Degradation of ZnO-based window layers for thin-film CIGS by accelerated stress exposures

The reliability of ZnO-based window layer for CuInGaSe2 (CIGS) solar cells was investigated. Samples of RF magnetron-sputtered, single-layer intrinsic and Al-doped ZnO and their combined bilayer on glass substrates were exposed in a weatherometer (WOM) and damp heat (DH) conditions with or without acetic acid vapor. Some preliminary samples of single-layer Al-doped Zn1-xMgxO (ZMO) alloy, a potential replacement for Al:ZnO with a wider bandgap, were also evaluated in the DH. The Al-doped ZnO and ZMO films showed irreversible loss in the conducting properties, free carrier mobility, and characteristic absorption band feature after <500-h DH exposure, with the originally clear transparent films turned into white hazy insulating films and the degradation rate follows the trend of (DH + acetic acid) > DH > WOM. The degradation rate was also reduced by higher film thickness, higher deposition substrate temperature, and dry-out intervals. The results of X-ray diffraction analysis indicate that the ZnO-based films underwent structural degeneration by losing their highly (002) preferential orientation with possible transformation from hexagonal into cubic and formation of Zn(OH)2. Periodic optical micro-imaging observations suggested a temporal process that involves initial hydrolysis of the oxides at sporadic weak spots, swelling and popping of the hydrolyzed spots due to volume increase, segregation of hydrolyzed regions causing discontinuity of electrical path, hydrolysis of the oxide-glass interface, and finally, formation of insulating oxides/hydroxides with visible delamination over larger areas.

[1]  R. Noufi,et al.  Damp-heat induced degradation of transparent conducting oxides for thin-film solar cells , 2008, 2008 33rd IEEE Photovoltaic Specialists Conference.

[2]  R. Noufi,et al.  High Efficiency CdTe and CIGS Thin Film Solar Cells: Highlights of the Technologies Challenges (Presentation) , 2006 .

[3]  Sang‐Woo Kim,et al.  Degradation of ZnO nanowire devices under the ambient condition , 2008 .

[4]  Rommel Noufi,et al.  An Investigation of Stability Issues of ZnO and Mo on Glass Substrates for CIGS Solar Cells upon Accelerated Weathering and Damp Heat Exposures , 2007 .

[5]  T. Venkatesan,et al.  Realization of band gap above 5.0 eV in metastable cubic-phase MgxZn1−xO alloy films , 2002 .

[6]  K. Terwilliger,et al.  Materials Testing for PV Module Encapsulation , 2003 .

[7]  H. S. Ullal,et al.  Thin Film CIGS and CdTe Photovoltaic Technologies: Commercialization, Critical Issues, and Applications; Preprint , 2007 .

[8]  N. Ohashi,et al.  Defect structures in undoped and doped ZnO films studied by solid state diffusion , 2004 .

[9]  D. Domine,et al.  Micromorph Solar Cell Optimization using a ZnO Layer as Intermediate Reflector , 2006, 2006 IEEE 4th World Conference on Photovoltaic Energy Conference.

[10]  S. Wiedeman,et al.  Scale-Up at Global Solar Energy using Roll-to-Roll Processes for Thin Film CIGS PV , 2007 .

[11]  Charlie Wood,et al.  Examination of lifetime-limiting failure mechanisms in CIGSS-based PV minimodules under environmental stress , 2008, 2008 33rd IEEE Photovoltaic Specialists Conference.

[12]  Jianshe Xue,et al.  RF magnetron sputtered ZnO:Al thin films on glass substrates: A study of damp heat stability on their optical and electrical properties , 2007 .

[14]  Christophe Ballif,et al.  Effect of ZnO Layer as Intermediate Reflector in Micromorph Solar Cells , 2005 .

[15]  R. M. Mehra,et al.  Effect of electrolytes on the photovoltaic performance of a hybrid dye sensitized ZnO solar cell , 2007 .

[16]  Takashi Minemoto,et al.  Antireflective coating fabricated by chemical deposition of ZnO for spherical Si solar cells , 2007 .

[17]  Gary Jorgensen,et al.  Moisture transport, adhesion, and corrosion protection of PV module packaging materials , 2006 .

[18]  R. Miles,et al.  Inorganic photovoltaic cells , 2007 .

[19]  M. Green.  Thin-film solar cells: review of materials, technologies and commercial status , 2007 .

[20]  R. Gordon.  Criteria for Choosing Transparent Conductors , 2000 .

[21]  F. Pern,et al.  Encapsulation of PV modules using ethylene vinyl acetate copolymer as a pottant: A critical review , 1996 .

[22]  R. Noufi,et al.  Effects of Mg Content on Zn1-xMgxO:Al Transparent Conducting Films , 2008 .

[23]  L. Schmidt‐Mende,et al.  ZnO - nanostructures, defects, and devices , 2007 .

[24]  E. Fortunato,et al.  Transparent Conducting Oxides for Photovoltaics , 2007 .

[25]  Kai Wang,et al.  Synthesis and properties of type II core/shell nanowire arrays for solar cells , 2008, 2008 33rd IEEE Photovoltaic Specialists Conference.

[26]  T. Minami.  New n-Type Transparent Conducting Oxides , 2000 .

[27]  Reinhard Carius,et al.  Amorphous Silicon, Microcrystalline Silicon, and Thin-Film Polycrystalline Silicon Solar Cells , 2007 .

[28]  Kakuya Iwata,et al.  Band-gap modified Al-doped Zn1-xMgxO transparent conducting films deposited by pulsed laser deposition , 2004 .

[29]  Martha Christina Lux-Steiner,et al.  ZnO layers deposited by the ion layer gas reaction on Cu(In,Ga)(S,Se)2 thin film solar cell absorbers—impact of ‘damp‐heat’ conditions on the layer properties , 2007 .

[30]  Rommel Noufi,et al.  Characterization of 19.9%-efficient CIGS absorbers , 2008, 2008 33rd IEEE Photovoltaic Specialists Conference.