Use of a novel dual-sensor probe array and electrical resistance tomography for characterization of the mean and time-dependent properties of inclined, bubbly oil-in-water pipe flows

An array of dual-sensor conductance probes, which contains a number of dual-sensor probes equispaced across the diameter of an 80 mm pipe, is introduced in this paper for characterizing bubbly oil-in-water pipe flows inclined at angles from 15? to 60? to the vertical. Each dual-sensor probe measures the local axial oil velocity and the local oil volume fraction at the position of the probe. Choosing an averaging interval of 0.05 s, values of the local oil volume fraction and the local oil velocity were measured simultaneously at the different probe positions, enabling the time-dependent structure of the two-phase flow to be investigated. After data processing, time-dependent variations of volume fraction along the pipe were found which are consistent with the presence of intermittent Kelvin?Helmholtz wave structures in the flow. A high-speed dual-plane ERT system was used to measure the axial propagation speed of these Kelvin?Helmholtz waves, using cross correlation. This paper presents results for the measured characteristics of inclined oil-in-water flows including (i) time-averaged and time-dependent oil volume fraction and velocity distributions and (ii) the Kelvin?Helmholtz wave properties including the wave speed, wave amplitude, wavelength and wave frequency.

[1]  Gary Lucas,et al.  Measurement of the homogeneous velocity of inclined oil-in-water flows using a resistance cross correlation flow meter , 2001 .

[2]  Gary Lucas.  Gas volume fraction and velocity profiles , 2006, J. Vis..

[3]  R. Buchholz,et al.  Application of an Electrical Conductivity Microprobe for the Characterization of bubble behavior in gas‐liquid bubble flow , 1984 .

[4]  Panagiota Angeli,et al.  Upward and downward inclination oil-water flows , 2006 .

[5]  Panagiota Angeli,et al.  Flow structure in horizontal oil-water flow , 2000 .

[6]  M. Ishii,et al.  Distribution parameter and drift velocity of drift-flux model in bubbly flow , 2002 .

[7]  Isao Kataoka,et al.  Turbulence structure of air-water bubbly flow—I. measuring techniques , 1975 .

[8]  Jean-Pierre Hulin,et al.  Liquid‐liquid flows in an inclined pipe , 1988 .

[9]  Annalisa Manera,et al.  Comparison between wire-mesh sensors and conductive needle-probes for measurements of two-phase flow parameters , 2009 .

[10]  Gary Lucas,et al.  Optimisation of four-sensor probes for measuring bubble velocity components in bubbly air–water and oil–water flows , 2011 .

[11]  K. Sekoguchi,et al.  INTERFACIAL PROFILES AND FLOW CHARACTERISTICS IN VERTICAL DOWNWARD TWO-PHASE PLUG AND FOAM FLOWS , 1996 .

[12]  Oscar Mauricio Hernandez Rodriguez,et al.  Slip ratio in dispersed viscous oil-water pipe flow , 2011 .

[13]  G. P. Lucas.  Modelling velocity profiles in inclined multiphase flow to provide a priori information for flow imaging , 1995 .

[14]  Robert F. Mudde,et al.  On the accuracy of the void fraction measurements using optical probes in bubbly flows , 2005 .

[15]  Rakesh Mishra,et al.  Power law approximations to gas volume fraction and velocity profiles in low void fraction vertical gas–liquid flows , 2004 .

[16]  Alfred Daniel Hill,et al.  Production logging tool behavior in two-phase inclined flow , 1981 .

[17]  R.A. Williams,et al.  A high-performance EIT system , 2005, IEEE Sensors Journal.