Intermediate temperature heat release in an HCCI engine fueled by ethanol/n-heptane mixtures: An experimental and modeling study

This study examines intermediate temperature heat release (ITHR) in homogeneous charge compression ignition (HCCI) engines using blends of ethanol and n-heptane. Experiments were performed over the range of 0–50% n-heptane liquid volume fractions, at equivalence ratios 0.4 and 0.5, and intake pressures from 1.4 bar to 2.2 bar. ITHR was induced in the mixtures containing predominantly ethanol through the addition of small amounts of n-heptane. After a critical threshold, additional n-heptane content yielded low temperature heat release (LTHR). A method for quantifying the amount of heat released during ITHR was developed by examining the second derivative of heat release, and this method was then used to identify trends in the engine data. The combustion process inside the engine was modeled using a single-zone HCCI model, and good qualitative agreement of pre-ignition pressure rise and heat release rate was found between experimental and modeling results using a detailed n-heptane/ethanol chemical kinetic model. The simulation results were used to identify the dominant reaction pathways contributing to ITHR, as well as to verify the chemical basis behind the quantification of the amount of ITHR in the experimental analysis. The dominant reaction pathways contributing to ITHR were found to be H-atom abstraction from n-heptane by OH and the addition of fuel radicals to O2.

[1]  A. Yates,et al.  Insights relating to the autoignition characteristics of alcohol fuels , 2010 .

[2]  John B. Heywood,et al.  Two-stage ignition in HCCI combustion and HCCI control by fuels and additives , 2003 .

[3]  I. I. Vibe.  Brennverlauf und Kreisprozeß von Verbrennungsmotoren , 1970 .

[4]  Robert W. Dibble,et al.  Prediction of carbon monoxide and hydrocarbon emissions in iso-octane HCCI engine combustion using multizone simulations , 2002 .

[5]  G. Woschni.  A Universally Applicable Equation for the Instantaneous Heat Transfer Coefficient in the Internal Combustion Engine , 1967 .

[6]  Peerawat Saisirirat,et al.  Spectroscopic Measurements of Low-Temperature Heat Release for Homogeneous Combustion Compression Ignition (HCCI) n-Heptane/Alcohol Mixture Combustion , 2010 .

[7]  Marcos Chaos,et al.  Low and intermediate temperature oxidation of ethanol and ethanol–PRF blends: An experimental and modeling study , 2009 .

[8]  C. Togbé,et al.  Auto-ignition and combustion characteristics in HCCI and JSR using 1-butanol/n-heptane and ethanol/n-heptane blends , 2011 .

[9]  H. Curran,et al.  The Unimolecular Decomposition and H Abstraction Reactions by HO and HO2 from n‐Butanol , 2009 .

[10]  John E. Dec,et al.  Ethanol Autoignition Characteristics and HCCI Performance for Wide Ranges of Engine Speed, Load and Boost , 2010 .

[11]  Samveg Saxena,et al.  Maximizing Power Output in an Automotive Scale Multi-Cylinder Homogeneous Charge Compression Ignition (HCCI) Engine , 2011 .

[12]  Norimasa Iida,et al.  Combustion Analysis of Natural Gas in a Four Stroke HCCI Engine Using Experiment and Elementary Reactions Calculation , 2003 .

[13]  Robert W. Dibble,et al.  A Multi-Zone Model for Prediction of HCCI Combustion and Emissions , 2000 .

[14]  John E. Dec,et al.  Boosted HCCI - Controlling Pressure-Rise Rates for Performance Improvements using Partial Fuel Stratification with Conventional Gasoline , 2011 .

[15]  Hatim Machrafi,et al.  An experimental and numerical investigation on the influence of external gas recirculation on the HCCI autoignition process in an engine: Thermal, diluting, and chemical effects , 2008 .

[16]  Dennis N. Assanis,et al.  Comparing Enhanced Natural Thermal Stratification Against Retarded Combustion Phasing for Smoothing of HCCI Heat-Release Rates , 2004 .

[17]  Yu Zhang,et al.  Autoignition of binary fuel blends of n-heptane and C7 esters in a motored engine , 2012 .

[18]  R. Head,et al.  HCCI experiments with gasoline surrogate fuels modeled by a semidetailed chemical kinetic model , 2009 .

