论文信息 - Effect of pressure history on shrinkage and residual stresses—injection molding with constrained shrinkage

Effect of pressure history on shrinkage and residual stresses—injection molding with constrained shrinkage

A simple elastic model for residual stresses and shrinkage of a thin solidifying product is proposed. The model results in expressions ready to be used. It accounts for shrinkage anisotropy between in-plane and thickness directions, caused by different constraints in deformation. The model uses local values for temperature, pressure, crystallization, and (if present) extent of reaction, which belong to the standard output of most simulation codes. It is therefore assumed to be valid also for complex shaped products.

Giuseppe Titomanlio | K. Jansen | G. Titomanlio | Kaspar M. B. Jansen

[1] M. Rezayat,et al. A thermoviscoelastic model for residual stress in injection molded thermoplastics , 1991 .

[2] J. C. Jaeger,et al. Conduction of Heat in Solids , 1952 .

[3] S. Timoshenko,et al. Theory of Elasticity (3rd ed.) , 1970 .

[4] J. Greener,et al. Pressure‐Induced densification in injection molding , 1986 .

[5] S. Timoshenko,et al. Theory of elasticity , 1975 .

[6] A. Isayev,et al. Residual Stress Development in the Injection Molding of Polymers , 1984 .

[7] G. Schennink,et al. The measurement of thermal stress distributions along the flow path in injection‐molded flat plates , 1992 .

[8] A. Isayev,et al. Volumetric effects in the injection molding of polymers , 1985 .

[9] Fpt Frank Baaijens. Calculation of residual stresses in injection molded products , 1991 .

[10] P. B. Allen. Conduction of Heat. , 1983 .

[11] C. Buckley. Prediction of stress in a linear viscoelastic solid strained while cooling , 1988 .

[12] Residual Stresses in Quenched and Injection Moulded Products , 1994 .