Determining the optimal PDMS–PDMS bonding technique for microfluidic devices

A number of polydimethysiloxane (PDMS) bonding techniques have been reported in the literature over the last several years as the focus on multilayer PDMS microfluidic devices has increased. Oxygen plasma bonding, despite cost, additional fabrication time and inconsistent bonding results, has remained a widely used method for bonding PDMS layers. A comparative study of four rapid, inexpensive alternative PDMS?PDMS bonding approaches was undertaken to determine relative bond strength. These include corona discharge, partial curing, cross-linker variation and uncured PDMS adhesive. Partial curing and uncured PDMS adhesive demonstrated a considerable improvement in bond strength and consistency by retaining average bond strengths of over 600 kPa, which was more than double the average bond strength of oxygen plasma. A description of each technique and their performance relative to oxygen plasma bonding is included.

[1]  S. Quake,et al.  Monolithic microfabricated valves and pumps by multilayer soft lithography. , 2000, Science.

[2]  Bruce K. Gale,et al.  A PDMS-based gas permeation pump for on-chip fluid handling in microfluidic devices , 2006 .

[3]  Jeung Sang Go,et al.  A disposable, dead volume-free and leak-free in-plane PDMS microvalve☆ , 2004 .

[4]  C. Effenhauser,et al.  Integrated capillary electrophoresis on flexible silicone microdevices:  analysis of DNA restriction fragments and detection of single DNA molecules on microchips. , 1997, Analytical chemistry.

[5]  D. Beebe,et al.  PDMS bonding by means of a portable, low-cost corona system. , 2006, Lab on a chip.

[6]  D. Bartholomeusz,et al.  Xurography: rapid prototyping of microstructures using a cutting plotter , 2005, Journal of Microelectromechanical Systems.

[7]  G. Whitesides,et al.  Rapid prototyping of microfluidic switches in poly(dimethyl siloxane) and their actuation by electro-osmotic flow , 1999 .

[8]  Göran Stemme,et al.  The fabrication of microfluidic structures by means of full-wafer adhesive bonding using a poly(dimethylsiloxane) catalyst , 2007 .

[9]  A. Majumdar,et al.  Stamp-and-stick room-temperature bonding technique for microdevices , 2005, Journal of Microelectromechanical Systems.

[10]  J. Berg,et al.  Studies on surface wettability of poly(dimethyl) siloxane (PDMS) and glass under oxygen-plasma treatment and correlation with bond strength , 2005, Journal of Microelectromechanical Systems.

[11]  G. Whitesides,et al.  Rapid Prototyping of Microfluidic Systems in Poly(dimethylsiloxane). , 1998, Analytical chemistry.