A 2-Kb One-Time Programmable Memory for UHF Passive RFID Tag IC in a Standard 0.18 $\mu$m CMOS Process

We present a 2-Kb one-time programmable (OTP) memory for UHF RFID applications. The OTP memory cell is based on a two-transistor (2-T) gate-oxide anti-fuse (AF) for low voltage operation. Reliability of memory cell is enhanced by limiting the maximum terminal voltages of thin-oxide and thick-oxide transistors to 1.8 V and 3.3 V, respectively. Improved low power circuit design techniques are used including auto shut-off for program mode and self-timed control for read mode. To further reduce power consumption, we develop a novel power-efficient charge pump. The designed OTP is successfully embedded into a UHF passive RFID tag IC that conforms to the EPCglobal Gen-2 standard. The tag chip was fabricated in a 0.18 m 1-poly 6-metal standard CMOS process with no additional masks. The total area of the chip including the I/Os and bonding pads is 2.3 × 1.5 mm2 where the OTP memory area is only 0.43 × 0.31 mm2. Our tag IC measurement shows that the read and write currents of the OTP memory are 17 μA and 58 μA, respectively.

[1]  W. Weber,et al.  Charge sharing concept and new clocking scheme for power efficiency and electromagnetic emission improvement of boosted charge pumps , 2000, IEEE Journal of Solid-State Circuits.

[2]  Haruo Kobayashi,et al.  Highly-Efficient Low-Voltage-Operation Charge Pump Circuits Using Bootstrapped Gate Transfer Switches , 2000 .

[3]  J. F. Dickson,et al.  On-chip high-voltage generation in MNOS integrated circuits using an improved voltage multiplier technique , 1976 .

[4]  Shoichi Masui,et al.  A 13.56 MHz CMOS RF Identification Passive Tag LSI with Ferroelectric Random Access Memory , 2005, IEICE Trans. Electron..

[5]  Zhang Fan,et al.  NEW DESIGN OF EEPROM MEMORY FOR RFID TAG IC Embedded EEPROM Memory Achieving Lower Power , 2006 .

[6]  S.F. Lam,et al.  Power reflection coefficient analysis for complex impedances in RFID tag design , 2005, IEEE Transactions on Microwave Theory and Techniques.

[7]  Jin Liu,et al.  An EEPROM Programming Controller for Passive UHF RFID Transponders with Gated Clock Regulation Loop and Current Surge Control , 2007, 2007 IEEE Custom Integrated Circuits Conference.

[8]  Deng Min,et al.  Embeded EEPROM Memory Achieving Lower Power - New design of EEPROM memory for RFID tag IC , 2006, IEEE Circuits and Devices Magazine.

[9]  Rainer Waser,et al.  Lifetime estimation due to imprint failure in ferroelectric SrBi2Ta2O9 thin films , 2000 .

[10]  Duong Huynh Thai Vo,et al.  A Fully Integrated HF-Band Passive RFID Tag IC Using 0.18- $\mu\hbox{m}$ CMOS Technology for Low-Cost Security Applications , 2011, IEEE Transactions on Industrial Electronics.

[11]  Gyu-Ho Lim,et al.  Low-Power 512-Bit EEPROM Designed for UHF RFID Tag Chip , 2008 .

[12]  Seung H. Kang,et al.  Development of Embedded STT-MRAM for Mobile System-on-Chips , 2011, IEEE Transactions on Magnetics.

[13]  Y. J. Park,et al.  A new charge pump without degradation in threshold voltage due to body effect [memory applications] , 2000, IEEE Journal of Solid-State Circuits.

[14]  Kwyro Lee,et al.  A 32-KB Standard CMOS Antifuse One-Time Programmable ROM Embedded in a 16-bit Microcontroller , 2006, IEEE Journal of Solid-State Circuits.

[15]  Bo Gao,et al.  A System-on-Chip EPC Gen-2 Passive UHF RFID Tag With Embedded Temperature Sensor , 2010, IEEE Journal of Solid-State Circuits.

[16]  Bomson Lee,et al.  A Long-Range UHF-Band Passive RFID Tag IC Based on High- $Q$ Design Approach , 2009, IEEE Transactions on Industrial Electronics.

[17]  Ming-Dou Ker,et al.  Design of charge pump circuit with consideration of gate-oxide reliability in low-voltage CMOS processes , 2006, IEEE J. Solid State Circuits.

[18]  Sang-Hoon Hong,et al.  A fully integrated high security NFC target IC using 0.18 μm CMOS process , 2011, 2011 Proceedings of the ESSCIRC (ESSCIRC).