Power Electronic Converters for Drives

[1]  Eberhart Reimers Power Transfer in DC Chopper Motor Drive , 1981, IEEE Transactions on Industry Applications.

[2]  W. H. Dodson,et al.  Probed determination of turn-on spread of large area thyristors , 1966 .

[3]  Bimal K. Bose,et al.  Power electronics-a technology review , 1992, Proc. IEEE.

[4]  J. D. van Wyk,et al.  Pulsed transformer base drives for high-efficiency high-current low-voltage switches , 1988 .

[5]  E.R.C. da Silva,et al.  A single phase to three phase soft-switched converter, isolated and with active input current shaping , 1995, Proceedings of PESC '95 - Power Electronics Specialist Conference.

[6]  Ashoka K. S. Bhat,et al.  A UNIFIED APPROACH TO CHARACTERIZATION OF PWM AND QUASI-PWM SWITCHING CONVERTERS : TOPOLOGICAL CONSTRAINTS, CLASSIFICATION AND SYNTHESIS A.K.S. Bhat, Senior Member IEEE, , 1989 .

[7]  Johann W. Kolar,et al.  New Lossless Turn-On and Turn-Off (Snubber) Networks for Inverters, Including Circuits for Blocking Voltage Limitation , 1986, IEEE Transactions on Power Electronics.

[8]  J. Vitins,et al.  Protection of thyristors against overvoltage with breakover diodes , 1988 .

[9]  Koosuke Harada,et al.  Common-Mode Noise Generation in a DC-to-DC Converter , 1980, IEEE Transactions on Aerospace and Electronic Systems.

[10]  R. P. Stratford,et al.  Harmonic Pollution on Power Systems - A Change in Philosophy , 1980, IEEE Transactions on Industry Applications.

[11]  H. Tunia,et al.  Surge Suppressor's Design by means of Nomograms , 1977 .

[12]  Timothy M. Crnko Current-Limiting Fuse Update - New Style Fuse for Protection of Semiconductor Devices , 1979, IEEE Transactions on Industry Applications.

[13]  Deepak Divan,et al.  The Resonant DC Link Converter--A New Concept in Static Power Conversion , 1986, 1986 Annual Meeting Industry Applications Society.

[14]  J. D. van Wyk,et al.  Optimum Nonlinear Turn-Off Snubbers: Design and Application , 1986, 1986 Annual Meeting Industry Applications Society.

[15]  H. Stemmler,et al.  Configurations of high-power voltage source inverter drives , 2002 .

[16]  T. Habetler,et al.  Acoustic noise reduction in sinusoidal PWM drives using a randomly modulated carrier , 1989 .

[17]  A. Ueda,et al.  Stabilizing control method for suppressing oscillations of induction motors driven by PWM inverters , 1990 .

[18]  Bimal K. Bose Recent advances in power electronics , 1992 .

[19]  William Shepherd,et al.  A Speed and Power Factor Controller for Small Three-Phase Induction Motors , 1984, IEEE Transactions on Industry Applications.

[20]  Thomas A. Lipo,et al.  Recent progress in the development in solid-state AC motor drives , 1988 .

[21]  A. L. Mohamadein,et al.  Microprocessor based harmonic elimination in chopper type AC voltage regulators , 1990 .

[22]  H. Stemmler High-power industrial drives , 1994 .

[23]  S. Hinchliffe,et al.  High frequency switching of power MOSFETs , 1988 .

[24]  W. Mcmurray,et al.  Modulation of the Chopping Frequency in DC Choppers and PWM Inverters Having Current-Hysteresis Controllers , 1983, IEEE Transactions on Industry Applications.

[25]  Robert L. Steigerwald,et al.  A DC Motor Control System for Electric Vehicle Drive , 1978, IEEE Transactions on Industry Applications.

[26]  Bogdan Sapiński,et al.  Analysis of phase-controlled converters for induction motors , 1990 .

[27]  C.L. Neft,et al.  Theory and design of a 30-hp matrix converter , 1988, Conference Record of the 1988 IEEE Industry Applications Society Annual Meeting.

[28]  E. T. Calkin,et al.  Circuit Techniques for Improving the Switching Loci of Transistor Switches in Switching Regulators , 1976, IEEE Transactions on Industry Applications.

