The Role of Water in the Reversible Optoelectronic Degradation of Hybrid Perovskites at Low Pressure

There is no doubt about the potential offered by the low-cost fabrication and high efficiency of  hybrid organic–inorganic perovskite solar cells. However, the service lifetimes of these devices must be increased from months to years to capitalize on their potential. The archetypal hybrid perovskite for solar cells, methylammonium lead iodide (CH3NH3PbI3, abbreviated MAPI), readily degrades in ambient atmosphere under standard operating conditions. Understanding the origin and effects of this degradation can pave the way to better engineer photovoltaic devices and the perovskite material itself. Herein we present the effects of varying pressure on the electrical performance of MAPI solar cells. Solar cell parameters, especially open circuit voltage, are significantly affected by the total ambient pressure and present an unexpected reversible behavior upon pressure cycling. We complement photoluminescence studies as a function of ambient atmosphere and temperature with first-principles density functional t...

[1]  Henry J. Snaith,et al.  Stability of Metal Halide Perovskite Solar Cells , 2015 .

[2]  Blöchl,et al.  Projector augmented-wave method. , 1994, Physical review. B, Condensed matter.

[3]  Jinli Yang,et al.  Investigation of CH3NH3PbI3 degradation rates and mechanisms in controlled humidity environments using in situ techniques. , 2015, ACS nano.

[4]  Linghai Zhang,et al.  Ab Initio Study of Interaction of Water, Hydroxyl Radicals, and Hydroxide Ions with CH3NH3PbI3 and CH3NH3PbBr3 Surfaces , 2015 .

[5]  M. Green,et al.  Physics of the temperature coefficients of solar cells , 2015 .

[6]  A. Tkatchenko,et al.  Accurate molecular van der Waals interactions from ground-state electron density and free-atom reference data. , 2009, Physical review letters.

[7]  Philip Schulz,et al.  Air-Exposure-Induced Gas-Molecule Incorporation into Spiro-MeOTAD Films. , 2014, The journal of physical chemistry letters.

[8]  Y. Qi,et al.  Moisture and Oxygen Enhance Conductivity of LiTFSI‐Doped Spiro‐MeOTAD Hole Transport Layer in Perovskite Solar Cells , 2016, Advanced Materials Interfaces.

[9]  M. Dion,et al.  van der Waals density functional for general geometries. , 2004, Physical review letters.

[10]  Jinsong Huang,et al.  Ultrahigh sensitivity of methylammonium lead tribromide perovskite single crystals to environmental gases , 2016, Science Advances.

[11]  A. Rahimi‐Iman,et al.  Oxygen Intercalation Induced by Photocatalysis on the Surface of Hybrid Lead Halide Perovskites , 2016 .

[12]  Jenny Nelson,et al.  Reversible Hydration of CH3NH3PbI3 in Films, Single Crystals, and Solar Cells , 2015 .

[13]  Qi Chen,et al.  Improved air stability of perovskite solar cells via solution-processed metal oxide transport layers. , 2016, Nature nanotechnology.

[14]  Y. Kanemitsu,et al.  Near-band-edge optical responses of solution-processed organic–inorganic hybrid perovskite CH3NH3PbI3 on mesoporous TiO2 electrodes , 2014 .

[15]  Y. Meng,et al.  Spectrum-Dependent Spiro-OMeTAD Oxidization Mechanism in Perovskite Solar Cells. , 2015, ACS applied materials & interfaces.

[16]  Stefan Grimme,et al.  Semiempirical GGA‐type density functional constructed with a long‐range dispersion correction , 2006, J. Comput. Chem..

[17]  P. Docampo,et al.  The Influence of Water Vapor on the Stability and Processing of Hybrid Perovskite Solar Cells Made from Non-Stoichiometric Precursor Mixtures. , 2016, ChemSusChem.

[18]  Jing Wei,et al.  Reversible Healing Effect of Water Molecules on Fully Crystallized Metal–Halide Perovskite Film , 2016 .

[19]  Mohammad Khaja Nazeeruddin,et al.  Outdoor Performance and Stability under Elevated Temperatures and Long‐Term Light Soaking of Triple‐Layer Mesoporous Perovskite Photovoltaics , 2015 .

[20]  Yao Sun,et al.  Enhancement of perovskite-based solar cells employing core-shell metal nanoparticles. , 2013, Nano letters.

[21]  Kresse,et al.  Efficient iterative schemes for ab initio total-energy calculations using a plane-wave basis set. , 1996, Physical review. B, Condensed matter.

[22]  Jon M. Azpiroz,et al.  Ab Initio Molecular Dynamics Simulations of Methylammonium Lead Iodide Perovskite Degradation by Water , 2015 .

[23]  Wolfgang Kowalsky,et al.  Water Infiltration in Methylammonium Lead Iodide Perovskite : Fast and Inconspicuous , 2015 .

[24]  Zhengshan Yu,et al.  Selecting tandem partners for silicon solar cells , 2016, Nature Energy.

[25]  Martin A. Green,et al.  Solar cell efficiency tables (version 48) , 2016 .

[26]  A. Ciccioli,et al.  On the Thermal and Thermodynamic (In)Stability of Methylammonium Lead Halide Perovskites , 2016, Scientific Reports.

[27]  Christophe Ballif,et al.  Sputtered rear electrode with broadband transparency for perovskite solar cells , 2015 .

[28]  Ullrich Steiner,et al.  Perovskite Solar Cell Stability in Humid Air: Partially Reversible Phase Transitions in the PbI2‐CH3NH3I‐H2O System , 2016 .

[29]  Burke,et al.  Generalized Gradient Approximation Made Simple. , 1996, Physical review letters.

[30]  Wenge Yang,et al.  Simultaneous band-gap narrowing and carrier-lifetime prolongation of organic–inorganic trihalide perovskites , 2016, Proceedings of the National Academy of Sciences.

[31]  T. Edvinsson,et al.  Room Temperature as a Goldilocks Environment for CH3NH3PbI3 Perovskite Solar Cells: The Importance of Temperature on Device Performance , 2016 .

[32]  Konrad Wojciechowski,et al.  Mapping Electric Field‐Induced Switchable Poling and Structural Degradation in Hybrid Lead Halide Perovskite Thin Films , 2015 .

[33]  H. Snaith,et al.  Structural and optical properties of methylammonium lead iodide across the tetragonal to cubic phase transition: implications for perovskite solar cells , 2016 .