Marchand Balun Embedded Probe

Planar-type Marchand baluns are embedded into on-wafer probes in order to provide accurate differential measurement capabilities for conventional single-ended measurement equipments such as the two-port vector network analyzer. In designing the planar-type Marchand balun, the values for differential- and common-mode characteristic impedances of the coupled transmission lines are analytically derived by using general transmission line theories. The derived characteristic impedances are realized using a double-sided single-layer printed circuit board surrounded by conductive fixtures. The proposed coupled transmission line structure provides convenient port interfaces to the coaxial cables and it is free from bond wires and vias, enabling one to achieve high cost efficiency and reproducibility.

[1]  Yicheng Lu,et al.  A silicon monolithic spiral transmission line balun with symmetrical design , 1999, IEEE Electron Device Letters.

[2]  S. P. Knight,et al.  Status of Lumped Elements in Microwave Integrated Circuits - Present and Future , 1971 .

[3]  S. A. Maas,et al.  A broadband, planar, doubly balanced monolithic Ka-band diode mixer , 1993 .

[4]  D. J. Allstot,et al.  A 0.5-8.5 GHz fully differential CMOS distributed amplifier , 2002 .

[5]  A. M. Pavio,et al.  A monolithic or hybrid broadband compensated balun , 1990, IEEE International Digest on Microwave Symposium.

[6]  T. Zwick,et al.  Pure-mode network analyzer concept for on-wafer measurements of differential circuits at millimeter-wave frequencies , 2005, IEEE Transactions on Microwave Theory and Techniques.

[7]  Dylan F. Williams,et al.  A General Waveguide Circuit Theory , 1992, Journal of research of the National Institute of Standards and Technology.

[8]  Walter V. Tyminski,et al.  A Wide-Band Hybrid Ring for UHF , 1953, Proceedings of the IRE.

[9]  Michael Yan Wah Chia,et al.  A novel LTCC miniaturized dualband balun , 2006 .

[10]  Jwo-Shiun Sun,et al.  Design of a planar balun , 2001, APMC 2001. 2001 Asia-Pacific Microwave Conference (Cat. No.01TH8577).

[11]  W. Eisenstadt,et al.  Combined differential and common-mode scattering parameters: theory and simulation , 1995 .

[12]  Wojciech Marczewski,et al.  The Overlapped Microstrip for MICs and MMICs , 1984, 1984 14th European Microwave Conference.

[13]  Guo-Wei Huang,et al.  Monolithic Broadband Gilbert Micromixer With an Integrated Marchand Balun Using Standard Silicon IC Process , 2006, IEEE Transactions on Microwave Theory and Techniques.

[14]  W. R. Eisenstadt,et al.  Pure-mode network analyzer for on-wafer measurements of mixed-mode S-parameters of differential circuits , 1997 .

[15]  Ian D. Robertson,et al.  Analysis and design of impedance-transforming planar Marchand baluns , 2001 .

[16]  N. Marchand,et al.  Transmission-line Conversion Transformers , 1944 .

[17]  Cam Nguyen,et al.  Computer-aided analysis and design of a planar multilayer Marchand balun , 1994 .

[18]  J. Dunsmore.  New methods & non-linear measurements for active differential devices , 2003, IEEE MTT-S International Microwave Symposium Digest, 2003.

[19]  William R. Eisenstadt,et al.  SPICE-based mixed-mode S-parameter calculations for four-port and three-port circuits , 2006, IEEE Transactions on Computer-Aided Design of Integrated Circuits and Systems.

[20]  Sang-Gug Lee,et al.  Low power fully differential frequency doubler , 2003 .

[21]  W.R. Eisenstadt,et al.  Design and optimization of a 5 GHz CMOS power amplifier , 2005, The 2005 IEEE Annual Conference Wireless and Micrwave Technology, 2005..

[22]  Sheng-Fuh Chang,et al.  A 20-40 GHz monolithic doubly-balanced mixer using modified planar Marchand baluns , 2001, APMC 2001. 2001 Asia-Pacific Microwave Conference (Cat. No.01TH8577).

[23]  R.L. Campbell.  High Frequency Differential Passive FET Direct Conversion Mixer/Modulator , 2006, 2006 IEEE MTT-S International Microwave Symposium Digest.

[24]  M.Y.W. Chia,et al.  A novel LTCC miniaturized dualband balun , 2005, 2005 European Microwave Conference.