High Step-Up DC–DC Converter With Active Switched-Inductor and Passive Switched-Capacitor Networks

High-gain voltage conversion is a feature required for several applications, especially for power processing of low-voltage renewable sources in grid-connected systems. In this scope, the presented paper proposes a novel transformerless high gain step-up dc–dc converter based on an active switched-inductor and a passive switched-capacitor networks. The main advantages of the proposed converter are the high voltage gain (>10), the reduced voltage stresses across the switches and the reduced number of components when compared to topologies that provide the same voltage gain using similar principles. The detailed analysis of the proposed converter and a comparison considering other topologies previously published in the literature are also presented in this manuscript. In order to verify the proposed converter performance, a prototype has been built for a power of 200 W, input and output voltages of 20 and 260 V, respectively, and switching frequency of 50 kHz. Experimental results validate the effectiveness of the theoretical analysis proving the satisfactory converter performance, which peak efficiency is around 95.5%.

[1]  Asha,et al.  A New Hybrid Boosting Converter for Renewable Energy Applications , 2016 .

[2]  Yaow-Ming Chen,et al.  Boost Converter With Coupled Inductors and Buck–Boost Type of Active Clamp , 2008, IEEE Transactions on Industrial Electronics.

[3]  Y. Berkovich,et al.  Switched Coupled-Inductor Cell for DC-DC Converters with Very Large Conversion Ratio , 2011, IECON 2006 - 32nd Annual Conference on IEEE Industrial Electronics.

[4]  Roberto F. Coelho,et al.  Generalized High Step-Up DC-DC Boost-Based Converter With Gain Cell , 2017, IEEE Transactions on Circuits and Systems I: Regular Papers.

[5]  Fernando Lessa Tofoli,et al.  Survey on non-isolated high-voltage step-up dc–dc topologies based on the boost converter , 2015 .

[6]  Erickson,et al.  Fundamentals of Power Electronics, 2nd edition , 2020 .

[7]  Jiann-Fuh Chen,et al.  Transformerless DC–DC Converters With High Step-Up Voltage Gain , 2009, IEEE Transactions on Industrial Electronics.

[8]  Wuhua Li,et al.  Review of Nonisolated High-Step-Up DC/DC Converters in Photovoltaic Grid-Connected Applications , 2011, IEEE Transactions on Industrial Electronics.

[9]  Fang Lin Luo,et al.  Positive output cascade boost converters , 2004 .

[10]  Xuefeng Hu,et al.  Input-parallel output-series DC–DC converter for non-isolated high step-up applications , 2016 .

[11]  I. Barbi,et al.  A New Quadratic, Three-Level, DC/DC Converter Suitable for Fuel Cell Applications , 2007, 2007 Power Conversion Conference - Nagoya.

[12]  Tsorng-Juu Liang,et al.  Analysis and Implementation of a Novel Bidirectional DC–DC Converter , 2012, IEEE Transactions on Industrial Electronics.

[13]  Chien-Ming Wang A Novel ZCS-PWM Flyback Converter With a Simple ZCS-PWM Commutation Cell , 2008, IEEE Transactions on Industrial Electronics.

[14]  Esam H. Ismail,et al.  A Family of Single-Switch PWM Converters With High Step-Up Conversion Ratio , 2008, IEEE Transactions on Circuits and Systems I: Regular Papers.

[15]  Chao-Ming Huang,et al.  Interleaved high step-up DC-DC converter with parallel-input series-output configuration and voltage multiplier module , 2017, 2017 IEEE International Conference on Industrial Technology (ICIT).

[16]  Ting Wang,et al.  Study of An Improved Dual-Switch Converter With Passive Lossless Clamping , 2015, IEEE Transactions on Industrial Electronics.

[17]  Ting Wang,et al.  Hybrid Switched-Inductor Converters for High Step-Up Conversion , 2015, IEEE Transactions on Industrial Electronics.

[18]  Ping Wang,et al.  Input-Parallel Output-Series DC-DC Boost Converter With a Wide Input Voltage Range, For Fuel Cell Vehicles , 2017, IEEE Transactions on Vehicular Technology.

[19]  Robert W. Erickson,et al.  Fundamentals of Power Electronics , 2001 .

[20]  Julio C. Rosas-Caro,et al.  A DC-DC multilevel boost converter , 2010 .

[21]  Fred C. Lee,et al.  High-efficiency, high step-up DC-DC converters , 2003 .

[22]  R. Gules,et al.  Voltage Multiplier Cells Applied to Non-Isolated DC–DC Converters , 2008, IEEE Transactions on Power Electronics.

[23]  Tsai-Fu Wu,et al.  Unified approach to developing single-stage power converters , 1998 .

[24]  Emmanuel C. Tatakis,et al.  Active voltage clamp in flyback converters operating in CCM mode under wide load variation , 2004, IEEE Transactions on Industrial Electronics.

[25]  Shih-Ming Chen,et al.  A Safety Enhanced, High Step-Up DC–DC Converter for AC Photovoltaic Module Application , 2012, IEEE Transactions on Power Electronics.