Low-frequency vibration control of floating slab tracks using dynamic vibration absorbers

This study aims to effectively and robustly suppress the low-frequency vibrations of floating slab tracks (FSTs) using dynamic vibration absorbers (DVAs). First, the optimal locations where the DVAs are attached are determined by modal analysis with a finite element model of the FST. Further, by identifying the equivalent mass of the concerned modes, the optimal stiffness and damping coefficient of each DVA are obtained to minimise the resonant vibration amplitudes based on fixed-point theory. Finally, a three-dimensional coupled dynamic model of a metro vehicle and the FST with the DVAs is developed based on the nonlinear Hertzian contact theory and the modified Kalker linear creep theory. The track irregularities are included and generated by means of a time–frequency transformation technique. The effect of the DVAs on the vibration absorption of the FST subjected to the vehicle dynamic loads is evaluated with the help of the insertion loss in one-third octave frequency bands. The sensitivities of the mass ratio of DVAs and the damping ratio of steel-springs under the floating slab are discussed as well, which provided engineers with the DVA's adjustable room for vibration mitigation. The numerical results show that the proposed DVAs could effectively suppress low-frequency vibrations of the FST when tuned correctly and attached properly. The insertion loss due to the attachment of DVAs increases as the mass ratio increases, whereas it decreases with the increase in the damping ratio of steel-springs.

[1]  Thomas J. Royston,et al.  Application of Sherman–Morrison matrix inversion formula to damped vibration absorbers attached to multi-degree of freedom systems , 2005 .

[2]  Victor V. Krylov.  Low-Frequency Ground Vibrations from Underground Trains , 1995 .

[3]  S Wolf.  Potential low frequency ground vibration (<6.3 Hz) impacts from underground LRT operations , 2003 .

[4]  G P Wilson,et al.  Control of ground-borne noise and vibration , 1983 .

[5]  Jim Nelson,et al.  RECENT DEVELOPMENTS IN GROUND-BORNE NOISE AND VIBRATION CONTROL , 1996 .

[6]  T. X. Wu,et al.  On the railway track dynamics with rail vibration absorber for noise reduction , 2008 .

[7]  J. K. Hedrick,et al.  A Comparison of Alternative Creep Force Models for Rail Vehicle Dynamic Analysis , 1983 .

[8]  Raouf A. Ibrahim,et al.  Recent advances in nonlinear passive vibration isolators , 2008 .

[9]  Wanming Zhai,et al.  Lateral Hunting Stability of Railway Vehicles Running on Elastic Track Structures , 2010 .

[10]  P. Spanos,et al.  Monte Carlo Treatment of Random Fields: A Broad Perspective , 1998 .

[11]  Wanming Zhai,et al.  Dynamic effects of vehicles on tracks in the case of raising train speeds , 2001 .

[12]  Xiaozhen Li,et al.  High-speed train–track–bridge dynamic interactions – Part I: theoretical model and numerical simulation , 2013 .

[13]  Hugh Saurenman,et al.  In-service tests of the effectiveness of vibration control measures on the BART rail transit system , 2005 .

[14]  Wanming Zhai,et al.  High-speed train–track–bridge dynamic interactions – Part II: experimental validation and engineering application , 2013 .

[15]  Geert Lombaert,et al.  The control of ground-borne vibrations from railway traffic by means of continuous floating slabs , 2006 .

[16]  蔡成标,et al.  Stress intensity factors evaluation for through-transverse crack in slab track system under vehicle dynamic load , 2014 .

[17]  Jinsong Zhou,et al.  On the resonant vibration of a flexible railway car body and its suppression with a dynamic vibration absorber , 2013 .

[18]  Nd Anh,et al.  Design of non-traditional dynamic vibration absorber for damped linear structures , 2014 .

[19]  P. Spanos,et al.  Damage evolution and dynamic response of cement asphalt mortar layer of slab track under vehicle dynamic load , 2014 .

[20]  Pekka Vähäoja,et al.  Recent Studies of Adaptive Tuned Vibration Absorbers/Neutralizers , 2009 .

[21]  Wanming Zhai,et al.  Fundamentals of vehicle–track coupled dynamics , 2009 .

[22]  J. Ormondroyd.  Theory of the Dynamic Vibration Absorber , 1928 .

[23]  Chris Jones,et al.  A tuned damping device for reducing noise from railway track , 2007 .

[24]  Wanming Zhai,et al.  A New Wheel/Rail Spatially Dynamic Coupling Model and its Verification , 2004 .

[25]  Wanming Zhai,et al.  TWO SIMPLE FAST INTEGRATION METHODS FOR LARGE‐SCALE DYNAMIC PROBLEMS IN ENGINEERING , 1996 .

[26]  Wanming Zhai,et al.  Lateral interactions of trains and tracks on small-radius curves: simulation and experiment , 2006 .

[27]  L Schillemans.  Impact of sound and vibration of the North–South high-speed railway connection through the city of Antwerp Belgium , 2003 .

[28]  Thomas J. Royston,et al.  Extending Den Hartog’s Vibration Absorber Technique to Multi-Degree-of-Freedom Systems , 2005 .

[29]  Sheng-yang Zhu,et al.  Interface damage and its effect on vibrations of slab track under temperature and vehicle dynamic loads , 2014 .

[30]  ShengYang Zhu,et al.  A frequency and amplitude dependent model of rail pads for the dynamic analysis of train-track interaction , 2015 .

[31]  R. Smith,et al.  Dynamic vibration absorbers , 1998 .