Ultrasonic spot welding of Al/Mg/Al tri-layered clad sheets

[1]  A. Heidarzadeh,et al.  Effect of tool pin profile on microstructure and mechanical properties of friction stir welded AZ31B magnesium alloy , 2014 .

[2]  V. Patel,et al.  Effect of zinc interlayer on ultrasonic spot welded aluminum-to-copper joints , 2014 .

[3]  S. Babu,et al.  Effect of ultrasonic welding parameters on microstructure and mechanical properties of dissimilar joints , 2014 .

[4]  N. Huber,et al.  Increased room temperature formability of Mg AZ31 by high speed Friction Stir Processing , 2014 .

[5]  Q. Peng,et al.  Age hardening behaviors, mechanical and corrosion properties of deformed Mg–Mn–Sn sheets by pre-rolled treatment , 2014 .

[6]  A. Macwan,et al.  Effect of annealing on interface microstructures and tensile properties of rolled Al/Mg/Al tri-layer clad sheets , 2013 .

[7]  C. Zhiqiang,et al.  Effect of high temperature annealing and subsequent hot rolling on microstructural evolution at the bond-interface of Al/Mg/Al alloy laminated composites , 2013 .

[8]  Alexander M. Korsunsky,et al.  Residual stresses in Linear Friction Welding of aluminium alloys , 2013 .

[9]  F. Pan,et al.  Influence of different rolling routes on the microstructure evolution and properties of AZ31 magnesium alloy sheets , 2013 .

[10]  J. Robson,et al.  The Effectiveness of Surface Coatings on Preventing Interfacial Reaction During Ultrasonic Welding of Aluminum to Magnesium , 2013, Metallurgical and Materials Transactions A.

[11]  M. McNutt.  Climate Change Impacts , 2013, Science.

[12]  S. Vignieri,et al.  Natural systems in changing climates. Once and future climate change. Introduction. , 2013, Science.

[13]  S. Hong,et al.  Effect of component layer thickness on the bending behaviors of roll-bonded tri-layered Mg/Al/STS clad composites , 2013 .

[14]  Karl Ulrich Kainer,et al.  Development of a magnesium secondary alloy system for mixed magnesium post-consumer scrap , 2013 .

[15]  Yuman Zhu,et al.  Periodic Segregation of Solute Atoms in Fully Coherent Twin Boundaries , 2013, Science.

[16]  V. Patel,et al.  Ultrasonic spot welded AZ31 magnesium alloy: Microstructure, texture, and lap shear strength , 2013 .

[17]  Yuansheng Yang,et al.  A high strength and ductility Mg–Zn–Al–Cu–Mn magnesium alloy , 2013 .

[18]  P. Wanjara,et al.  Microstructure and Fatigue Properties of a Friction Stir Lap Welded Magnesium Alloy , 2013, Metallurgical and Materials Transactions A.

[19]  Chao Xu,et al.  Texture Evolution of the Mg/Al Laminated Composite by Accumulative Roll Bonding at Ambient Temperature , 2013 .

[20]  V. Patel,et al.  Formation of zinc interlayer texture during dissimilar ultrasonic spot welding of magnesium and high strength low alloy steel , 2013 .

[21]  P. Wanjara,et al.  Lap shear strength and fatigue life of friction stir spot welded AZ31 magnesium and 5754 aluminum alloys , 2012 .

[22]  D. Yoon,et al.  Effect of annealing on the interface microstructure and mechanical properties of a STS–Al–Mg 3-ply clad sheet , 2012 .

[23]  J. Robson,et al.  The effect of high strain rate deformation on intermetallic reaction during ultrasonic welding aluminium to magnesium , 2012 .

[24]  William J. Joost,et al.  Reducing Vehicle Weight and Improving U.S. Energy Efficiency Using Integrated Computational Materials Engineering , 2012 .

[25]  Margaret Lucas,et al.  A study of weld quality in ultrasonic spot welding of similar and dissimilar metals , 2012 .

[26]  V. Patel,et al.  Improving weld strength of magnesium to aluminium dissimilar joints via tin interlayer during ultrasonic spot welding , 2012 .

[27]  P. Clark,et al.  Global warming preceded by increasing carbon dioxide concentrations during the last deglaciation , 2012, Nature.

[28]  V. Patel,et al.  Microstructure and mechanical properties of dissimilar welded Mg–Al joints by ultrasonic spot welding technique , 2012 .

[29]  A. Kokabi,et al.  Investigation on friction stir lap welding of aluminium to aluminium clad steel sheets , 2012 .

