Effect of 1/f noise in integrating sensors and detectors

The authors calculate the variance in the output of an integrating sensor or detector when in the presence of 1/fα noise in the input of the sensor. The calculations are based on mapping the detector onto a linear, time-invariant filter; the approach is general and can be used for any detector that can be so mapped. Formulae for the output variance and signal-to-noise ratio are given for a simple integrating detector and a detector with three different methods of background subtraction, including double sampling, that has two integrations, and triple sampling where the average of two integrations before and after the signal is subtracted from the integration during the signal. The authors consider cases in which α is unity, less than unity and more than unity, given that quite often α is not ideally unity. Also, for the case of an integrating detector that is used to sample a signal, a formula is derived for the expected variance of N samples when the input contains 1/f noise. The authors apply the treatise herein to the input stage of an a-Se based flat panel X-ray image detector and demonstrate that the 1/f noise fluctuations in the dark current of the photoconductor exceeds those because of shot noise.

[1]  Patrick Pittet,et al.  Noise Modeling For Charge Amplification and Sampling , 2006, 2006 13th IEEE International Conference on Electronics, Circuits and Systems.

[2]  A. Nathan,et al.  Reset and partition noise in active pixel image sensors , 2005, IEEE Transactions on Electron Devices.

[3]  H. Wey,et al.  An improved correlated double sampling circuit for low noise charge coupled devices , 1990 .

[4]  A. Erdélyi,et al.  Higher Transcendental Functions , 1954 .

[5]  David H. Lumb,et al.  Noise reduction techniques for CCD image sensors , 1982 .

[6]  Arokia Nathan,et al.  Amorphous silicon active pixel sensor readout circuit for digital imaging , 2003 .

[7]  M. Buckingham.  Noise in electronic devices and systems , 1983 .

[8]  Studies on excess noise in stabilized amorphous selenium used in X-ray photodetectors , 2008 .

[9]  Zahid Yaqoob,et al.  A generalized noise variance analysis model and its application to the characterization of 1/f noise. , 2007, Optics express.

[10]  Arokia Nathan,et al.  Amorphous silicon technology for large area digital X-ray and optical imaging , 2002, Microelectron. Reliab..

[11]  A. Prudnikov,et al.  Integrals and series of special functions , 1983 .

[12]  R. Hornsey,et al.  Transduction principles of a-Si:H Schottky diode X-ray image sensors , 2000 .

[13]  Safa Kasap,et al.  Amorphous selenium and its alloys from early xeroradiography to high resolution X‐ray image detectors and ultrasensitive imaging tubes , 2009 .

[14]  M. S. Keshner.  1/f noise , 1982, Proceedings of the IEEE.

[15]  J A Rowlands,et al.  Digital radiology using active matrix readout of amorphous selenium: theoretical analysis of detective quantum efficiency. , 1997, Medical physics.

[16]  M. A. Caloyannides,et al.  Microcycle spectral estimates of 1/f noise in semiconductors , 1974 .

[17]  Changhuei Yang,et al.  Fundamental sensitivity limit imposed by dark 1/f noise in the low optical signal detection regime. , 2008, Optics express.

[19]  J A Rowlands,et al.  X-ray imaging using amorphous selenium: feasibility of a flat panel self-scanned detector for digital radiology. , 1995, Medical physics.

[20]  Gabor C. Temes,et al.  Circuit techniques for reducing the effects of op-amp imperfections: autozeroing, correlated double sampling, and chopper stabilization , 1996, Proc. IEEE.

[21]  S. Kasap,et al.  1/f noise in hydrogenated amorphous silicon–germanium alloys , 2003 .

[22]  J. C. Eilbeck.  Table errata: Higher transcendental functions. Vol. I, II (McGraw-Hill, New York, 1953) by A. Erdélyi, W. Magnus, F. Oberhettinger and F. G. Tricomi , 1971 .

[23]  Sh. Kogan,et al.  Electronic noise and fluctuations in solids , 1996 .

[24]  Pierre Magnan,et al.  Analysis and reduction of signal readout circuitry temporal noise in CMOS image sensors for low-light levels , 2000 .

[25]  Karim S. Karim,et al.  Noise optimisation analysis of an active pixel sensor for low-noise real-time X-ray fluoroscopy , 2007, IET Circuits Devices Syst..

[26]  R. J. Kansy,et al.  Response of a correlated double sampling circuit to 1/f noise , 1980 .