A Semi-Empirical Model for Tilted-Gun Planar Magnetron Sputtering Accounting for Chimney Shadowing

Integrated computational materials engineering (ICME) approaches to composition and thickness profiles of sputtered thin-film samples are the key to expediting materials exploration for these materials. Here, an ICME-based semi-empirical approach to modeling the thickness of thin-film samples deposited via magnetron sputtering is developed. Using Yamamura’s dimensionless differential angular sputtering yield and a measured deposition rate at a point in space for a single experimental condition, the model predicts the deposition profile from planar DC sputtering sources. The model includes corrections for off-center, tilted gun geometries as well as shadowing effects from gun chimneys used in most state-of-the-art sputtering systems. The modeling algorithm was validated by comparing its results with experimental deposition rates obtained from a sputtering system utilizing sources with a multi-piece chimney assembly that consists of a lower ground shield and a removable gas chimney. Simulations were performed for gun-tilts ranging from 0° to 31.3° from the vertical with and without the gas chimney installed. The results for the predicted and experimental angular dependence of the sputtering deposition rate were found to have an average magnitude of relative error of $$ 4.14\% \pm 3.02\% $$4.14%±3.02% for a 0°–31.3° gun-tilt range without the gas chimney, and $$ 2.12\% \pm 1.71\% $$2.12%±1.71% for a 17.7°–31.3° gun-tilt range with the gas chimney. The continuum nature of the model renders this approach reverse-optimizable, providing a rapid tool for assisting in the understanding of the synthesis-composition-property space of novel materials.

[1]  A. Gras-marti,et al.  Evolution towards thermalization, and diffusion, of sputtered particle fluxes: Spatial profiles , 1984 .

[2]  Ning Li,et al.  Magnetic recording on FePt and FePtB intermetallic compound media , 1999 .

[3]  Krishna Rajan,et al.  Combinatorial and high-throughput screening of materials libraries: review of state of the art. , 2011, ACS combinatorial science.

[4]  J. Szczyrbowski,et al.  Antireflective coatings on large scale substrates produced by reactive twin-magnetron sputtering , 1997 .

[5]  K. Kao,et al.  PIEZOELECTRIC, DIELECTRIC, AND INTERFACIAL PROPERTIES OF ALUMINUM NITRIDE FILMS , 1998 .

[6]  F. Rosei,et al.  Packing-induced electronic structure changes in bundled single-wall carbon nanotubes , 2005 .

[7]  T. Terai,et al.  INVESTIGATION ON NITROGENATED DLC FILMS FOR ANTI-REFLECTION COATING APPLICATION , 2002 .

[8]  A. Gras-marti,et al.  Slowing down and thermalization of sputtered particle fluxes: Energy distributions , 1983 .

[9]  R. V. Dover,et al.  Combinatorial investigation of magnetostriction in Fe–Ga and Fe–Ga–Al , 2008 .

[10]  Y. Yamamura.  Contribution of anisotropic velocity distribution of recoil atoms to sputtering yields and angular distributions of sputtered atoms , 1981 .

[11]  Min-Hsiung Hon,et al.  The effects of thickness and operation temperature on ZnO:Al thin film CO gas sensor , 2002 .

[12]  Piers R. F. Barnes,et al.  Enhancement of Photoelectrochemical Hydrogen Production from Hematite Thin Films by the Introduction of Ti and Si , 2007 .

[13]  C. Canal,et al.  Preparation of metal (W, Mo, Nb, Ti) containing a-C:H films by reactive magnetron sputtering , 2003 .

[14]  M. W. Thompson.  II. The energy spectrum of ejected atoms during the high energy sputtering of gold , 1968 .

[15]  Yoshinori Hatanaka,et al.  Ga2O3 thin film for oxygen sensor at high temperature , 2001 .

[16]  W. Maier,et al.  Combinatorial and high-throughput materials science. , 2007, Angewandte Chemie.

[17]  P. Frach,et al.  Numerical modelling of charged particle motion in electric and magnetic fields to assist magnetron design , 1997 .

[18]  X. Q. Meng,et al.  A new formula on the thickness of films deposited by planar and cylindrical magnetron sputtering , 1998 .

[19]  P. Sigmund.  Recollections of fifty years with sputtering , 2012 .

[20]  Yusuke Taki,et al.  Film structure and optical constants of magnetron-sputtered fluoride films for deep ultraviolet lithography , 2004 .

[21]  N. Itoh,et al.  A semiempirical formula for the energy dependence of the sputtering yield , 1981 .

[22]  P. Sigmund.  Theory of Sputtering. I. Sputtering Yield of Amorphous and Polycrystalline Targets , 1969 .

[23]  P. Fournier,et al.  Angular distribution of sputtered particles and surface morphology: the case of beryllium under a krypton beam at various incidences , 2005 .

[24]  Jae Koo Lee,et al.  Modeling of magnetron sputtering plasmas , 2002 .

[25]  Apurva Mehta,et al.  Giant magnetostriction in annealed Co(1-x)Fe(x) thin-films. , 2011, Nature communications.

[26]  Sylvain Fourmaux,et al.  Grain size effect on the semiconductor-metal phase transition characteristics of magnetron-sputtered VO2 thin films , 2005 .

[27]  J. Hattrick-Simpers,et al.  Combinatorial approach to turbine bond coat discovery. , 2013, ACS combinatorial science.

[28]  P Sigmund,et al.  スパッタの理論 I 非晶質のスパッタ収量と多結晶ターゲット , 1969 .

[29]  I. Schuller,et al.  Thermalization of sputtered atoms , 1981 .

[30]  Jiefang Li,et al.  Analysis of the combustion driven linear generator for electric gun applications , 1999 .

[31]  D. Depla,et al.  Magnetron sputter deposition as visualized by Monte Carlo modeling , 2012 .

[32]  M. Seah,et al.  An accurate semi‐empirical equation for sputtering yields I: for argon ions , 2005 .