Three-dimensional inkjet-printed redox cycling sensor

Multilayer inkjet printing is emerging as a robust platform for fabricating flexible electronic devices over a large area. Here, we report a straightforward, scalable and inexpensive method for printing multilayer three-dimensional nanoporous redox cycling devices with a tunable nanometer gap for electrochemical sensing. The fabrication of the electrochemical redox cycling device is based on vertical stacking of two conductive electrodes made of carbon and gold nanoparticle inks. In this configuration, the two electrodes are parallel to each other and electrically separated by a layer of polystyrene nanospheres. As the top and the bottom electrodes are biased to, respectively, oxidizing and reducing potentials, repetitive cycling of redox molecules between them generates a large current amplification. We show that a vertical interelectrode spacing down to several hundred nanometers with high precision using inkjet printing is possible. The printed sensors demonstrate excellent performance in electrochemical sensing of ferrocene dimethanol as a redox-active probe. A collection efficiency of 100% and current amplification up to 30-fold could be obtained. Our method provides a low cost and versatile means for sensitive electrochemical measurements eliminating the need for sophisticated fabrication methods, which could prove useful for sensitive point-of-care diagnostics devices.

[1]  Tsutomu Horiuchi,et al.  Enhancement of Redox Cycling Currents at Interdigitated Electrodes with Elevated Fingers , 2014 .

[2]  Charles N. Reilley,et al.  Thin-layer electrochemistry: steady-state methods of studying rate processes , 1965 .

[3]  Anthony P. F. Turner,et al.  Electrocatalytic Currents from Single Enzyme Molecules. , 2016, Journal of the American Chemical Society.

[4]  J. E. Dick,et al.  Observation of Single-Protein and DNA Macromolecule Collisions on Ultramicroelectrodes. , 2015, Journal of the American Chemical Society.

[5]  A. Bard,et al.  Scanning electrochemical microscopy. Introduction and principles , 1989 .

[6]  B. Wolfrum,et al.  On-chip redox cycling techniques for electrochemical detection , 2012 .

[7]  A. van den Berg,et al.  Redox cycling with facing interdigitated array electrodes as a method for selective detection of redox species. , 2007, The Analyst.

[8]  Pradyumna S. Singh,et al.  Single-molecule electrochemistry: present status and outlook. , 2013, Accounts of chemical research.

[9]  Wei Xu,et al.  Ion Accumulation and Migration Effects on Redox Cycling in Nanopore Electrode Arrays at Low Ionic Strength. , 2016, ACS nano.

[10]  Bernhard Wolfrum,et al.  Nanofluidic redox cycling amplification for the selective detection of catechol. , 2008, Analytical chemistry.

[11]  Sebastian J. Lechner,et al.  Nano-porous electrode systems by colloidal lithography for sensitive electrochemical detection: fabrication technology and properties , 2008 .

[12]  D. Woodward,et al.  Redox cycling measurements of a model compound and dopamine in ultrasmall volumes with a self-contained microcavity device , 2003 .

[13]  Yi Cui,et al.  Printed energy storage devices by integration of electrodes and separators into single sheets of paper , 2010 .

[14]  Andreas Offenhäusser,et al.  Redox cycling in nanoporous electrochemical devices. , 2014, Nanoscale.

[15]  G. Jabbour,et al.  Inkjet Printing—Process and Its Applications , 2010, Advanced materials.

[16]  M. Madou,et al.  Selective Detection of Dopamine against Ascorbic Acid Interference Using 3D Carbon Interdigitated Electrode Arrays , 2014 .

[17]  Pradyumna S. Singh,et al.  Fast electron-transfer kinetics probed in nanofluidic channels. , 2009, Journal of the American Chemical Society.

[18]  N. M. Contento,et al.  Redox cycling in nanoscale-recessed ring-disk electrode arrays for enhanced electrochemical sensitivity. , 2013, ACS nano.

