Unsteady Simulations of the Flow in a Swirl Generator, Using OpenFOAM

This work presents numerical results, using OpenFOAM, of the flow in the swirl flow generator test rig developed at Politehnica University of Timisoara, Romania. The work shows results computed by solving the unsteady Reynolds Averaged Navier Stokes equations. The unsteady method couples the rotating and stationary parts using a sliding grid interface based on a GGI formulation. Turbulence is modeled using the standard k-e model, and block structured wall function ICEM-Hexa meshes are used. The numerical results are validated against experimental LDV results, and against design velocity profiles. The investigation shows that OpenFOAM gives results that are comparable to the experimental and design profiles. The unsteady pressure fluctuations at four different positions in the draft tube is recorded. A Fourier analysis of the numerical results is compared whit that of the experimental values. The amplitude and frequency predicted by the numerical simulation are comparable to those given by the experimental results, though slightly over estimated.

[1]  Oscar Bergman.  Numerical investigation of the flow in a swirl generator, using OpenFOAM , 2010 .

[2]  Sebastian Muntean,et al.  Decelerated Swirling Flow Control in the Discharge Cone of Francis Turbines , 2009 .

[3]  Design and Manufacturing of a Convergent-Divergent Test Section for Swirling Flow Apparatus , 2008 .

[4]  M. Zangeneh,et al.  A compressible three‐dimensional design method for radial and mixed flow turbomachinery blades , 1991 .

[5]  François Avellan,et al.  Flow Investigation in a Francis Draft Tube : the Flindt Project , 2000 .

[6]  Alin Bosioc,et al.  Mitigation of pressure fluctuations in the discharge cone of hydraulic turbines using flow-feedback , 2010 .

[7]  Hrvoje Jasak,et al.  The OpenFOAM turbomachinery working group, and conclusions from the turbomachinery session of the third OpenFOAM Workshop , 2008 .

[8]  S. Bernad,et al.  SWIRLING FLOW APPARATUS AND TEST RIG FOR FLOW CONTROL IN HYDRAULIC TURBINES DISCHARGE CONE , 2007 .

[9]  Olivier Petit,et al.  The ERCOFTAC centrifugal pump OpenFOAM case-study , 2009 .

[10]  Hrvoje Jasak,et al.  Development of a Generalized Grid Mesh Interface for Turbomachinery simulations with OpenFOAM , 2008 .

[11]  Håkan Nilsson,et al.  3D numerical analysis of the unsteady turbulent swirling flow in a conical diffuser using Fluent and OpenFOAM , 2009 .

[12]  Alin Bosioc,et al.  Unsteady pressure measurements and numerical investigation of the jet control method in a conical diffuser with swirling flow , 2010 .