A review of the interference of carbon containing fly ash with air entrainment in concrete

Abstract Industrial utilization of fly ash from pulverized coal combustion plays an important role in environmentally clean and cost effective power generation. Today, the primary market for fly ash utilization is as pozzolanic additive in the production of concrete. However, the residual carbon in fly ash may interfere with air entraining admixtures (AEAs) added to enhance air entrainment in concrete in order to increase its workability and resistance toward freezing and thawing conditions. The problem has increased with implementation of low- NO x combustion technologies. This review presents the past work carried out to identify the mechanisms causing the interactions between AEAs and fly ash in concrete mixtures, emphasizing the residual carbon. It has been shown that not only the amount, but also the properties of carbon, such as particle size and surface chemistry, has an impact on the adsorption capacity of AEAs. The type of fuel used in the combustion process influences the amount and properties of the residual carbon. Fly ash derived from bituminous coal has generally higher carbon content compared with fly ash produced from subbituminous coal or lignite, but shows a lower AEA adsorption capacity per mass of carbon. Cases reporting increased residual carbon content due to low- NO x combustion are described, together with observations from a pilot scale experiment, where increased AEA adsorption capacity of carbon appeared to relate with firing at low- NO x conditions. Post-treatment methods applied to improve fly ash quality are described in the review. Ozonation, thermal treatment and physical cleaning of carbon have been found to improve the fly ash performance for concrete utilization. Ultimately, recommendations for further work are outlined in the discussion.

[1]  C. M. White,et al.  Characterization of carbon concentrates from coal-combustion fly ash , 2001 .

[2]  Ravindra K. Dhir,et al.  Pulverized fuel ash concrete: air-entrainment and freeze/thaw durability , 1999 .

[3]  T. Robl,et al.  Case study of the conversion of tangential- and wall-fired units to low-NOx combustion : Impact on fly ash quality , 1998 .

[4]  Kenneth E. Baldrey,et al.  Characterization of fly ash from full-scale demonstration of sorbent injection for mercury control on coal-fired power plants , 2004 .

[5]  D S Lane,et al.  TESTING FLY ASH IN MORTARS FOR AIR-ENTRAINMENT CHARACTERISTICS , 1991 .

[6]  Carolann Giovando.  Markets grow for coal-combustion byproducts , 2000 .

[7]  D. S. Zhang.  Air entrainment in fresh concrete with PFA , 1996 .

[8]  R. Helmuth,et al.  Fly Ash in Cement and Concrete , 1987 .

[9]  E. Teller,et al.  ADSORPTION OF GASES IN MULTIMOLECULAR LAYERS , 1938 .

[10]  Martin L Hall,et al.  Fly ash quality, past, present and future, and the effect of ash on the development of novel products , 2002 .

[11]  Y. Soong,et al.  Triboelectrostatic separation of fly ash and charge reversal , 2002 .

[12]  T. D. Brown,et al.  Mercury Measurement and Its Control: What We Know, Have Learned, and Need to Further Investigate. , 1999, Journal of the Air & Waste Management Association.

[13]  M. Gray,et al.  Parametric study of the column oil agglomeration of fly ash , 2001 .

[14]  M. Maroto-Valer,et al.  Mercury capture by distinct fly ash carbon forms , 2000 .

[15]  G. M. Bruere.  Air‐entraining actions of anionic surfactants in portland cement pastes , 2007 .

[16]  Koji Ikeda,et al.  Optimal boiler control through real-time monitoring of unburned carbon in fly ash by laser-induced breakdown spectroscopy. , 2003, Applied optics.

[17]  Robert H. Hurt,et al.  Mechanisms of surfactant adsorption on non-polar, air-oxidized and ozone-treated carbon surfaces , 2003 .

[18]  S. Diamond.  Concrete admixtures handbook: V.S. Ramachandran, editor. Noyes Publications, Park Ridge, NJ 07656. 1984. (cloth $84.00) , 1986 .

[19]  J. Makansi.  Diverse techniques help create markets for flyash , 1994 .

[20]  J. Hower,et al.  Dry triboelectrostatic beneficiation of fly ash , 1997 .

[21]  Robert H. Hurt,et al.  Residual carbon from pulverized coal fired boilers: 1. Size distribution and combustion reactivity , 1995 .

[22]  C. Senior,et al.  Impact of Carbon-in-Ash on Mercury Removal across Particulate Control Devices in Coal-Fired Power Plants , 2005 .

[23]  Robert H. Hurt,et al.  Effects of carbon on air entrainment in fly ash concrete : The role of soot and carbon black , 1997 .

[24]  James C. Hower,et al.  Investigation of fly ash carbon by thermal analysis and optical microscopy , 1998 .

[25]  Robert H. Hurt,et al.  Ozonation for the chemical modification of carbon surfaces in fly ash , 2001 .

[26]  D. W. Pershing,et al.  Measurement of soot and char in pulverized coal fly ash , 2000 .

[27]  J. K. Floess,et al.  Intrinsic reaction kinetics of microporous carbons. 1. Noncatalyzed chars , 1988 .

[28]  R. Hurt,et al.  Development of porosity during coal char combustion , 2002 .

[29]  A. Samarin,et al.  The Use of Fly Ash in Concrete-Australian Experience , 1983 .

[30]  D. W. Pershing,et al.  Sources of unburned carbon in the fly ash produced from low-NOx pulverized coal combustion , 1998 .

[31]  P. R. Norman,et al.  Characterisation of surface oxides on carbon and their influence on dynamic adsorption , 2002 .