[30]  P. Prangnell,et al.  Optimization of Aluminium-to-Magnesium Ultrasonic Spot Welding , 2012 .

[31]  J. Murray,et al.  Climate policy: Oil's tipping point has passed , 2012, Nature.

[32]  V. Patel,et al.  Influence of ultrasonic spot welding on microstructure in a magnesium alloy , 2011 .

[33]  S. Bhole,et al.  Microstructure and Mechanical Properties of Fiber-Laser-Welded and Diode-Laser-Welded AZ31 Magnesium Alloy , 2011 .

[34]  S. Castagne,et al.  Proposal of bond criterion for hot roll bonding and its application , 2011 .

[35]  Y. Chen,et al.  Ultrasonic spot welding of aluminium to steel for automotive applications—microstructure and optimisation , 2011 .

[36]  S. Castagne,et al.  Entrance analysis of 7075 Al/Mg–Gd–Y–Zr/7075 Al laminated composite prepared by hot rolling and its mechanical properties , 2011 .

[37]  R. Wu,et al.  Effects of Ce-rich RE additions and heat treatment on the microstructure and tensile properties of Mg–Li–Al–Zn-based alloy , 2011 .

[38]  P. Prangnell,et al.  Mechanisms of joint and microstructure formation in high power ultrasonic spot welding 6111 aluminium automotive sheet , 2010 .

[39]  S. D. Bhole,et al.  Tensile properties of a friction stir welded magnesium alloy: Effect of pin tool thread orientation and weld pitch , 2010 .

[40]  Z. Fan,et al.  The effect of Al8Mn5 intermetallic particles on grain size of as-cast Mg–Al–Zn AZ91D alloy , 2010 .

[41]  T. Pollock.  Weight Loss with Magnesium Alloys , 2010, Science.

[42]  S. Bhole,et al.  Tensile properties and strain-hardening behavior of double-sided arc welded and friction stir welded AZ31B magnesium alloy , 2010 .

[43]  S. Bhole,et al.  Microstructure and tensile properties of thixomolded magnesium alloys , 2010 .

[44]  S. Bhole,et al.  Welding behaviour, microstructure and mechanical properties of dissimilar resistance spot welds between galvannealed HSLA350 and DP600 steels , 2009 .

[45]  A. Luo,et al.  Dependence of the distribution of deformation twins on strain amplitudes in an extruded magnesium alloy after cyclic deformation , 2009 .

[46]  M. Jahazi,et al.  Polishing-assisted galvanic corrosion in the dissimilar friction stir welded joint of AZ31 magnesium alloy to 2024 aluminum alloy , 2009 .

[47]  M. Liu,et al.  Influence of the β-phase morphology on the corrosion of the Mg alloy AZ91 , 2008 .

[48]  X. Z. Lin,et al.  Strain Hardening and Strain-Rate Sensitivity of an Extruded Magnesium Alloy , 2008, Journal of Materials Engineering and Performance.

[49]  G. Song,et al.  Comparison of the linearly increasing stress test and the constant extension rate test in the evaluation of transgranular stress corrosion cracking of magnesium , 2008 .

[50]  Xinjin Cao,et al.  Microstructure and tensile properties of friction stir welded AZ31B magnesium alloy , 2008 .

[51]  M. Jahazi,et al.  Strain hardening behavior of a friction stir welded magnesium alloy , 2007 .

[52]  S. Bhole,et al.  Formability and Fatigue Behavior of Tailor (Laser) Welded Blanks for Automotive Applications , 2006 .

[53]  N. Ünlü,et al.  Reassessment of Al-Ce and Al-Nd binary systems supported by critical experiments and first-principles energy calculations , 2005 .

[54]  S. Hanada,et al.  Fabrication of pure Al/Mg-Li alloy clad plate and its mechanical properties , 2005 .

[55]  E. Ghali,et al.  General and localized corrosion of magnesium alloys: A critical review , 2004 .

[56]  G. Song,et al.  Corrosion mechanisms of magnesium alloys , 1999 .

[57]  Yun-Soo Lee,et al.  Interface-correlated deformation behavior of a stainless steel-Al–Mg 3-ply composite , 2013 .

[58]  Xuyue Yang,et al.  Enhanced stretch formability and mechanical properties of a magnesium alloy processed by cold forging and subsequent annealing , 2013 .

[59]  Y. Gu,et al.  Effect of chloride ion level on the corrosion performance of MAO modified AZ31 alloy in NaCl solutions , 2013 .

[60]  D. Scholl,et al.  Ultrasonic Metal Welding Process Robustness in Aluminum Automotive Body Construction Applications , 2009 .