Modeling of heat transfer and pyrolysis reactions in ethylene cracking furnace based on 3-D combustion monitoring

Abstract In this paper, a distributed parameter model for tubular reactor in the ethylene cracking furnace based on 3-D temperature reconstruction is developed. The mathematical model was formulated to predict the distributions of the heat flux and the tube temperature while considering a non-uniform distribution of the surface heat transfer and the ethylene pyrolysis process. The results show that the heat flux distribution on the tubular reactor has four high heat flux zones, and the tube temperature reaches a maximum of 1088 °C. The value of the maximum tube temperature decreases compared with the value of the maximum heat flux due to the heat exchange coefficient of pyrolysis gas increasing slowly in the bend region. The tube temperature distribution was validated by using a spectrometer system and the errors between three major product yields at the tube outlet obtained by the proposed model and in-situ measured values were within 5%. This distributed parameter model can be used as a guide for ethylene cracking furnace operators and as a tool for design.

[1]  Qiang Cheng,et al.  A new way to calculate radiative intensity and solve radiative transfer equation through using the Monte Carlo method , 2004 .

[2]  Tommy Detemmerman,et al.  Three Dimensional Coupled Simulation of Furnaces and Reactor Tubes for the Thermal Cracking of Hydrocarbons , 1998 .

[3]  K. M. Sundaram,et al.  Kinetics of coke deposition in the thermal cracking of propane , 1979 .

[4]  D. Kunzru,et al.  Modeling of naphtha pyrolysis , 1985 .

[5]  James Paul Holloway,et al.  A reconstruction algorithm for a spatially resolved plasma optical emission spectroscopy sensor , 2001 .

[6]  Erik Dick,et al.  Three‐dimensional flow patterns in cracking furnaces with long‐flame burners , 2001 .

[7]  Zhou Huai-chun,et al.  Measurements on flame temperature and its 3D distribution in a 660 MWe arch-fired coal combustion furnace by visible image processing and verification by using an infrared pyrometer , 2009 .

[8]  Mohammad Reza Rahimpour,et al.  Modeling of ethane pyrolysis process: A study on effects of steam and carbon dioxide on ethylene and hydrogen productions , 2013 .

[9]  Audai Hussein Al-Abbas,et al.  Numerical investigation of pyrolysis of a Loy Yang coal in a lab-scale furnace at elevated pressures , 2013 .

[10]  Chuguang Zheng,et al.  Visualization of three-dimensional temperature distributions in a large-scale furnace via regularized reconstruction from radiative energy images: numerical studies , 2002 .

[11]  Xiangyu Zhang,et al.  Distributed parameters modeling for evaporation system in a once-through coal-fired twin-furnace boiler , 2011 .

[12]  F. Dittus,et al.  Heat transfer in automobile radiators of the tubular type , 1930 .

[13]  Meihong Wang,et al.  Modelling and dynamic optimization of thermal cracking of propane for ethylene manufacturing , 2011, Comput. Chem. Eng..

[14]  Xiangyu Zhang,et al.  Simultaneous Measurement of Three-Dimensional Temperature Distributions and Radiative Properties Based on Radiation Image Processing Technology in a Gas-Fired Pilot Tubular Furnace , 2014 .

[15]  M. Shahrokhi,et al.  Optimal Temperature Control of a Propane Thermal Cracking Reactor , 2002 .

[16]  Jafar Towfighi,et al.  Simulation, optimization and control of a thermal cracking furnace , 2006 .

[17]  The influence of anisotropic scattering on the radiative intensity in a gray, plane-parallel medium calculated by the DRESOR method , 2007 .

[18]  Huai-Chun Zhou,et al.  Experimental investigations on visualization of three-dimensional temperature distributions in a large-scale pulverized-coal-fired boiler furnace , 2005 .

[19]  Geraldine J. Heynderickx,et al.  CFD simulations of steam cracking furnaces using detailed combustion mechanisms , 2006, Comput. Chem. Eng..

[20]  Xiangyu Zhang,et al.  An improved colorimetric method for visualization of 2-D, inhomogeneous temperature distribution in a gas fired industrial furnace by radiation image processing , 2011 .

[21]  Jamal Naser,et al.  Numerical modelling of oxy fuel combustion, the effect of radiative and convective heat transfer and burnout , 2015 .

[22]  Meihong Wang,et al.  Mathematical Modeling and Optimal Operation of Industrial Tubular Reactor for Naphtha Cracking , 2009 .

[23]  Jafar Towfighi,et al.  The combined simulation of heat transfer and pyrolysis reactions in industrial cracking furnaces , 2004 .

[24]  Huang Guihua,et al.  Numerical simulation on flow, combustion and heat transfer of ethylene cracking furnaces , 2011 .

[25]  Donglin Chen,et al.  Experiments on Measurement of Temperature and Emissivity of Municipal Solid Waste (MSW) Combustion by Spectral Analysis and Image Processing in Visible Spectrum , 2013 .

[26]  Guy Marin,et al.  Development of reduced combustion mechanisms for premixed flame modeling in steam cracking furnaces with emphasis on NO emission , 2006 .