Study of high-anionic conducting sulfonated microporous membranes for zinc-air electrochemical cells

Abstract High-performance electrochemical membranes have been in great demand due to the rapid market growth in the portable power source devices. The electrochemical characteristics of high-anionic conducting membrane separators were studied in this report using microporous membranes with different sulfonation degrees obtained by changing the sulfonation reaction time. The degree of sulfonation treatment and the effects on the membrane separators were carefully investigated. The room temperature anionic conductivity of the membranes was improved by 132% to 3.52 × 10 −2  S cm −1 when the sulfonation treatment time was 128 h. It was about 1.52 × 10 −2  S cm −1 for the unsulfonated membranes. The anionic transport number in 1 M KOH aqueous solution was also improved to 0.89 from 0.79. The characteristic properties of these membrane separators were studied by infrared spectroscopy (IR), elemental analysis (EA), X-ray diffraction (XRD), scanning electron microscopy (SEM), AC impedance, contact angle measuring system and stress–strain tests. In addition, the solid-state zinc-air cells assembled from the sulfonated membrane separators showed enhanced battery power density of 38 mW cm −2 while the discharge current density was higher at 45 mA cm −2 . The battery power density was around 20 mW cm −2 and the discharge current density was 25 mA cm −2 for the unsulfonated samples. Therefore, the sulfonated microporous membranes could be tailored for the different electrochemical cell applications.

[1]  S. Rajendran,et al.  Electrochemical studies on [(1 − x)PVA–xPMMA] solid polymer blend electrolytes complexed with LiBF4 , 2006 .

[2]  O. Park,et al.  Proton-conducting composite membranes derived from sulfonated hydrocarbon and inorganic materials , 2003 .

[3]  J. Fauvarque,et al.  Characterization and use of anionic membranes for alkaline fuel cells , 2001 .

[4]  Xianfeng Li,et al.  Electrochemical properties of sulfonated PEEK used for ion exchange membranes , 2005 .

[5]  D. Dascalu,et al.  Anisotropic etching of silicon in a complexant redox alkaline system , 1999 .

[6]  H. Mantsch,et al.  FT-IR PAS DEPTH PROFILING INVESTIGATION OF POLYETHYLENE SURFACE SULFONATION , 1996 .

[7]  Hongzheng Chen,et al.  PAN–PEO solid polymer electrolytes with high ionic conductivity , 2005 .

[8]  S. Brückner,et al.  X-ray scattering , 1999 .

[9]  Jean-François Fauvarque,et al.  Electrochemical properties of an alkaline solid polymer electrolyte based on P(ECH-co-EO) , 2000 .

[10]  Hiroshi Tanaka 13C NMR spectra and magnetic relaxation times of isotactic polypropylene treated with fuming nitric acid , 1995 .

[11]  T. Mahalingam,et al.  Conductivity and thermal studies of solid polymer electrolytes prepared by blending polyvinylchloride, polymethylmethacrylate and lithium sulfate , 2004 .

[12]  Wu Gwo-Mei Oxygen plasma treatment of high performance fibers for composites , 2004 .

[13]  Chun–Chen Yang,et al.  Study of ionic transport properties of alkaline poly(vinyl) alcohol-based polymer electrolytes , 2005 .

[14]  A. Vadivel Murugan,et al.  Electrochemically synthesised conducting polymeric materials for applications towards technology in electronics, optoelectronics and energy storage devices , 1999 .

[15]  C. Fonseca,et al.  Sulphuric acid etching of polyethylene surfaces , 1985 .

[16]  J. Karger‐Kocsis Polypropylene : an A-Z reference , 1999 .

[17]  R. D. Falb,et al.  THREE YEARS' EXPERIENCE IN VIVO AND IN VITRO WITH SURFACES AND DEVICES TREATED BY THE HEPARIN COMPLEX METHOD , 1972, Transactions - American Society for Artificial Internal Organs.

[18]  H. Tada,et al.  Conformational change restricted selectivity in the surface sulfonation of polypropylene with sulfuric acid , 1997 .

[19]  Takeshi Kobayashi,et al.  Proton-conducting polymers derived from poly(ether-etherketone) and poly(4-phenoxybenzoyl-1,4-phenylene) , 1998 .

[20]  Chun–Chen Yang,et al.  Alkaline Zn-air and Al-air cells based on novel solid PVA/PAA polymer electrolyte membranes , 2006 .

[21]  Hisaya Sato,et al.  Sulfonation of Poly(propylene) Films with Fuming Sulfuric Acid , 2005 .

[22]  Chun–Chen Yang,et al.  Preparation and characterization of PVA/PAA membranes for solid polymer electrolytes , 2006 .

[23]  F. Picchioni,et al.  Ionomeric membranes based on partially sulfonated poly(styrene): synthesis, proton conduction and methanol permeation , 2000 .

[24]  D. Bergbreiter,et al.  Annealing and reorganization of sulfonated polyethylene films to produce surface-modified films of varying hydrophilicity , 1991 .