Maximum Achievable Efficiency in Near-Field Coupled Power-Transfer Systems

Wireless power transfer is commonly realized by means of near-field inductive coupling and is critical to many existing and emerging applications in biomedical engineering. This paper presents a closed form analytical solution for the optimum load that achieves the maximum possible power efficiency under arbitrary input impedance conditions based on the general two-port parameters of the network. The two-port approach allows one to predict the power transfer efficiency at any frequency, any type of coil geometry and through any type of media surrounding the coils. Moreover, the results are applicable to any form of passive power transfer such as provided by inductive or capacitive coupling. Our results generalize several well-known special cases. The formulation allows the design of an optimized wireless power transfer link through biological media using readily available EM simulation software. The proposed method effectively decouples the design of the inductive coupling two-port from the problem of loading and power amplifier design. Several case studies are provided for typical applications.

[1]  J Olivo,et al.  Energy Harvesting and Remote Powering for Implantable Biosensors , 2011, IEEE Sensors Journal.

[2]  R.R. Harrison,et al.  A Low-Power Integrated Circuit for a Wireless 100-Electrode Neural Recording System , 2006, IEEE Journal of Solid-State Circuits.

[3]  Maysam Ghovanloo,et al.  An Inductively Powered Scalable 32-Channel Wireless Neural Recording System-on-a-Chip for Neuroscience Applications , 2010, IEEE Transactions on Biomedical Circuits and Systems.

[4]  Stephen O'Driscoll.  Adaptive signal acquisition and power delivery for implanted medical devices , 2009 .

[5]  Charles Polk,et al.  CRC Handbook of Biological Effects of Electromagnetic Fields , 1986 .

[6]  Teresa H. Y. Meng,et al.  A mm-sized implantable power receiver with adaptive link compensation , 2009, 2009 IEEE International Solid-State Circuits Conference - Digest of Technical Papers.

[7]  Clemens Zierhofer,et al.  Coil design for improved power transfer efficiency in inductive links , 1996, Proceedings of 18th Annual International Conference of the IEEE Engineering in Medicine and Biology Society.

[8]  Mohamad Sawan,et al.  High-Speed OQPSK and Efficient Power Transfer Through Inductive Link for Biomedical Implants , 2010, IEEE Transactions on Biomedical Circuits and Systems.

[9]  Maysam Ghovanloo,et al.  An inductively powered scalable 32-channel wireless neural recording system-on-a-chip for neuroscience applications , 2010, 2010 IEEE International Solid-State Circuits Conference - (ISSCC).

[10]  Jun-Bo Yoon,et al.  CMOS-compatible surface-micromachined suspended-spiral inductors for multi-GHz silicon RF ICs , 2002, IEEE Electron Device Letters.

[11]  Wentai Liu,et al.  Design and analysis of an adaptive transcutaneous power telemetry for biomedical implants , 2005, IEEE Transactions on Circuits and Systems I: Regular Papers.

[12]  S. Kotani,et al.  A subnanosecond Josephson 16-bit ALU , 1988 .

[13]  Sérgio Francisco Pichorim,et al.  Design of coils for millimeter- and submillimeter-sized biotelemetry , 2004, IEEE Transactions on Biomedical Engineering.

[14]  Maysam Ghovanloo,et al.  Modeling and Optimization of Printed Spiral Coils in Air, Saline, and Muscle Tissue Environments , 2009, IEEE Transactions on Biomedical Circuits and Systems.

[15]  Luca Benini,et al.  Load optimization of an inductive power link for remote powering of biomedical implants , 2009, 2009 IEEE International Symposium on Circuits and Systems.

[16]  Reid R. Harrison,et al.  Designing Efficient Inductive Power Links for Implantable Devices , 2007, 2007 IEEE International Symposium on Circuits and Systems.

[17]  F. De Flaviis,et al.  A UHF Near-Field RFID System With Fully Integrated Transponder , 2008, IEEE Transactions on Microwave Theory and Techniques.

