Noise Reduction Studies from the Leading Edge of Serrated Flat Plates

This paper provides an experimental investigation into the use of leading edge serrations as a means of reducing the broadband noise generated due to the interaction between the aerofoil’s leading edge (LE) and impinging turbulence. Experiments are performed on a flat plate in an open jet wind tunnel. Grids are used to generate isotropic homogeneous turbulence. The leading edge serrations are in the form of sinusoidal profiles of wavelengths, λ, and amplitudes, 2h. The frequency and amplitude characteristics are studied in detail in order to understand the effect of LE serrations on noise reduction characteristics and are compared with straight edge baseline flat plates. Noise reductions are found to be insignificant at low frequencies but significant in the mid frequency range for all the cases studied. The flat plate results are also compared to the noise reductions obtained on a serrated NACA-65 aerofoil with the same serration profile. Noise reductions are found to be significantly higher for the flat plates with a maximum noise reduction of around 8 dB compared with about 5 dB for the aerofoil. In general, it is observed that the sound power reduction level (∆PWL) is sensitive to the amplitude, 2h of the LE serrations but much less sensitive to the serration wavelength, λ. Thus, this paper sufficiently demonstrates that the LE amplitude act as a key parameter for enhancing the noise reduction levels in flat plates and aerofoils.