardt.  Brittle rock fracture and progressive damage in uniaxial compression , 1998 .

[46]  J. Walsh,et al.  The impact of porosity and crack density on the elasticity, strength and friction of cohesive granular materials : insights from DEM modelling , 2009 .

[47]  S. Vinciguerra,et al.  The evolution of elastic moduli with increasing crack damage during cyclic stressing of a basalt from Mt. Etna volcano , 2009 .

[48]  Z. T. Bieniawski.  Mechanism of brittle fracture of rock. Parts 1-3 , 1967 .

[49]  Pathegama Gamage Ranjith,et al.  The effect of CO2 saturation on mechanical properties of Australian black coal using acoustic emission , 2010 .

[50]  Manchao He,et al.  Experimental investigations on gas desorption and transport in stressed coal under isothermal conditions , 2010 .