[32]  O. Manz,et al.  Coal fly ash: a retrospective and future look , 1999 .

[33]  Elizabeth Freeman,et al.  Interactions of carbon-containing fly ash with commercial air-entraining admixtures for concrete , 1997 .

[34]  Robert H. Hurt,et al.  Adsorptive and Optical Properties of Fly Ash from Coal and Petroleum Coke Co-firing , 2000 .

[35]  Leonard W. Bell,et al.  CHEMICAL ADMIXTURES FOR CONCRETE , 1999 .

[36]  N Bouzoubaâ,et al.  Laboratory-produced high-volume fly ash blended cements: compressive strength and resistance to the chloride-ion penetration of concrete , 2000 .

[37]  J. Andresen,et al.  Physical cleaning of high carbon fly ash , 2002 .

[38]  Hong Jiang,et al.  On the kinetics of carbon (Char) gasification: Reconciling models with experiments , 1990 .

[39]  J. Hupka,et al.  Recovery of coke fines from fly ash by air sparged hydrocyclone flotation , 1999 .

[40]  Song Hu,et al.  An experimental research on boiler combustion performance , 2000 .

[41]  M. Mercedes Maroto-Valer,et al.  Characterization of differing forms of unburned carbon present in fly ash separated by density gradient centrifugation , 2001 .

[42]  Robert H. Hurt,et al.  Size distribution of unburned carbon in coal fly ash and its implications , 2004 .

[43]  F. Lea.  The chemistry of cement and concrete , 1970 .

[44]  R. Hurt,et al.  Residual carbon from pulverized-coal-fired boilers. 2. Morphology and physicochemical properties , 1995 .

[45]  A. Presto,et al.  Survey of catalysts for oxidation of mercury in flue gas. , 2006, Environmental science & technology.

[46]  Steven A. Benson,et al.  Status review of mercury control options for coal-fired power plants , 2003 .

[47]  J. Monzó,et al.  Thermogravimetric Methods for Determining Carbon Content in Fly Ashes , 1998 .

[48]  John P. Baltrus,et al.  Measurement of adsorption of air-entraining admixture on fly ash in concrete and cement , 2001 .

[49]  M. Mercedes Maroto-Valer,et al.  Novel separation of the differing forms of unburned carbon present in fly ash using density gradient centrifugation , 1999 .

[50]  A. Sarofim,et al.  Emissions of mercury, trace elements, and fine particles from stationary combustion sources , 2000 .

[51]  Nanjing.  Environmental assessment report , 2003 .

[52]  R. Neufeld,et al.  Autoclaved Aerated Concrete Produced with Low NOx Burner/Selective Catalytic Reduction Fly Ash , 2001 .

[53]  Klaus R. G. Hein,et al.  Effect of coal blending and particle size on NOx emission and burnout , 1994 .

[54]  R. Hurt,et al.  Evolution of char chemistry, crystallinity, and ultrafine structure during pulverized-coal combustion☆☆☆ , 1995 .

[55]  M. Çelik,et al.  Characterization and Recovery of Lignitic Fly Ash Byproducts from the Tuncbilek Power Station , 2002 .

[56]  David J. Corr,et al.  Air void morphology in fresh cement pastes , 2002 .

[57]  G. Lumpkin,et al.  Micro- and nanochemistry of fly ash from a coal-fired power plant , 2003 .

[58]  Impact of the conversion to low-NOx combustion on ash characteristics in a utility boiler burning Western US coal , 1999 .

[59]  Roger Rixom,et al.  The economic aspects of admixture use , 1998 .

[60]  Robert H. Hurt,et al.  Adsorption of surfactants on unburned carbon in fly ash and development of a standardized foam index test , 2003 .

[61]  P. Walker,et al.  THE IMPORTANCE OF ACTIVE SURFACE AREA IN THE CARBON-OXYGEN REACTION1,2 , 1963 .

[62]  A. Lizzio,et al.  Effect of oxygen chemisorption on char gasification reactivity profiles obtained by thermogravimetric analysis , 1988 .

[63]  Peter Glarborg,et al.  Influence of coal quality on combustion performance , 1998 .

[64]  N. Nevers,et al.  Air Pollution Control Engineering , 1994 .

[65]  Robert H. Hurt,et al.  The effect of solid fuel type and combustion conditions on residual carbon properties and fly ash quality , 2002 .

[66]  D. J. Fauth,et al.  Dry beneficiation of high loss-on-ignition fly ash , 2002 .

[67]  Stuart C. Burris,et al.  Comparison of heating losses and macro thermogravimetric analysis procedures for estimating unburned carbon in combustion residues , 2005 .

[68]  Yuming Gao,et al.  Surfactant adsorptivity of solid products from pulverized-coal combustion under controlled conditions , 1998 .

[69]  Martin Rhodes,et al.  Introduction to Particle Technology , 1998 .

[70]  James C. Hower,et al.  An examination of fly ash carbon and its interactions with air entraining agent , 1997 .

[71]  J. Andresen,et al.  Comparison of high-unburned-carbon fly ashes from different combustor types and their steam activated products , 2003 .

[72]  James C. Hower,et al.  Changes in the quality of coal combustion by-products produced by Kentucky power plants, 1978 to 1997: consequences of Clean Air Act directives , 1999 .

[73]  Robert C. Brown,et al.  Systematic errors in the use of loss-on-ignition to measure unburned carbon in fly ash , 1995 .

[74]  S. Turns.  An Introduction to Combustion: Concepts and Applications , 2000 .