论文信息 - Voltage Sensor Fault Detection and Reconfiguration for a Doubly Fed Induction Generator

Voltage Sensor Fault Detection and Reconfiguration for a Doubly Fed Induction Generator

Fault detection and reconfiguration of the control loops of a Doubly-Fed Induction Generator are described in this paper. The stator voltage is measured as well as observed. During fault free operation, the measured signal is used for the field oriented control. In case of a voltage sensor fault, the faulty measurement is identified and the control is reconfigured using the observer output. Operation without measuring the stator voltage is possible. Laboratory measurements prove this concept.

F.W. Fuchs | K. Rothenhagen | S. Thomsen

[1] Thomas Steffen,et al. Control Reconfiguration of Dynamical Systems: Linear Approaches and Structural Tests , 2005 .

[2] Hirofumi Akagi,et al. Control and performance of a doubly-fed induction machine intended for a flywheel energy storage system , 2002 .

[3] R D Lorenz. OBSERVERS AND STATE FILTERS IN DRIVES AND POWER ELECTRONICS , 2002 .

[4] S. Daley,et al. Model based intermittant fault tolerance in an induction motor drive , 1996 .

[5] J. Janning,et al. Analysis of a 300 MW variable speed drive for pump-storage plant applications , 2005, 2005 European Conference on Power Electronics and Applications.

[6] F.W. Fuchs,et al. Analysis of stator voltage observers for a doubly fed induction generator , 2007, 2007 European Conference on Power Electronics and Applications.

[7] Frede Blaabjerg,et al. Overall control strategy of variable speed doubly-fed induction generator wind turbine , 2004 .

[8] Paul M. Frank,et al. Issues of Fault Diagnosis for Dynamic Systems , 2010, Springer London.

[9] Stephen Bennett. Model based methods for sensor fault-tolerant control of rail vehicle traction , 1998 .