[29]  Richard Redlt Invited paper. Power-factor correction in single-phase switching-mode power supplies—an overview , 1994 .

[30]  P. Enjeti,et al.  A new single phase to three phase converter with active input current shaping for low cost AC motor drives , 1990, Conference Record of the 1990 IEEE Industry Applications Society Annual Meeting.

[31]  M. Ishida,et al.  New single-phase unity power factor PWM converter-inverter system , 1989, 20th Annual IEEE Power Electronics Specialists Conference.

[32]  Th. Wasserrab Schaltungslehre der Stromrichtertechnik , 1962 .

[33]  Bimal K. Bose,et al.  Power electronics-an emerging technology , 1989 .

[34]  Marco Venturini,et al.  The generalised transformer: A new bidirectional, sinusoidal waveform frequency converter with continuously adjustable input power factor , 1980, 1980 IEEE Power Electronics Specialists Conference.

[35]  W. F. Wirth High-speed snubberless operation of GTOs using a new gate drive technique , 1988 .

[36]  A. Ackva,et al.  Kurzschlussfestigkeit und systemeigene Sicherheit durch optimale Ansteuerung: eine Treiberstufe für Bipolartransistoren und IGBT im Vergleich , 1990 .

[37]  Fred C. Lee,et al.  High-frequency quasi-resonant converter technologies , 1988, Proc. IEEE.

[38]  J. D. van Wyk,et al.  Power electronic converters for motion control , 1994, Proc. IEEE.

[39]  M. Grotzbach,et al.  Simplified predetermination of line current harmonics , 1995 .

[40]  J.D. van Wyk,et al.  A high density three phase high frequency link system for variable frequency output , 1989, Conference Record of the IEEE Industry Applications Society Annual Meeting,.

[41]  Mitsuyuki Hombu,et al.  A Current Source GTO Inverter with Sinusoidal Inputs and Outputs , 1987, IEEE Transactions on Industry Applications.

[42]  G. D. Bergman The gate-triggered turn-on process in thyristors , 1965 .

[43]  J.D. van Wyk,et al.  A high frequency link system with self-oscillating inverter and direct converter using ZTOs , 1988, Conference Record of the 1988 IEEE Industry Applications Society Annual Meeting.

[44]  C. G. Steyn Analysis and optimization of regenerative linear snubbers , 1989 .

[45]  T.A. Lipo,et al.  Design and performance of a high frequency link induction motor drive operating at unity power factor , 1988, Conference Record of the 1988 IEEE Industry Applications Society Annual Meeting.

[46]  J. Appelbaum,et al.  A.C. voltage regulation by means of chopper circuits , 1968 .

[47]  Thomas A. Lipo,et al.  A Quantitative Analysis of Induction Motor Performance Improvement by SCR Voltage Control , 1983 .

[48]  Joachim Holtz,et al.  High-efficiency dual transistor base drive circuit based on the Cuk converter topology , 1991 .

[49]  Muneaki Ishida,et al.  Stability of current‐source induction‐motor drive system , 1978 .

[50]  E. E. Ward Invertor suitable for operation over a range of frequency , 1964 .

[51]  A. Emanuel-Eigeles,et al.  Analyse einer Regelungsschaltung für Wechselstromspannungen mittels Steller , 1970 .

[52]  G. K. Dubey,et al.  A comparative study of some chopper commutation circuits , 1982 .

[53]  O. D. Patterson,et al.  Pseudo-resonant full bridge DC/DC converter , 1987 .

[54]  C.K. Duffey,et al.  Update of harmonic standard IEEE-519-IEEE Recommended Practices and Requirements for Harmonic Control in Electric Power Systems , 1989, Conference Record of the IEEE Industry Applications Society Annual Meeting,.

[55]  A. U. DUBHASHl,et al.  Power transistor protection schemes , 1985 .

[56]  J. D. van Wyk,et al.  Transformer-coupled direct base drive technology for high-power, high-voltage, bipolar transistor PWM converters , 1989 .

[57]  J. D. van Wyk,et al.  Analysis and optimization of regenerative linear snubbers applied to switches with voltage and current tails , 1994 .

[58]  J.D. van Wyk,et al.  A high performance gate/base drive using a current source , 1990, Conference Record of the 1990 IEEE Industry Applications Society Annual Meeting.