[18]  R. Castello,et al.  A 1.3 GHz low-phase noise fully tunable CMOS LC VCO , 2000, IEEE Journal of Solid-State Circuits.

[19]  R. White,et al.  A Wide-Band Efficient Inductive Transdennal Power and Data Link with Coupling Insensitive Gain , 1987, IEEE Transactions on Biomedical Engineering.

[20]  P. Glenn Gulak,et al.  Integrated CMOS wireless power transfer for neural implants , 2011, 2011 IEEE Biomedical Circuits and Systems Conference (BioCAS).

[21]  R. W. Lau,et al.  The dielectric properties of biological tissues: II. Measurements in the frequency range 10 Hz to 20 GHz. , 1996, Physics in medicine and biology.

[22]  Thomas H. Lee,et al.  The Design of CMOS Radio-Frequency Integrated Circuits: RF CIRCUITS THROUGH THE AGES , 2003 .

[23]  Shahriar Mirabbasi,et al.  Design and Optimization of Resonance-Based Efficient Wireless Power Delivery Systems for Biomedical Implants , 2011, IEEE Transactions on Biomedical Circuits and Systems.

[24]  Gert Cauwenberghs,et al.  Power harvesting and telemetry in CMOS for implanted devices , 2004, IEEE Transactions on Circuits and Systems I: Regular Papers.

[25]  P. Vaillancourt,et al.  EM radiation behavior upon biological tissues in a radio-frequency power transfer link for a cortical visual implant , 1997, Proceedings of the 19th Annual International Conference of the IEEE Engineering in Medicine and Biology Society. 'Magnificent Milestones and Emerging Opportunities in Medical Engineering' (Cat. No.97CH36136).

[26]  Maysam Ghovanloo,et al.  Design and Optimization of Printed Spiral Coils for Efficient Transcutaneous Inductive Power Transmission , 2007, IEEE Transactions on Biomedical Circuits and Systems.

[27]  W. Ko,et al.  Design of radio-frequency powered coils for implant instruments , 1977, Medical and Biological Engineering and Computing.

[28]  C.M. Zierhofer,et al.  Geometric approach for coupling enhancement of magnetically coupled coils , 1996, IEEE Transactions on Biomedical Engineering.

[29]  Erwin S. Hochmair,et al.  System Optimization for Improved Accuracy in Transcutaneous Signal and Power Transmission , 1984, IEEE Transactions on Biomedical Engineering.

[30]  M. Soljačić,et al.  Wireless Power Transfer via Strongly Coupled Magnetic Resonances , 2007, Science.

[31]  Klaus Finkenzeller,et al.  Book Reviews: RFID Handbook: Fundamentals and Applications in Contactless Smart Cards and Identification, 2nd ed. , 2004, ACM Queue.

[32]  T. Meng,et al.  Optimal Frequency for Wireless Power Transmission Into Dispersive Tissue , 2010, IEEE Transactions on Antennas and Propagation.

[33]  Rahul Sarpeshkar,et al.  Feedback Analysis and Design of RF Power Links for Low-Power Bionic Systems , 2007, IEEE Transactions on Biomedical Circuits and Systems.

[34]  K. Najafi,et al.  A Modular 32-site wireless neural stimulation microsystem , 2004, IEEE Journal of Solid-State Circuits.

[35]  R. W. Lau,et al.  The dielectric properties of biological tissues: III. Parametric models for the dielectric spectrum of tissues. , 1996, Physics in medicine and biology.

[36]  Brian Ellis.  The Design of CMOS Radio-Frequency Integrated Circuits , 2004 .

[37]  K. Fotopoulou,et al.  Wireless Power Transfer in Loosely Coupled Links: Coil Misalignment Model , 2011, IEEE Transactions on Magnetics.

[38]  C. Dehollain,et al.  Improvement of power efficiency of inductive links for implantable devices , 2008, 2008 Ph.D. Research in Microelectronics and Electronics.

[39]  Maysam Ghovanloo,et al.  Wideband Near-Field Data Transmission Using Pulse Harmonic Modulation , 2011, IEEE Transactions on Circuits and Systems I: Regular Papers.