Spall strength of glass fiber reinforced polymer composites

Abstract In the present paper results of a series of plate impact experiments designed to study spall strength in glass–fiber reinforced polymer composites (GRP) are presented. Two GRP architectures are investigated—S2 glass woven roving in Cycom 4102 polyester resin matrix and a balanced 5-harness satin weave E-glass in a Ciba epoxy (LY564) matrix. The GRP specimens were shock loaded using an 82.5 mm bore single-stage gas-gun. A velocity interferometer was used to measure the particle velocity profile at the rear (free) surface of the target plate. The spall strength of the GRP was obtained as a function of the normal component of the impact stress and the applied shear-strain by subjecting the GRP specimens to normal shock compression and combined shock compression and shear loading, respectively. The spall strengths of the two GRP composites were observed to decrease with increasing levels of normal shock compression. Moreover, superposition of shear-strain on the normal shock compression was found to be highly detrimental to the spall strength. The E-glass reinforced GRP composite was found to have a much higher level of spall strength under both normal shock compression and combined compression and shear loading when compared to the S2-glass GRP composite. The maximum spall strength of the E-glass GRP composite was found to be 119.5 MPa, while the maximum spall strength for the S2 glass GRP composite was only 53.7 MPa. These relatively low spall strength levels of the S2-glass and the E-glass fiber reinforced composites have important implications to the design and development of GRP-based light-weight integral armor.

[1]  B. K. Fink,et al.  Aluminum foam integral armor: a new dimension in armor design , 2001 .

[2]  M. E. Kipp,et al.  Dynamic Fracture and Fragmentation , 1993 .

[3]  A. El-Habak Mechanical behaviour of woven glass fibre-reinforced composites under impact compression load , 1991 .

[4]  B. K. Fink,et al.  High Strain-Rate Behavior of Plain-Weave S-2 Glass/Vinyl Ester Composites , 2001 .

[5]  Howard Kuhn,et al.  Mechanical testing and evaluation , 2000 .

[6]  V. Prakash A pressure-shear plate impact experiment for investigating transient friction , 1995 .

[7]  P. Beaulieu,et al.  Elastic constants and delamination strength of a glass-fiber-reinforced polymer composite , 1998 .

[8]  S. K. Chaturvedi,et al.  Dynamic Loading and Characterization of Fiber-Reinforced Composites , 1997 .

[9]  Isaac M Daniel,et al.  Nonlinear Elastic Behavior of Unidirectional Composites With Fiber Waviness Under Compressive Loading , 1996 .

[10]  B. K. Fink,et al.  Performance Metrics for Composite Integral Armor , 2000 .

[11]  Lundergan THE HUGONIOT EQUATION OF STATE OF 6061-T6 ALUMINUM AT LOW PRESSURES , 1963 .

[12]  L. M. Barker,et al.  Laser interferometer for measuring high velocities of any reflecting surface , 1972 .

[13]  M. Benzeggagh,et al.  Comparative study of strain rate effects on mechanical properties of glass fibre-reinforced thermoset matrix composite , 1996 .

[14]  K. Bruce,et al.  Performance Metrics for Composite Integral Armor , 2000 .

[15]  A. Agbossou,et al.  Effects of interphase and impact strain rates on tensile off-axis behaviour of unidirectional glass fibre composite: Experimental results , 1995 .

[16]  Rodney J. Clifton,et al.  A combined normal‐ and transverse‐displacement interferometer with an application to impact of y‐cut quartz , 1977 .

[17]  P. Avan,et al.  CONTRIBUTIONS OF TEMPORAL ANALYSIS OF TRANSIENT EVOKED OTOACOUSTIC EMISSIONS TO THE IDENTIFICATION OF THEIR SOURCES , 1994 .

[18]  J. Lifshitz Impact Strength of Angle Ply Fiber Reinforced Materials , 1976 .

[19]  B. K. Fink,et al.  Investigation of high-velocity impact on integral armor using finite element method , 2000 .

[20]  F. Wallenberger,et al.  Glass Fibers , 2001 .

[21]  G. Ravichandran,et al.  Failure mode transition and energy dissipation in naturally occurring composites , 2004 .

[22]  Isaac M Daniel,et al.  EFFECT OF FIBER WAVINESS ON STIFFNESS AND STRENGTH REDUCTION OF UNIDIRECTIONAL COMPOSITES UNDER COMPRESSIVE LOADING , 1996 .

[23]  G. Kanel,et al.  Glass-epoxy composite behaviour under shock loading , 1994 .

[24]  V.P.W. Shim,et al.  An empirical strain rate-dependent constitutive relationship for glass-fibre reinforced epoxy and pure epoxy , 1995 .

[25]  Gal deBotton,et al.  The response of a glass fibers reinforced epoxy composite to an impact loading , 2004 .

[26]  M. Meyers Dynamic Behavior of Materials , 1994 .