[59]  Deepak Divan,et al.  Zero-switching-loss inverters for high-power applications , 1989 .

[60]  Joseph Vithayathil,et al.  DC Link Filter Design Considerations in Three-Phase Voltage Source Inverter-Fed Induction Motor Drive System , 1987, IEEE Transactions on Industry Applications.

[61]  S.R. Bowes Advanced regular-sampled PWM control techniques for drives and static power converters , 1995, IEEE Trans. Ind. Electron..

[62]  S.K. Biswas,et al.  Some aspects in the design of discrete MOS-bipolar Darlington power switches , 1989, Conference Record of the IEEE Industry Applications Society Annual Meeting,.

[63]  H. Matsuo,et al.  A new gate amplifier for high power GTO thyristors , 1991, PESC '91 Record 22nd Annual IEEE Power Electronics Specialists Conference.

[64]  Angelo Ferraro,et al.  An overview of low-loss snubber technology for transistor converters , 1982, 1982 IEEE Power Electronics Specialists conference.

[65]  M. S. Erlicki,et al.  Switching drive of induction motors , 1963 .

[66]  Mitsuyuki Hombu,et al.  A New Current Source GTO Inverter with Sinusoidal Output Voltage and Current , 1985, IEEE Transactions on Industry Applications.

[67]  J. Ben Klaassens,et al.  A Controllable 45-kW Current Source for DC Machines , 1979, IEEE Transactions on Industry Applications.

[68]  Kenneth P. Phillips Current-Source Converter for AC Motor Drives , 1972 .

[69]  P. D. Evans,et al.  High frequency inductor design concepts , 1991, PESC '91 Record 22nd Annual IEEE Power Electronics Specialists Conference.

[70]  Jerry L. Hudgins,et al.  Gating Effects on Thyristor Anode Current di/dt , 1987, IEEE Transactions on Power Electronics.

[71]  Philip C. Jacobs Fuse Application to Solid-State Motor and Power Control , 1966 .

[72]  Alexander Eigeles Emanuel,et al.  A Simplified Dual Cycloconverter , 1981, IEEE Transactions on Industrial Electronics and Control Instrumentation.

[73]  Koosuke Harada,et al.  On the Effective Turn-Off of GTO by a Small Saturable Core , 1987, IEEE Transactions on Power Electronics.

[74]  D.M. Divan,et al.  A three-phase soft-switched high power density DC/DC converter for high power applications , 1988, Conference Record of the 1988 IEEE Industry Applications Society Annual Meeting.

[75]  R.W. De Doncker,et al.  The auxiliary resonant commutated pole converter , 1990, Conference Record of the 1990 IEEE Industry Applications Society Annual Meeting.

[76]  Donald W. Novotny,et al.  Current Control of VSI-PWM Inverters , 1985, IEEE Transactions on Industry Applications.

[77]  Bantval J. Baliga,et al.  Power semiconductor devices for variable-frequency drives , 1994, Proc. IEEE.

[78]  H. Harders,et al.  Pendelmomententwicklung bei der stromrichtergespeisten Asynchronmaschine mit Berücksichtigung des welligen Zwischenkreisstroms , 1982 .

[79]  Jacobus Daniel van Wyk,et al.  A Comparative Investigation of a Three-Phase Induction Machine Drive with a Component Minimized Voltage-Fed Inverter under Different Control Options , 1984 .

[80]  A.R. Hefner An investigation of the drive circuit requirements for the power insulated gate bipolar transistor (IGBT) , 1990, 21st Annual IEEE Conference on Power Electronics Specialists.

[81]  Tore Undeland,et al.  A snubber configuration for both poker transistors and GTO PHH inverters , 1984, 1984 IEEE Power Electronics Specialists Conference.

[82]  Paresh C. Sen,et al.  Effect of Gate-Drive Circuits on GTO Thyristor Characteristics , 1986, IEEE Transactions on Industrial Electronics.

[83]  S. A. Hamed Steady-state modeling, analysis, and performance of transistor-controlled AC power conditioning systems , 1990 .

[84]  Jerry L. Hudgins,et al.  High di/dt Pulse Switching of Thyristors , 1987, IEEE Transactions on Power Electronics.