Abstract SnO2 thin films, doped with Cd between 1 and 6 at.%, are prepared by an original method allowing us to obtain a high surface area; the adsorption of low NOx and NO2 concentrations onto the thin-film surface has been extensively studied. The thin films are grown by means of thermal evaporation, the tin being deposited at a temperature higher than its melting point (tin rheotaxial growth) while the cadmium is deposited at room temperature; the metallic film is slowly oxidized up to a maximum temperature of 520 °C. The XRD analysis shows that the thin films are polycrystalline with preferential (101) and (111) orientations for SnO2 and CdO respectively. Measurements of the thin-film electrical conductance in the presence of various gases show first that these films have a maximum sensitivity, defined as relative percentage variation of conductance, towards NOx and NO2 equal to 10 000 and 4000% respectively at a temperature of 300 °C and 10 ppm gas concentration. At the same temperature the sensitivities towards some gases like CO, CH4, C4H10 and H2, present in an air flow at a 100 ppm concentration, always remains lower than 300%.
[1]
Giorgio Sberveglieri,et al.
LETTER TO THE EDITOR: A new technique for growing large surface area SnO2 thin film (RGTO technique)
,
1990
.
[2]
V. Lantto,et al.
Response studies of some semiconductor gas sensors under different experimental conditions
,
1988
.
[3]
F. Solymosi,et al.
Adsorption and reduction of NO on tin(IV) oxide doped with chromium(III) oxide
,
1978
.
[4]
H. Torvela,et al.
Effect of CH4, SO2 and NO on the CO response of an SnO2-based thick film gas sensor in combustion gases
,
1985
.
[5]
G. Ghiotti,et al.
Surface chemistry and electronic effects of O2, NO and NO/O2 on SnO2
,
1991
.
[6]
Shih-Chia Chang.
Thin-film semiconductor NO x sensor
,
1979
.
[7]
Response to nitrix oxide of thin and thick SnO2 films containing trivalent additives
,
1990
.