EMI Filter Design Based on High-Frequency Modeling of Common-mode Chokes

Aiming at the bad performance of EMI filter in the high frequency band, the non-ideal factors of common-mode chokes and the limitations of the existing high-frequency model are summarized. Considering the frequency characteristics of core material and the influence of parasitic capacitance, an improved cascaded Foster network model is established, and then the common-mode and differential-mode high-frequency equivalent circuits of EMI filter in lS0kHz-30MHz are developed. Furthermore, an EMI filter design method based on the optimization of the impedance characteristics of common- mode chokes is proposed. An experiment is carried out to verify the method by an 1.2SkW Boost PFC prototype. Results indicate that the device with the proposed EMI filter can pass the conducted EMI test successfully, and the design scheme can provide effective guidance for the remediation of conducted electromagnetic interference.

[1]  D. Boroyevich,et al.  EMI filter design considering in-circuit impedance mismatching , 2012, 2012 IEEE Energy Conversion Congress and Exposition (ECCE).

[2]  Wei Chen,et al.  Modeling and measurement of the impedance of common mode noise source of switching converters , 2006, Twenty-First Annual IEEE Applied Power Electronics Conference and Exposition, 2006. APEC '06..

[3]  Qian Zhao-ming.  High frequency modeling of common mode chokes for electromagnetic interference analysis , 2007 .

[4]  W. Eberle,et al.  A novel EMI filter design method for switching power supplies , 2004, IEEE Transactions on Power Electronics.

[5]  R. West.  Common mode inductor material selection , 1995, Proceedings:Electrical Electronics Insulation Conference and Electrical Manufacturing & Coil Winding Conference.

[6]  W. Khan-ngern,et al.  The effect of impedance mismatch on the conducted EMI emission , 2003, Asia-Pacific Conference on Environmental Electromagnetics, 2003. CEEM 2003. Proceedings..

[7]  Dehong Liu,et al.  High frequency characteristic analysis of EMI filter in switch mode power supply (SMPS) , 2002, 2002 IEEE 33rd Annual IEEE Power Electronics Specialists Conference. Proceedings (Cat. No.02CH37289).

[8]  Yie-Tone Chen,et al.  A procedure for designing EMI filters for AC line applications , 1996 .

[9]  Huang Shi-you,et al.  A Method to Extract the Lumped Parameters of Common Mode Choke for EMI Filters , 2009 .

[10]  C. Sullivan,et al.  Magnetic material selection for EMI filters , 2017, 2017 IEEE Energy Conversion Congress and Exposition (ECCE).

[11]  C. Paul.  Introduction to electromagnetic compatibility , 2005 .