Film thickness decay and replenishment in point contact lubricated with different greases: A study into oil bleeding and the evolution of lubricant reservoir

Abstract Six different types of greases were tested on the ball-on-disc test rig under starved condition. Both the central film thickness and the cross section film thickness profile were analyzed to better understand the mechanism of grease starvation. In-situ Monitoring of lubricant reservoir was achieved by using a high-resolution camera. Results showed that a new reservoir would re-form after a period of operation after the contact lost its initial grease reservoir under starved condition. The higher oil bleeding ratio of grease, the larger re-formed lubricant reservoir would be. A turning point on the central film thickness curve was found, which was due to the loss and re-formation of the lubricant reservoir.

[1]  Jorge H.O. Seabra,et al.  Friction torque in grease lubricated thrust ball bearings , 2011 .

[3]  D. Mazuyer,et al.  Effects of Grease Composition and Structure on Film Thickness in Rolling Contact , 2003 .

[4]  Henrik Åström,et al.  Lubricating Grease Replenishment in an Elastohydrodynamic Point Contact , 1993 .

[5]  H. Spikes,et al.  Visualisation of starved grease and fluid lubricant films , 1995 .

[6]  G. Dalmaz,et al.  Film Thickness in Starved EHL Point Contacts , 1998 .

[7]  Philippa Cann,et al.  Starvation and Reflow in a Grease-Lubricated Elastohydrodynamic Contact , 1996 .

[8]  S. Wen,et al.  Effects of Slide/Roll Ratio on the Behaviours of Grease Reservoir and Film Thickness of Point Contact , 2014, Tribology Letters.

[9]  Gerhard Poll,et al.  Correlation between Model Test Devices and Full Bearing Tests under Grease Lubricated Conditions , 2006 .

[10]  S. Wen,et al.  Starvation and Reflow of Point Contact Lubricated with Greases of Different Chemical Formulation , 2014, Tribology Letters.

[11]  S. Wen,et al.  A Theoretical and Experimental Study of EHL Lubricated With Grease , 1988 .

[12]  Philippa Cann,et al.  Starved Grease Lubrication of Rolling Contacts , 1999 .

[13]  A. Lubrecht,et al.  The effect of transient loading on contact replenishment with lubricating greases , 2003 .

[14]  Henrik Åström,et al.  Video recordings of an EHD point contact lubricated with grease , 1991 .

[15]  Pieter Martin Lugt,et al.  Grease Lubrication in Rolling Bearings , 2013 .

[16]  P. Cann.  Grease degradation in a bearing simulation device , 2006 .

[17]  Peiran Yang,et al.  Influence of spinning on the rolling EHL films , 2010 .

[18]  A. Lubrecht,et al.  Influence of Cage Clearance on Bearing Lubrication© , 2003 .

[19]  K. Kalogiannis,et al.  Track Replenishment by Lateral Vibrations in Grease-Lubricated EHD Contacts , 2012 .

[20]  Antonius Lubrecht,et al.  The transition between fully flooded and starved regimes in EHL , 2004 .