[19]  Daniel Dahl,et al.  HCCI/SCCI Load Limits and Stoichiometric Operation in a Multicylinder Naturally Aspirated Spark Ignition Engine Operated on Gasoline and E85 , 2011 .

[20]  William Cannella,et al.  Boosted HCCI Combustion Using Low-Octane Gasoline with Fully Premixed and Partially Stratified Charges , 2012 .

[21]  Zhen Huang,et al.  Experimental study and chemical analysis of n-heptane homogeneous charge compression ignition combustion with port injection of reaction inhibitors , 2007 .

[22]  John E. Dec,et al.  Spectroscopic and chemical-kinetic analysis of the phases of HCCI autoignition and combustion for single- and two-stage ignition fuels , 2008 .

[23]  N. Marinov,et al.  A detailed chemical kinetic model for high temperature ethanol oxidation , 1999 .

[24]  André L. Boehman,et al.  Oxidation of 1-butanol and a mixture of n-heptane/1-butanol in a motored engine , 2010 .

[25]  Robert W. Dibble,et al.  Investigation of HCCI combustion of diethyl ether and ethanol mixtures using carbon 14 tracing and numerical simulations , 2005 .

[26]  A. Savitzky,et al.  Smoothing and Differentiation of Data by Simplified Least Squares Procedures. , 1964 .

[27]  C. Togbé,et al.  Experimental and modeling study of the kinetics of oxidation of ethanol-n-heptane mixtures in a jet-stirred reactor , 2010 .

[28]  H. Curran,et al.  A Shock Tube Study of n- and iso-Propanol Ignition , 2009 .

[29]  C. Westbrook,et al.  A Comprehensive Modeling Study of n-Heptane Oxidation , 1998 .

[30]  Blake A. Simmons,et al.  Characteristics of Isopentanol as a Fuel for HCCI Engines , 2010 .

[31]  John E. Dec,et al.  Boosted HCCI for high power without engine knock and with ultra-low NOx emissions - Using conventional gasoline , 2010 .

[32]  Bengt Johansson,et al.  A Turbocharged Dual-Fuel HCCI Engine , 2001 .

[33]  Samveg Saxena,et al.  Fundamental phenomena affecting low temperature combustion and HCCI engines, high load limits and strategies for extending these limits , 2013 .

[34]  John E. Dec,et al.  Advanced compression-ignition engines—understanding the in-cylinder processes , 2009 .

[35]  John E. Dec,et al.  Comparing late-cycle autoignition stability for single- and two-stage ignition fuels in HCCI engines , 2007 .

[36]  C. Westbrook,et al.  Kinetic modeling of gasoline surrogate components and mixtures under engine conditions , 2011 .

[37]  A. Konnov,et al.  Laminar burning velocities of n-heptane, iso-octane, ethanol and their binary and tertiary mixtures , 2011 .

[38]  Mani Sarathy,et al.  Detailed Kinetic Modeling of Conventional Gasoline at Highly Boosted Conditions and the Associated Intermediate Temperature Heat Release , 2012 .

[39]  Yu Zhang,et al.  Premixed ignition behavior of C9 fatty acid esters: A motored engine study , 2009 .

[40]  Robert W. Dibble,et al.  Sensitivity of Natural Gas HCCI Combustion to Fuel and Operating Parameters Using Detailed Kinetic Modeling , 1999, Advanced Energy Systems.

[41]  William J. Pitz,et al.  Detailed Kinetic Modeling of Low-Temperature Heat Release for PRF Fuels in an HCCI Engine , 2009 .

[42]  John E. Dec,et al.  Improving Efficiency and Using E10 for Higher Loads in Boosted HCCI Engines , 2012 .

[43]  J. Eng,et al.  Characterization of Pressure Waves in HCCI Combustion , 2002 .

[44]  Zhen Huang,et al.  Experimental study on the auto-ignition and combustion characteristics in the homogeneous charge compression ignition (HCCI) combustion operation with ethanol/n-heptane blend fuels by port injection , 2006 .

[45]  Kohei Kuzuoka,et al.  Study on HCCI-SI Combustion Using Fuels Ethanol Containing , 2007 .