论文信息 - Mixed-mode operation of boost switch-mode rectifier for wide range of load variations

Mixed-mode operation of boost switch-mode rectifier for wide range of load variations

A mixed-mode input current sensorless predictive current control at constant but two different switching frequencies for a single-phase boost type switch-mode rectifier (SMR) with single switch topology is proposed. The SMR operates in continuous input current mode (CCM) or in discontinuous input current mode (DCM) depending upon the load. This load dependent operating mode selection avoids the operation of the SMR in the dual mode, where the input current harmonic distortion is maximum. The closed loop output voltage regulation is achieved without the need of an input current sensor. The control scheme is optimized to result in an economic size of the boost inductor along with the compliance of IEC 1000-3-2 harmonic limits for input current.

[1] Phoivos D. Ziogas,et al. A novel active current waveshaping technique for solid-state input power factor conditioners , 1991 .

[2] G. Joos,et al. Programmable input power factor correction methods for single phase diode rectifier circuits , 1990, Fifth Annual Proceedings on Applied Power Electronics Conference and Exposition.

[3] K. Natarajan,et al. Control of power factor correcting boost converter without instantaneous measurement of input current , 1995 .

[4] Jing Wang,et al. Modified boost converter with continuous inductor current mode and ripple free input current , 1996, PESC Record. 27th Annual IEEE Power Electronics Specialists Conference.

[5] Manjusha Dawande,et al. Bang-bang current control with predecided switching frequency for switch-mode rectifiers , 1999, IEEE Trans. Ind. Electron..

[6] Simone Buso,et al. Conducted EMI issues in a 600-W single-phase boost PFC design , 2000 .

[7] G. K. Dubey,et al. Programmable input power factor correction method for switch-mode rectifiers , 1996 .

[8] N. Mohan,et al. A digitally controlled AC to DC power conditioner that draws sinusoidal input current , 1986, 1986 17th Annual IEEE Power Electronics Specialists Conference.

[9] Jose A. Cobos,et al. The determination of the boundaries between continuous and discontinuous conduction modes in PWM DC-to-DC converters used as power factor preregulators , 1992 .