Quantitative sampling and analysis of trace elements in atmospheric aerosols: impactor characterization and Synchrotron-XRF mass calibration.

Abstract. Identification of trace elements in ambient air can add substantial information to pollution source apportionment studies, although they do not contribute significantly to emissions in terms of mass. A method for quantitative size and time-resolved trace element evaluation in ambient aerosols with a rotating drum impactor and synchrotron radiation based X-ray fluorescence is presented. The impactor collection efficiency curves and size segregation characteristics were investigated in an experiment with oil and salt particles. Cutoff diameters were determined through the ratio of size distributions measured with two particle sizers. Furthermore, an external calibration technique to empirically link fluorescence intensities to ambient concentrations was developed. Solutions of elemental standards were applied with an ink-jet printer on thin films and area concentrations were subsequently evaluated with external wet chemical methods. These customized and reusable reference standards enable quantification of different data sets analyzed under varying experimental conditions.

[1]  U. Fittschen,et al.  Picoliter droplet deposition using a prototype picoliter pipette: control parameters and application in micro X-ray fluorescence. , 2010, Analytical chemistry.

[2]  Richard J C Brown,et al.  Spatial inhomogeneity of metals in particulate matter on ambient air filters determined by LA-ICP-MS and comparison with acid digestion ICP-MS. , 2009, Journal of environmental monitoring : JEM.

[3]  Eliseo Monfort,et al.  Application of Optimally Scaled Target Factor Analysis for Assessing Source Contribution of Ambient PM10 , 2009, Journal of the Air & Waste Management Association.

[4]  Howard A. Padmore,et al.  The optics beamline at the Swiss Light Source , 2009 .

[5]  P. Siskos,et al.  Assessment of source apportionment by Positive Matrix Factorization analysis on fine and coarse urban aerosol size fractions , 2009 .

[6]  Markus Furger,et al.  Deposition Uniformity and Particle Size Distribution of Ambient Aerosol Collected with a Rotating Drum Impactor , 2009 .

[7]  Daniel Grolimund,et al.  X-ray fluorescence spectrometry for high throughput analysis of atmospheric aerosol samples: The benefits of synchrotron X-rays , 2008 .

[8]  M. Viana,et al.  PM speciation and sources in Mexico during the MILAGRO-2006 Campaign , 2007 .

[9]  G. Falkenberg,et al.  A new technique for the deposition of standard solutions in total reflection X-ray fluorescence spectrometry (TXRF) using pico-droplets generated by inkjet printers and its applicability for aerosol analysis with SR-TXRF ☆ , 2006 .

[10]  J. M. Ondova,et al.  Baltimore Supersite : Highly time-and size-resolved concentrations of urban PM 2 . 5 and its constituents for resolution of sources and immune responses , 2006 .

[11]  P. Hopke,et al.  Baltimore Supersite: Highly time- and size-resolved concentrations of urban PM2.5 and its constituents for resolution of sources and immune responses , 2006 .

[12]  R. Gehrig,et al.  Trace metals in ambient air: Hourly size-segregated mass concentrations determined by synchrotron-XRF. , 2005, Environmental science & technology.

[13]  J. H. Hubbell,et al.  XCOM : Photon Cross Sections Database , 2005 .

[14]  Jin-Seok Han,et al.  Source estimation of anthropogenic aerosols collected by a DRUM sampler during spring of 2002 at Gosan, Korea , 2005 .

[15]  Freddy C. Adams,et al.  Processing of three-dimensional microscopic X-ray fluorescence data , 2004 .

[16]  Roger J. Dejus,et al.  XOP 2.1 - A New Version of the X-ray Optics Software Toolkit , 2004 .

[17]  Virgil A. Marple,et al.  History of Impactors—The First 110 Years , 2004 .

[18]  K. W. Lee,et al.  Design and calibration of a 5-stage cascade impactor (K-JIST cascade impactor) , 2003 .

[19]  R. Vecchi,et al.  Hourly elemental composition and sources identification of fine and coarse PM10 particulate matter in four Italian towns , 2003 .

[20]  Andrzej A. Markowicz,et al.  Handbook of X-Ray Spectrometry , 2002 .

[21]  Jorma Keskinen,et al.  PERFORMANCE EVALUATION OF THE ELECTRICAL LOW-PRESSURE IMPACTOR (ELPI) , 2000 .

[22]  J. Seinfeld,et al.  Atmospheric Chemistry and Physics: From Air Pollution to Climate Change , 1998 .

[23]  J. P. Willis,et al.  Practical XRF Calibration Procedures for Major and Trace Elements , 1996 .

[24]  Kenneth L. Rubow,et al.  A Microorifice Uniform Deposit Impactor (MOUDI): Description, Calibration, and Use , 1991 .

[25]  Thomas A. Cahill,et al.  CALIBRATION STUDIES OF THE DRUM IMPACTOR , 1988 .

[26]  Koen Janssens,et al.  AXIL-PC: software for the analysis of complex X-ray spectra , 1986 .

[27]  M. L. Laucks,et al.  Aerosol Technology Properties, Behavior, and Measurement of Airborne Particles , 2000 .

[28]  A. Berner,et al.  Mass size distributions of traffic aerosols at Vienna , 1980 .

[29]  R. D. Giauque,et al.  Determination of trace elements in light element matrices by x-ray fluorescence spectrometry with incoherent scattered radiation as an internal standard , 1979 .

[30]  N Gochman,et al.  Incorrect least-squares regression coefficients in method-comparison analysis. , 1979, Clinical chemistry.

[31]  J. J. Collins,et al.  Design and evaluation of a new low-pressure impactor. 2 , 1979 .

[32]  Richard C. Flagan,et al.  Design and evaluation of new low-pressure impactor. I , 1978 .

[33]  R. W. Fink,et al.  X-Ray Fluorescence Yields, Auger, and Coster-Kronig Transition Probabilities , 1972 .

[34]  D. Lundgren.  An aerosol sampler for determination of particle concentration as a function of size and time. , 1967, Journal of the Air Pollution Control Association.

[35]  E. Burhop.  Le rendement de fluorescence , 1955 .