Multi-objective optimization of the dry electric discharge machining process

Dry Electric Discharge Machining (EDM) is an environment-friendly modification of the conventional EDM process, which is obtained by replacing the liquid dielectric by a gaseous medium. In this study, multi-objective optimization of dry EDM process has been done using the non dominated sorting genetic algorithm (NSGA II), with material removal rate (MRR) and surface roughness (Ra) as the objective functions. Experiments were conducted with air as dielectric to develop polynomial models of MRR and Ra in terms of the six input parameters: gap voltage, discharge current, pulse-on time, duty factor, air pressure and spindle speed. A Pareto-optimal front was then obtained using NSGA II. Analysis of the front was done to identify separate regions for finish and rough machining. Designed experiments were then conducted in these focused regions to verify the optimization results and to identify the region-specific characteristics of the process. Finishing conditions were obtained at low current, high pulse-on time and low duty factor, where as rough conditions were obtained at high current, low pulse-on time and high duty factor. Focused experiments revealed an additional process constraint based on the flushing efficiency.

[1]  M. Kunieda,et al.  Improvement of EDM Efficiency by Supplying Oxygen Gas into Gap , 1991 .

[2]  Kalyanmoy Deb,et al.  Simulated Binary Crossover for Continuous Search Space , 1995, Complex Syst..

[3]  Masanori Kunieda,et al.  Electrical Discharge Machining in Gas , 1997 .

[4]  K. Deb.  An Efficient Constraint Handling Method for Genetic Algorithms , 2000 .

[5]  Kalyanmoy Deb,et al.  A fast and elitist multiobjective genetic algorithm: NSGA-II , 2002, IEEE Trans. Evol. Comput..

[6]  Nobuhiro Nakajima,et al.  High Speed 3D Milling by Dry EDM , 2003 .

[7]  I. Pashby,et al.  A review on the use of environmentally-friendly dielectric fluids in electrical discharge machining , 2004 .

[8]  Zhanbo Yu,et al.  Dry electrical discharge machining of cemented carbide , 2004 .

[9]  Masanori Kunieda,et al.  Improvement of Dry EDM Characteristics Using Piezoelectric Actuator , 2004 .

[10]  Masanori Kunieda,et al.  Feasibility of 3-D Surface Machining by Dry EDM , 2005 .

[11]  M. S. Shunmugam,et al.  Multi-objective optimization of wire-electro discharge machining process by Non-Dominated Sorting Genetic Algorithm , 2005 .

[12]  Ruxu Du,et al.  An investigation of ultrasonic-assisted electrical discharge machining in gas , 2006 .

[13]  Surjya K. Pal,et al.  Modeling of electrical discharge machining process using back propagation neural network and multi-objective optimization using non-dominating sorting genetic algorithm-II , 2007 .

[14]  K. Palanikumar,et al.  Optimization of electrical discharge machining characteristics of WC/Co composites using non-dominated sorting genetic algorithm (NSGA-II) , 2008 .

[15]  Jun Ni,et al.  Experimental Study of the Dry and Near-Dry Electrical Discharge Milling Processes , 2008 .

[16]  Sourabh K. Saha,et al.  Experimental investigation and empirical modeling of the dry electric discharge machining process , 2009 .