AN EXPERIMENTAL INVESTIGATION ON WEAR ASPECTS OF TAPPING OPERATION ON HARDENED STEELS
暂无分享,去创建一个
Reginaldo Teixeira Coelho | Hugo Martinelli Watanuki | Emanuel Nunes Borges | Ricardo Arai | Hugo Martinelli Watanuki | R. Coelho | E. N. Borges | Ricardo Arai
[1] Yang Shengrong,et al. The tribological behaviors of various metallic cations in tapping of a titanium alloy , 2001 .
[2] J. S. Agapiou,et al. Evaluation of the Effect of High Speed Machining on Tapping , 1994 .
[3] Richard E. DeVor,et al. Use of radial forces for fault detection in tapping , 2002 .
[4] David K. Aspinwall,et al. The surface integrity of turned and ground hardened bearing steel , 1996 .
[5] Y. Kevin Chou,et al. Tool wear mechanism in continuous cutting of hardened tool steels , 1997 .
[6] De-yuan Zhang,et al. Relief-face friction in vibration tapping , 1998 .
[7] Wei Li,et al. Diagnosis of tapping process using spindle motor current , 2003 .
[8] Gerry Byrne,et al. Cutting tool wear in the machining of hardened steels , 2001 .
[9] Gerry Byrne,et al. Cutting tool wear in the machining of hardened steels: Part I: alumina/TiC cutting tool wear , 2001 .
[10] M. Arndt,et al. Performance of new AlTiN coatings in dry and high speed cutting , 2003 .
[11] Hans Kurt Tönshoff,et al. Cutting of Hardened Steel , 2000 .
[12] John W. Sutherland,et al. Investigation of thread tapping load characteristics through mechanistics modeling and experimentation , 2002 .
[13] H. Brändle,et al. New hard/lubricant coating for dry machining , 1999 .