Field test investigation of the characteristics for the air source heat pump under two typical mal-defrost phenomena

A study is presented on the characteristics of the air source heat pump (ASHP) under two kinds of typical mal-defrost phenomena. The definition of the “Mal-defrost phenomena” is put forward, and the possible origins of their occurrence are analyzed. It is concluded that the current defrost strategies may cause mal-defrost phenomena due to the lack of the direct control information, frost thickness. Transient characteristics of the tested ASHP under these mal-defrost phenomena are investigated by field tests. Instant frosting images are captured to record the dynamic frosting process. In the first phenomenon of mal-defrost, the defrost control is carried out over an hour after a “critical” level of frosting has been reached. It reduces the COP and heating capacity by about 17.4% and 29%, respectively. In the second phenomenon of mal-defrost, three defrost operations occur while almost no frost is observed on the heat exchanger during 6h testing period. It causes 4.2% decrease for the heating efficiency.

[1]  Wang Zhiyi,et al.  Defrost improvement by heat pump refrigerant charge compensating , 2008 .

[2]  Wei Wang,et al.  An experimental study of the correlation for predicting the frost height in applying the photoelectric technology , 2010 .

[3]  Xingqun Zhang,et al.  Effects of fan-starting methods on the reverse-cycle defrost performance of an air-to-water heat pump , 2004 .

[4]  Wei Wang,et al.  An analysis of the feasibility and characteristics of photoelectric technique applied in defrost-control , 2009 .

[5]  Judith Evans,et al.  Refrigerant flow instability as a means to predict the need for defrosting the evaporator in a retail display freezer cabinet , 2008 .

[6]  Ju-Suk Byun,et al.  Frost retardation of an air-source heat pump by the hot gas bypass method , 2008 .

[7]  Kyung-Min Kwak,et al.  A study on the performance enhancement of heat pump using electric heater under the frosting condition: Heat pump under frosting condition , 2010 .

[8]  Paul Byrne,et al.  Design and simulation of a heat pump for simultaneous heating and cooling using HFC or CO2 as a working fluid , 2009 .

[9]  Ju-Suk Byun,et al.  The application of photo-coupler for frost detecting in an air-source heat pump , 2006 .

[10]  D. S Llewelyn.  A significant advance in defrost control , 1984 .

[11]  Savvas A. Tassou,et al.  Frost formation and defrost control parameters for open multideck refrigerated food display cabinets , 2001 .

[12]  Dong Huang,et al.  Comparison between hot-gas bypass defrosting and reverse-cycle defrosting methods on an air-to-water heat pump , 2009 .

[13]  R. Morgan,et al.  Ice detection in heat pumps and coolers , 1978 .

[14]  Di Liu,et al.  Frosting of heat pump with heat recovery facility , 2007 .

[15]  Y. T. Shah,et al.  Frost Deposition on Cold Surfaces , 1970 .

[16]  Xiaosong Zhang,et al.  Control strategy and experimental study on a novel defrosting method for air-source heat pump , 2010 .

[17]  Dennis L. O'Neal,et al.  Effect of short-tube orifice size on the performance of an air source heat pump during the reverse-cycle defrost , 1991 .