As the use of biodiesel becomes more wide-spread, engine manufacturers have expressed concern about biodiesel’s higher viscosity. In particular, they are concerned that biodiesel may exhibit different viscosity-temperature characteristics that could result in higher fuel injection pressures at low engine operating temperatures. This study presents data for the kinematic viscosity of biodiesel and its blends with No. 1 and No. 2 diesel fuels at 75, 50, and 20% biodiesel, from close to their melting point to 100°C. The results indicate that while their viscosity is higher, biodiesel and its blends demonstrate temperature-dependent behavior similar to that of No. 1 and No. 2 diesel fuels. Equations of the same general form are shown to correlate viscosity data for both biodiesel and diesel fuel, and for their blends. A blending equation is presented that allows the kinematic viscosity to be calculated as a function of the biodiesel fraction.
[1]
Robert L. McCormick,et al.
Combustion of fat and vegetable oil derived fuels in diesel engines
,
1998
.
[2]
Yu Zhang.
Emissions and combustion of fatty acid esters of soybean oil in a diesel engine
,
1994
.
[3]
A. Drews,et al.
Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (the Calculation of Dynamic Viscosity)
,
1998
.
[4]
A. J. Meirelles,et al.
Viscosities of fatty acids, triglycerides, and their binary mixtures
,
1997
.
[5]
C. L. Peterson,et al.
Vegetable oil substitutes for diesel fuel.
,
1983
.
[6]
A. H. Nissan,et al.
Mixture Law for Viscosity
,
1949,
Nature.
[7]
L. Clements,et al.
Viscosities of vegetable oils and fatty acids
,
1992
.
[8]
C. J. A. Roelands,et al.
Physical properties of fatty acid methyl esters. VI. Viscosity
,
1966
.