Defect annealing processes for polycrystalline silicon thin-film solar cells

Abstract A variety of defect healing methods was analyzed for optimization of polycrystalline silicon (poly-Si) thin-film solar cells on glass. The films were fabricated by solid phase crystallization of amorphous silicon deposited either by plasma enhanced chemical vapor deposition (PECVD) or by electron-beam evaporation (EBE). Three different rapid thermal processing (RTP) set-ups were compared: A conventional rapid thermal annealing oven, a dual wavelength laser annealing system and a movable two sided halogen lamp oven. The two latter processes utilize focused energy input for reducing the thermal load introduced into the glass substrates and thus lead to less deformation and impurity diffusion. Analysis of the structural and electrical properties of the poly-Si thin films was performed by Suns-VOC measurements and Raman spectroscopy. 1 cm2 cells were prepared for a selection of samples and characterized by I–V-measurements. The poly-Si material quality could be extremely enhanced, resulting in increase of the open circuit voltages from about 100 mV (EBE) and 170 mV (PECVD) in the untreated case up to 480 mV after processing.

[1]  A. Aberle,et al.  Rapid Thermal Annealing and Hydrogen Passivation of Polycrystalline Silicon Thin-Film Solar Cells on Low-Temperature Glass , 2007 .

[2]  D. Biegelsen,et al.  Deuterium passivation of grain‐boundary dangling bonds in silicon thin films , 1982 .

[3]  D. A. Clugston,et al.  Crystalline silicon on glass (CSG) thin-film solar cell modules , 2004 .

[4]  P. Stolk,et al.  The influence of polysilicon gate morphology on dopant activation and deactivation kinetics in deep-submicron CMOS transistors , 2001 .

[5]  B. Rech,et al.  Influence of Hydrogen Plasma on the Defect Passivation of Polycrystalline Si Thin Film Solar Cells , 2009 .

[6]  Toshiaki Baba,et al.  High-quality polycrystalline silicon thin film prepared by a solid phase crystallization method , 1996 .

[7]  Hiroaki Morikawa,et al.  16.0% Efficiency of large area (10cm×10cm) thin film polycrystalline silicon solar cell , 1998 .

[8]  B. Rech,et al.  Development of a rapid thermal annealing process for polycrystalline silicon thin-film solar cells on glass , 2009 .

[9]  B. Rech,et al.  Characterization and control of crystal nucleation in amorphous electron beam evaporated silicon for thin film solar cells , 2011 .

[10]  Warren B. Jackson,et al.  Hydrogen passivation of grain boundary defects in polycrystalline silicon thin films , 1993 .

[11]  A. Slaoui,et al.  High-temperature laser annealing for thin film polycrystalline silicon solar cell on glass substrate , 2012 .

[12]  R. Reedy,et al.  Comparative Study of Solid-Phase Crystallization of Amorphous Silicon Deposited by Hot-wire CVD, Plasma-Enhanced CVD, and Electron-Beam Evaporation , 2007 .

[13]  Armin G. Aberle,et al.  Large open-circuit voltage improvement by rapid thermal annealing of evaporated solid-phase-crystallized thin-film silicon solar cells on glass , 2005 .