Corrosion and synergy in a WCCoCr HVOF thermal spray coating—understanding their role in erosion–corrosion degradation

Abstract The material degradation of a high velocity oxy-fuel (HVOF) WC Co Cr thermal spray coating is addressed in this paper focusing on the effect of corrosion and the degradation caused by the interaction between corrosion and erosion (synergy) on the overall material loss in erosion–corrosion environments. The mechanical and electrochemical components, which contribute to degradation are isolated and evaluated using an experimental protocol comprising electrochemical techniques and scanning electron microscopy (SEM). Tests under erosion–corrosion conditions were performed in 3.5% NaCl solution with silica sand concentrations of 200, 500 and 1000 mg/l, at two temperatures (20 and 50 °C) and using an impingement velocity of 17 m/s. Austenitic (UNS S31603) and super duplex (UNS S32760) stainless steels were used as a reference and the performance of these three materials is presented. The results show that corrosion and corrosion–erosion interactions play an important role in the overall material degradation of the HVOF coating and that the dominance of each process is critically dependent on the environment. Some discussion of potential means of improving the coating durability is presented through consideration of the dominant processes in erosion–corrosion.

[1]  A. Neville,et al.  Linking electrochemical corrosion behaviour and corrosion mechanisms of thermal spray cermet coatings (WC–CrNi and WC/CrC–CoCr) , 2003 .

[2]  H. Scholl,et al.  Anodic polarization of cemented carbides of the type [(WC,M): M = Fe, Ni or Co] in sulphuric acid solution , 1992 .

[3]  V. Souza.  Corrosion and erosion-corrosion of wc-based cermet coatings - a kinetic and mechanistic study , 2004 .

[4]  M. Stern,et al.  Electrochemical Polarization I . A Theoretical Analysis of the Shape of Polarization Curves , 1957 .

[5]  A. Neville,et al.  Assessment of the corrosion rates and mechanisms of a WC–Co–Cr HVOF coating in static and liquid–solid impingement saline environments , 2001 .

[6]  H. Fischmeister,et al.  ESCA studies of the composition profile of low temperature oxide formed on chromium steels—II. Corrosion in oxygenated water , 1975 .

[7]  A. Neville,et al.  Study of passive film on stainless steels and high grade nickel base alloy using X-ray photoelectron spectroscopy , 2000 .

[8]  M. Ghandehari.  Anodic Behavior of Cemented WC‐6% Co Alloy in Phosphoric Acid Solutions , 1980 .

[9]  G. T. Burstein,et al.  Effect of impact angle on the slurry erosion–corrosion of 304L stainless steel , 2000 .

[10]  Anne Neville,et al.  Corrosion and erosion damage mechanisms during erosion–corrosion of WC–Co–Cr cermet coatings , 2003 .

[11]  I. Olefjord,et al.  Surface Composition of Stainless Steels during Anodic Dissolution and Passivation Studied by ESCA , 1985 .

[12]  W. J. Tomlinson,et al.  Anodic polarization and corrosion of cemented carbides with cobalt and nickel binders , 1988 .

[13]  P. Shipway,et al.  Sliding wear behaviour of HVOF sprayed WC-Co coatings deposited with both gas-fuelled and liquid-fuelled systems , 2003 .

[14]  G. T. Burstein,et al.  Growth of passivating films on scratched 304L stainless steel in alkaline solution , 1983 .

[15]  P. H. Shipway,et al.  Abrasive wear behaviour of conventional and nanocomposite HVOF-sprayed WC–Co coatings , 1999 .

[16]  J. D. Voorhies.  Electrochemical and Chemical Corrosion of Tungsten Carbide (WC) , 1972 .

[17]  FanAiming,et al.  An investigation of the corrosive wear of stainless steels in aqueous slurries , 1996 .

[18]  Rongguang Wang,et al.  Corrosion Behavior of Thermally Sprayed WC Coating in Na2SO4 Aqueous Solution , 2002 .

[19]  S. P. Hutton,et al.  The synergistic effect of erosion and corrosion: trends in published results , 1990 .

[20]  B. W. Madsen.  Measurement of erosion-corrosion synergism with a slurry wear test apparatus , 1988 .

[21]  A. Fanigliulo,et al.  Electrochemical oxidation of WC in acidic sulphate solution , 2004 .

[22]  L. Bergström,et al.  Oxidation and dissolution of tungsten carbide powder in water , 2000 .