Cryogenic composite supports: a review of strap and strut properties

The properties of fibre-reinforced composite straps and struts that are used for thermal isolation and mechanical support of cryogenic systems are reviewed. The review includes compilation and discussion of the mechanical (tension, compression, fatigue) and thermal (contraction, conductivity, specific heat) aspects of both structures. The role of fibre lay-up is discussed, and the two types of support modes are compared.

[1]  R. P. Reed,et al.  Cryogenic properties of unidirectional composites , 1994 .

[2]  N. F. Dow,et al.  Structural efficiency of orthotropic cylindrical shells subjected to axial compression. , 1965 .

[3]  Cc Chamis,et al.  Compressive Behavior of Unidirectional Fibrous Composites , 1983 .

[4]  K. Han,et al.  Mechanical and Thermal Properties of Glass-Fiber-Reinforced Composites at Cryogenic Temperatures , 1982 .

[5]  M. Shuart Failure of compression-loaded multi-directional composite laminates , 1988 .

[6]  T. Hayashi On the shear instability of structures caused by compressive load , 1965 .

[7]  W. Young,et al.  Ultimate strength, low stress creep characteristics, and thermal intercept methods for an epoxy fiberglass tension member support , 1980 .

[8]  Y. Fung,et al.  Fiber Composite Columns Under Compression , 1972 .

[9]  Thermal expansion characteristics of graphite-reinforced composite materials , 1972 .

[10]  Thermal and fatigue cycling of fibre composites , 1995 .

[11]  J. Tasi Effect of heterogeneity on the stability of composite cylindrical shells under axial compression. , 1966 .

[12]  M. B. Kasen,et al.  Cryogenic mechanical properties of boron-, graphite-, and glass-reinforced composites☆ , 1977 .

[13]  Comparison of composite and noncomposite structural tubes. , 1968 .

[14]  A. Schedler Fibre composites in satellites , 1988 .

[15]  S. Tsai,et al.  Introduction to composite materials , 1980 .

[16]  H. Thomas Hahn,et al.  Compression Failure Mechanisms in Unidirectional Composites , 1986 .

[17]  Marvin Guiles Liquid crystal polymer cryogenic storage tank with reduced thermal loss and weight , 1995 .

[18]  H. Bansemir,et al.  Basic material data and structural analysis of fibre composite components for space application , 1991 .

[19]  The Thermal Conductivity and Thermal Expansion of Non-Metallic Composite Materials at Low Temperatures , 1982 .

[20]  Peter Kittel Comparison of Dewar supports for space applications , 1993 .

[21]  G. Hartwig Overview of advanced fibre composites , 1988 .

[22]  R. A. Hopkins,et al.  Optimized support systems for spaceborne dewars , 1987 .

[23]  S. Nishijima,et al.  Thermal Insulating Support Systems for Radiation Environments , 1992 .

[24]  S. Knaak,et al.  Fibre-epoxy composites at low temperatures , 1984 .

[25]  H. Rosenberg,et al.  The thermal conductivity of glass-fibre and carbon-fibre/epoxy composites from 2 to 80 k , 1982 .

[26]  Michael S. Kramer Composites for Cryogenics , 1991 .

[27]  R. P. Reed,et al.  Advances in Cryogenic Engineering Materials , 1988 .

[28]  M. B. Kasen Mechanical and thermal properties of filamentary-reinforced structural composites at cryogenic temperatures 1: Glass-reinforced composites , 1975 .

[29]  J. Tasi,et al.  The Buckling Strength of Filament-Wound Cylinders Under Axial Compression, , 1965 .

[30]  M. Darby,et al.  Thermal conductivity measurements of some glass fibre- and carbon fibre-reinforced plastics , 1990 .

[31]  G. Hartwig,et al.  Thermal expansion of carbon fibre composites with thermoplastic matrices , 1991 .

[32]  G. Hartwig REINFORCm POLYMERS AT LOW TEMPERATURES , 1982 .

[33]  Chamis Thermoelastic properties of unidirectional filamentary composites by a semiempirical micromechanics theory. [B, C, and glass-filament epoxy-resin composites] , 1974 .

[34]  M. B. Kasen Cryogenic properties of filamentary-reinforced composites: an update , 1981 .

[35]  S. Nishijima,et al.  Thermal and Mechanical Properties of Advanced Composite Materials at Low Temperatures , 1986 .

[36]  D. Read,et al.  Fatigue Resistance of a Uniaxial S-Glass/Epoxy Composite at Room and Liquid Helium Temperatures , 1976 .