SAHPPA: a novel power pinch analysis approach for the design of off-grid hybrid energy systems

This work proposes a novel approach called stand-alone hybrid system power pinch analysis (SAHPPA), which is particularly applicable for the design of off-grid distributed energy generation systems. The enhanced graphical tool employs new ways of utilising the recently introduced demand composite curve and supply composite curve while honouring and adapting fundamental energy systems engineering concepts. The SAHPPA method is capable of optimising the capacity of both the power generators and energy storage for biomass (i.e. non-intermittent) and solar photovoltaic (i.e. intermittent) energy technologies, which is a contribution to the emerging area of power pinch analysis. In addition, the procedure considers all possible efficiency losses in the overall system encompassing the charging–discharging and current inversion processes.

[1]  Mohammad Yusri Hassan,et al.  Process Integration techniques for optimal design of hybrid power systems , 2013 .

[2]  Dominic C.Y. Foo,et al.  Pinch analysis approach to carbon-constrained energy sector planning , 2007 .

[3]  Mohammad Yusri Hassan,et al.  Process integration of hybrid power systems with energy losses considerations , 2013 .

[4]  Dominic C.Y. Foo,et al.  Optimize Shift Scheduling Using Pinch Analysis , 2010 .

[5]  Daniel S. Kirschen,et al.  Centralised and distributed electricity systems , 2008 .

[6]  K. Chatterjee,et al.  Design of isolated renewable hybrid power systems , 2010 .

[7]  Sharifah Rafidah Wan Alwi,et al.  EVALUATION OF PHOTOVOLTAIC SYSTEM INSTALLATION FOR A MOSQUE IN UNIVERSITI TEKNOLOGI MALAYSIA , 2011 .

[8]  J. Klemeš,et al.  Integration of solar thermal energy into processes with heat demand , 2012, Clean Technologies and Environmental Policy.

[9]  Sharifah Rafidah Wan Alwi,et al.  New graphical tools for process changes via load shifting for hybrid power systems based on Power Pinch Analysis , 2013, Clean Technologies and Environmental Policy.

[10]  Dominic C.Y. Foo,et al.  Process Integration for Resource Conservation , 2012 .

[11]  Mimi Haryani Hassim,et al.  Design of distributed energy system through Electric System Cascade Analysis (ESCA) , 2012 .

[12]  T. Mahlia,et al.  A review on energy scenario and sustainable energy in Indonesia , 2011 .

[13]  Jiří Jaromír Klemeš,et al.  A process integration targeting method for hybrid power systems , 2012 .

[14]  Genevieve Saur,et al.  Lifecycle Cost Analysis of Hydrogen Versus Other Technologies for Electrical Energy Storage , 2009 .

[15]  Igor Bulatov,et al.  Sustainability in the Process Industry: Integration and Optimization , 2010 .

[16]  Jiří Jaromír Klemeš,et al.  Process Intensification and Integration: an assessment , 2013, Clean Technologies and Environmental Policy.

[17]  Jiří J. Klemeš,et al.  Handbook of Process Integration (PI) , 2013 .

[18]  R. Billinton,et al.  Reliability/Cost Implications of PV and Wind Energy Utilization in Small Isolated Power Systems , 2001, IEEE Power Engineering Review.

[19]  Ahmed M. A. Haidar,et al.  Optimal configuration assessment of renewable energy in Malaysia , 2011 .

[20]  Santanu Bandyopadhyay,et al.  Design and optimization of isolated energy systems through pinch analysis , 2011 .

[21]  Robin Smith,et al.  Chemical Process: Design and Integration , 2005 .

[22]  Dominic C.Y. Foo,et al.  A generalised guideline for process changes for resource conservation networks , 2013, Clean Technologies and Environmental Policy.

[23]  Bodo Linnhoff,et al.  A User guide on process integration for the efficient use of energy , 1994 .

[24]  Jeng Shiun Lim,et al.  Combined design and load shifting for distributed energy system , 2013, Clean Technologies and Environmental Policy.

[25]  Denny K. S. Ng,et al.  Targeting for Total Water Network. 1. Waste Stream Identification , 2007 .

[26]  Ian C. Kemp,et al.  Pinch Analysis and Process Integration: A User Guide on Process Integration for the Efficient Use of Energy , 2007 .

[27]  Jiří Jaromír Klemeš,et al.  Process Integration (PI): An Introduction , 2013 .

[28]  Robin Smith.  Chemical process design , 1994 .

[29]  ELECTRICITY STORAGE AND RENEWABLES FOR ISLAND POWER , 2015 .

[30]  Ronnie Belmans,et al.  Distributed generation: definition, benefits and issues , 2005 .

[31]  Wei Zhou,et al.  Battery behavior prediction and battery working states analysis of a hybrid solar-wind power generation system , 2008 .

[32]  Raymond R. Tan,et al.  Pinch Analysis Approach to Short-Term Scheduling of Batch Reactors in Multi-Purpose Plants , 2007 .

[33]  T. Mahlia,et al.  A review on energy scenario and sustainable energy in Malaysia , 2010 .

[34]  Haji Hassan Masjuki,et al.  A review on emissions and mitigation strategies for road transport in Malaysia , 2011 .

[35]  John K. Kaldellis,et al.  Optimum sizing of an autonomous wind–diesel hybrid system for various representative wind-potential cases , 2006 .

[36]  Otto Rentz,et al.  19 th International Conference on Production Research PRODUCTION PLANNING BY PINCH ANALYSIS FOR BIOMASS USE IN DYNAMIC AND SEASONAL MARKETS , 2022 .

[37]  Kostas Kalaitzakis,et al.  Methodology for optimal sizing of stand-alone photovoltaic/wind-generator systems using genetic algorithms , 2006 .