[19]  A. Baldi,et al.  Gold interdigitated nanoelectrodes as a sensitive analytical tool for selective detection of electroactive species via redox cycling , 2016, Microchimica Acta.

[20]  Norbert Fabre,et al.  Elaboration of a microstructured inkjet-printed carbon electrochemical capacitor , 2010 .

[21]  M. Schwab,et al.  Inkjet-printed energy storage device using graphene/polyaniline inks , 2014 .

[22]  W. Heineman,et al.  Small-volume voltammetric detection of 4-aminophenol with interdigitated array electrodes and its application to electrochemical enzyme immunoassay. , 1993, Analytical chemistry.

[23]  Juhyoun Kwak,et al.  Bench-top fabrication and electrochemical applications of a micro-gap electrode using a microbead spacer , 2016 .

[24]  Paul W. Bohn,et al.  Redox Cycling in Nanopore-Confined Recessed Dual-Ring Electrode Arrays , 2016 .

[25]  P. Bohn,et al.  Nanopore-enabled electrode arrays and ensembles , 2016, Microchimica Acta.

[26]  M. Tentzeris,et al.  Multi-Layer RF Capacitors on Flexible Substrates Utilizing Inkjet Printed Dielectric Polymers , 2013, IEEE Microwave and Wireless Components Letters.

[27]  M. Stelzle,et al.  Characterization of Nanopore Electrode Structures as Basis for Amplified Electrochemical Assays , 2006 .

[28]  Pedro Estrela,et al.  Cysteine-cystine redox cycling in a gold-gold dual-plate generator-collector microtrench sensor. , 2014, Analytical chemistry.

[29]  Hitoshi Shiku,et al.  A local redox cycling-based electrochemical chip device with nanocavities for multi-electrochemical evaluation of embryoid bodies. , 2015, Lab on a chip.

[30]  Edgar D Goluch,et al.  Stochastic sensing of single molecules in a nanofluidic electrochemical device. , 2011, Nano letters.

[31]  Pradyumna S. Singh,et al.  Stochasticity in single-molecule nanoelectrochemistry: origins, consequences, and solutions. , 2012, ACS nano.

[32]  J. Ye,et al.  Fabrication and electrochemical characterization of interdigitated nanoelectrode arrays , 2005 .

[33]  P. Licence,et al.  Ultramicroelectrode voltammetry and scanning electrochemical microscopy in room-temperature ionic liquid electrolytes. , 2010, Chemical Society reviews.

[34]  L. Anderson,et al.  Filar electrodes: steady-state currents and spectroelectrochemistry at twin interdigitated electrodes , 1985 .

[35]  Ronald Österbacka,et al.  Application of Paper-Supported Printed Gold Electrodes for Impedimetric Immunosensor Development , 2012, Biosensors.

[36]  C. P. Winlove,et al.  Boron-Doped Diamond Dual-Plate Deep-Microtrench Device for Generator-Collector Sulfide Sensing , 2015 .

[37]  R. Engstrom,et al.  Measurements within the diffusion layer using a microelectrode probe , 1986 .

[38]  Marc D. Porter,et al.  Alkanethiolate Gold Cluster Molecules with Core Diameters from 1.5 to 5.2 nm: Core and Monolayer Properties as a Function of Core Size , 1998 .

[39]  Allen J. Bard,et al.  Digital Simulation of the Measured Electrochemical Response of Reversible Redox Couples at Microelectrode Arrays: Consequences Arising from Closely Spaced Ultramicroelectrodes , 1986 .

[40]  Boris Hofmann,et al.  Nanocavity redox cycling sensors for the detection of dopamine fluctuations in microfluidic gradients. , 2010, Analytical chemistry.

[41]  C. Grigoropoulos,et al.  All-inkjet-printed flexible electronics fabrication on a polymer substrate by low-temperature high-resolution selective laser sintering of metal nanoparticles , 2007 .