Doubly-fed induction generator enabled power generation in ocean wave energy conversion system

This paper proposes a power architecture to utilize doubly-fed induction generator (DFIG) for power generation from oscillating wave energy converter (WEC). Unlike in wind energy conversion system, the stator circuit of the DFIG can not be tied directly with the grid in wave energy conversion system (WECS). In WECS, the speed of the DFIG oscillates from one direction to another. Due to the change of direction of the speed, the stator of the DFIG is proposed to be connected with the grid with switched phase sequence. Also, at low operating speed the DFIG slip speed increases which requires higher voltage rating of the rotor side converter. Therefore, to operate the DFIG with limited rotor side voltage the stator circuit is short circuited at low speed. With these modifications, the DFIG based power architecture is proposed to generate power from WECS. In this paper, the overall hardware and control architecture and system operation are presented. System operation is validated through simulation in MATLAB-Simulink platform. For simulation of the whole system, a WEC model is considered.

[1]  R. Datta,et al.  Variable-Speed Wind Power Generation Using a Doubly Fed Wound Rotor Induction Machine: A Comparison with Alternative Schemes , 2002, IEEE Power Engineering Review.

[2]  P. Bauer,et al.  Wave Energy Converter Concepts : Design Challenges and Classification , 2012, IEEE Industrial Electronics Magazine.

[3]  M. Pietrzak-David,et al.  Doubly Fed Induction Machine speed drive for hydro-electric power station , 2007, 2007 European Conference on Power Electronics and Applications.

[4]  Subhashish Bhattacharya,et al.  Stator flux active damping by optimal rotor current injection for grid tied doubly-fed induction generator , 2015, 2015 IEEE International Electric Machines & Drives Conference (IEMDC).

[5]  Yongdong Li,et al.  A Converter-Based Starting Method and Speed Control of Doubly Fed Induction Machine With Centrifugal Loads , 2011, IEEE Transactions on Industry Applications.

[6]  Werner Leonhard,et al.  Control of Electrical Drives , 1990 .

[7]  Subhashish Bhattacharya,et al.  Control of squirrel cage induction generator in an oscillating point absorber based wave energy conversion system , 2014, 2014 IEEE Applied Power Electronics Conference and Exposition - APEC 2014.

[8]  Jon Clare,et al.  Doubly fed induction generator using back-to-back PWM converters and its application to variable-speed wind-energy generation , 1996 .

[9]  James L. Kirtley,et al.  Bumpless Automatic Transfer for a Switched-Doubly-Fed-Machine Propulsion Drive , 2015, IEEE Transactions on Industry Applications.

[10]  V. T. Ranganathan,et al.  Variable-Speed Wind Power Generation Using a Doubly Fed Wound Rotor Induction Machine: A Comparison with Alternative Schemes , 2002 .

[11]  Subhashish Bhattacharya,et al.  Electrical machines for power generation in oscillating wave energy conversion system — A comparative study , 2015, 2015 IEEE International Electric Machines & Drives Conference (IEMDC).

[12]  Samir Hazra,et al.  Vector approach for self-excitation and control of induction machine in stand-alone wind power generation , 2011 .