The results do mesh

This article considers the effects of open-circuited phase windings and of shorted coil turns of the stator winding on the operation of the induction machine. The analysis and comparison of faulted modes of operation is achieved by simulation, using the dynamic mesh reluctance model (DMRM) approach. The DMRM approach gives valuable insight of induction motor detection of the faulted windings. Clearly, five-phase motors with third harmonic control give the best performance for machines with one-phase open circuit, and careful machine design can minimize adverse effects of torque ripple

[1]  H. G. Sedding,et al.  Current monitoring for detecting inter-turn short circuits in induction motors , 2001 .

[2]  Thomas A. Lipo,et al.  VSI-PWM rectifier/inverter system with a reduced switch count , 1995, IAS '95. Conference Record of the 1995 IEEE Industry Applications Conference Thirtieth IAS Annual Meeting.

[3]  Jafar Milimonfared,et al.  Interbar currents and axial fluxes in healthy and faulty induction motors , 2002 .

[4]  J. Penman,et al.  Detection and location of interturn short circuits in the stator windings of operating motors , 1994 .

[5]  V. Ostovic,et al.  A Simplified Approach to Magnetic Equivalent Circuit Modelling of Induction Machines , 1986, 1986 Annual Meeting Industry Applications Society.

[6]  Gojko Joksimovic,et al.  The detection of inter-turn short circuits in the stator windings of operating motors , 2000, IEEE Trans. Ind. Electron..

[7]  T.A. Lipo,et al.  Multiple coupled circuit modeling of induction machines , 1993, Conference Record of the 1993 IEEE Industry Applications Conference Twenty-Eighth IAS Annual Meeting.

[8]  A. Cardoso,et al.  Diagnosis of stator inter-turn short circuits in DTC induction motor drives , 2004, IEEE Transactions on Industry Applications.

[9]  Hamid A. Toliyat,et al.  Modeling and control of a five-phase series-connected two-motor drive , 2003, IECON'03. 29th Annual Conference of the IEEE Industrial Electronics Society (IEEE Cat. No.03CH37468).

[10]  T.A. Lipo,et al.  A strategy for improving reliability of field oriented controlled induction motor drives , 1991, Conference Record of the 1991 IEEE Industry Applications Society Annual Meeting.

[11]  Mark Sumner,et al.  Evaluation of a vector controlled induction motor drive using the dynamic magnetic circuit model , 2003, 38th IAS Annual Meeting on Conference Record of the Industry Applications Conference, 2003..

[12]  T.A. Lipo,et al.  Fault tolerant three-phase AC motor drive topologies: a comparison of features, cost, and limitations , 2003, IEEE Transactions on Power Electronics.

[13]  Hamid A. Toliyat,et al.  New developments in the diagnosis of faults in line-connected and direct torque controlled induction motors , 2003, IECON'03. 29th Annual Conference of the IEEE Industrial Electronics Society (IEEE Cat. No.03CH37468).

[14]  A. Consoli,et al.  An improved model of saturated induction machines , 1988, Conference Record of the 1988 IEEE Industry Applications Society Annual Meeting.

[15]  Hamid A. Toliyat,et al.  Transient analysis of cage induction machines under stator, rotor bar and end ring faults , 1995 .

[16]  J. Haylock,et al.  A comparative study of permanent magnet and switched reluctance motors for high performance fault tolerant applications , 1995, IAS '95. Conference Record of the 1995 IEEE Industry Applications Conference Thirtieth IAS Annual Meeting.

[17]  Hamid A. Toliyat,et al.  Rotor field oriented control of five-phase induction motor with the combined fundamental and third harmonic currents , 2001, APEC 2001. Sixteenth Annual IEEE Applied Power Electronics Conference and Exposition (Cat. No.01CH37181).

[18]  J. Haylock,et al.  Operation of fault tolerant machines with winding failures , 1997, 1997 IEEE International Electric Machines and Drives Conference Record.

[19]  Hamid A. Toliyat,et al.  Analysis and simulation of five-phase variable-speed induction motor drives under asymmetrical connections , 1998 .

[20]  Gordon R. Slemon.  An equivalent circuit approach to analysis of synchronous machines with saliency and saturation , 1990 .

[21]  K. J. Bradley,et al.  Reluctance mesh modelling of induction motors with healthy and faulty rotors , 1996, IAS '96. Conference Record of the 1996 IEEE Industry Applications Conference Thirty-First IAS Annual Meeting.

[22]  Thomas M. Jahns,et al.  IPM synchronous machine drive response to a single-phase open circuit fault , 2002 .

[23]  V. Ostović.  A Method for Evaluation of Transient and Steady State Performance in Saturated Squirrel Cage Induction Machines , 1986, IEEE Transactions on Energy Conversion.