Transition Effects on Heating in the Wake of a Blunt Body

A series of aerodynamic heating tests was conducted on a 70-deg sphere-cone planetary entry vehicle model in a Mach 10 perfect-gas wind tunnel at freestream Reynolds numbers based on diameter of 8.23x104 to 3.15x105. Surface heating distributions were determined from temperature time-histories measured on the model and on its support sting using thin-film resistance gages. The experimental heating data were compared to computations made using an axisymmetric/2D, laminar, perfect-gas Navier-Stokes solver. Agreement between computational and experimental heating distributions to within, or slightly greater than, the experimental uncertainty was obtained on the forebody and afterbody of the entry vehicle as well as on the sting upstream of the free-shear-layer reattachment point. However, the distributions began to diverge near the reattachment point, with the experimental heating becoming increasingly greater than the computed heating with distance downstream from the reattachment point. It was concluded that this divergence was due to transition of the wake free shear layer just upstream of the reattachment point on the sting.

[1]  Thomas J. Horvath,et al.  Experimental and computational studies of the flow over a sting mounted planetary probe configuration , 1997 .

[2]  R. L. Sorenson,et al.  Automatic mesh-point clustering near a boundary in grid generation with elliptic partial differential equations , 1979 .

[3]  Graham V. Candler,et al.  Computation of weakly ionized hypersonic flows in thermochemical nonequilibrium , 1991 .

[4]  J. H. Thomas,et al.  Blunt Body Near Wake Flow Field at Mach 10 , 1997 .

[5]  T. V. Jones,et al.  Heat-transfer measurements in short-duration hypersonic facilities , 1973 .

[6]  Brian R. Hollis,et al.  High-Enthalpy Aerothermodynamics of a Mars Entry Vehicle Part 1: Experimental Results , 1997 .

[7]  S. Zeiberg.  Transition correlations for hypersonic wakes , 1964 .

[8]  Graham V. Candler,et al.  The solution of the Navier-Stokes equations using Gauss-Seidel line relaxation , 1989 .

[9]  John Micol,et al.  Hypersonic aerodynamic/aerothermodynamic testing capabilities at Langley Research Center - Aerothermodynamic Facilities Complex , 1995 .

[10]  E. R. Hedlund,et al.  Heat Transfer Testing in the NSWC Hypervelocity Wind Tunnel Utilizing Co-Axial Surface Thermocouples , 1980 .

[11]  Joe F. Thompson,et al.  Automatic numerical generation of body-fitted curvilinear coordinate system for field containing any number of arbitrary two-dimensional bodies , 1974 .

[12]  Brian R. Hollis,et al.  High-Enthalpy Aerothermodynamics of a Mars Entry Vehicle Part 2: Computational Results , 1997 .

[13]  Michael Gallis,et al.  Comparison of computations and experiments for nonequilibrium flow expansions around a blunted cone , 1996 .

[14]  J Alter Stephen.  The Volume Grid Manipulator (VGM): A Grid Reusability Tool , 1997 .

[15]  Peter A. Gnoffo,et al.  Heating analysis for a Lunar Transfer Vehicle at near-equilibrium flow conditions , 1993 .

[16]  G. Bird.  Molecular Gas Dynamics and the Direct Simulation of Gas Flows , 1994 .

[17]  L. Lees.  Hypersonic wakes and trails , 1964 .

[18]  Peter A. Gnoffo,et al.  Wake flow about a MESUR Mars entry vehicle , 1994 .

[19]  E. Venkatapathy,et al.  Mars Pathfinder computations including base-heating predictions , 1995 .

[20]  Michael Holden,et al.  Calibration, validation, and evaluation studies in the LENS facility , 1995 .

[21]  R Hollis Brian,et al.  Experimental and Computational Aerothermodynamics of a Mars Entry Vehicle , 1996 .

[22]  David Hash,et al.  Comparison of DSMC and experimental results for hypersonic external flows , 1995 .

[23]  Edward H. Schulte,et al.  Semiconductor Surface Thermocouples for Determining Heat-Transfer Rates , 1967, IEEE Transactions on Aerospace and Electronic Systems.

[24]  Brian R. Hollis,et al.  HIGH-ENTHALPY AND PERFECT-GAS HEATING MEASUREMENTS ON A BLUNT CONE , 1996 .