A Shield-Based Three-Port De-Embedding Method for Microwave On-Wafer Characterization of

A general three-port -parameter de-embedding method using shield-based test structures for microwave on-wafer characterization is presented in this paper. This method does not require any physical equivalent-circuit assumption for the surrounding parasitics of a device-under-test. We use one open and three thru dummy devices to remove the parasitic components connected to the gate, drain, and source terminals of a MOSFET. By shielding the lossy silicon substrate, the cross-coupling from port to port can be significantly mitigated, and thus, the parasitics of probe pads and interconnects at each port can be separately subtracted. The MOS transistor and its corresponding dummy structures fabricated in a 0.18- m CMOS process were charac- terized up to 20 GHz. Compared with the two-port cascade-based de-embedding method, the proposed three-port de-embedding procedure can further eliminate the parasitics associated with the dangling leg in the source terminal. The impacts of the accuracy of the de-embedding technique on device modeling and simulation are also discussed.

[1]  H. Cho,et al.  A three-step method for the de-embedding of high-frequency S-parameter measurements , 1991 .

[2]  Kee Soo Nam,et al.  A novel approach to extracting small-signal model parameters of silicon MOSFET's , 1997 .

[3]  J.A.M. Geelen,et al.  An improved de-embedding technique for on-wafer high-frequency characterization , 1991, Proceedings of the 1991 Bipolar Circuits and Technology Meeting.

[4]  T. E. Kolding.  Impact of test-fixture forward coupling on on-wafer silicon device measurements , 2000 .

[5]  Seonghearn Lee,et al.  A new parameter extraction technique for small-signal equivalent circuit of polysilicon emitter bipolar transistors , 1994 .

[6]  S. C. Wang,et al.  A Practical Method to Extract Extrinsic Parameters for the Silicon MOSFET Small- Signal Model , 2004 .

[7]  R. J. Havens,et al.  A calibrated lumped-element de-embedding technique for on-wafer RF characterization of high-quality inductors and high-speed transistors , 2003 .

[8]  G. Gonzalez.  Microwave Transistor Amplifiers: Analysis and Design , 1984 .

[9]  M. J. Deen,et al.  A general procedure for high-frequency noise parameter de-embedding of MOSFETs by taking the capacitive effects of metal interconnections into account , 2001, ICMTS 2001. Proceedings of the 2001 International Conference on Microelectronic Test Structures (Cat. No.01CH37153).

[10]  T. E. Kolding.  Shield-based microwave on-wafer device measurements , 2001 .

[11]  E. Vandamme,et al.  Improved three-step de-embedding method to accurately account for the influence of pad parasitics in silicon on-wafer RF test-structures , 2001 .

[12]  T. E. Kolding,et al.  Simple noise deembedding technique for on-wafer shield-based test fixtures , 2003 .

[13]  T. Kolding,et al.  Test Structures and Techniques for On-Wafer CMOS TRL Calibration , 2001 .

[14]  Hans-Martin Rein,et al.  Methods for measurement and simulation of weak substrate coupling in high-speed bipolar ICs , 2002 .

[15]  Troels Emil Kolding.  A Four-Step Method for De-Embedding Gigahertz , 2000 .