论文信息 - Cutting Load Capacity of End Mills with Complex Geometry - 字舞流文

Cutting Load Capacity of End Mills with Complex Geometry

L. Kops | James A. Nemes | Erhan Budak | S. Asamoah-Attiah | L. Kops | E. Budak | J. Nemes | S. Asamoah-Attiah

[1] B. Lawn,et al. Hardness, Toughness, and Brittleness: An Indentation Analysis , 1979 .

[2] Erhan Budak,et al. Improving Productivity and Part Quality in Milling of Titanium Based Impellers by Chatter Suppression and Force Control , 2000 .

[3] Kenichi Kanazawa,et al. Analytical Prediction of Failure in Cemented Carbide End-mill (2nd Report) , 1997 .

[4] Stefan Vichev,et al. Strength calculation of cutting tools , 1994 .

[5] K. Asano,et al. Analytical Prediction of Failure in Cemented Carbide Endmill. , 1994 .

[6] St. Enache,et al. Determination of Tool Cutting Capacity , 1992 .

[7] L. Kops,et al. Determination of the Equivalent Diameter of an End Mill Based on its Compliance , 1990 .

[8] H. Chandrasekaran,et al. Modelling of Tool Stresses in Peripheral Milling , 1988 .

[9] K. Okamura,et al. Analysis of Brittle Failure of Cutting Tools Based on Fracture Mechanics , 1983 .

[10] T. J. Reddy,et al. On the Nature of Cyclic Stresses in the Tool Tip in Peripheral Milling and Their Implications on Tool Fracture , 1982 .

[11] M. C. Shaw,et al. Evaluation of Fracture Strength of Brittle Tools , 1981 .