Observers for vehicle tyre/road forces estimation: experimental validation

The motion of a vehicle is governed by the forces generated between the tyres and the road. Knowledge of these vehicle dynamic variables is important for vehicle control systems that aim to enhance vehicle stability and passenger safety. This study introduces a new estimation process for tyre/road forces. It presents many benefits over the existing state-of-art works, within the dynamic estimation framework. One of these major contributions consists of discussing in detail the vertical and lateral tyre forces at each tyre. The proposed method is based on the dynamic response of a vehicle instrumented with potentially integrated sensors. The estimation process is separated into two principal blocks. The role of the first block is to estimate vertical tyre forces, whereas in the second block two observers are proposed and compared for the estimation of lateral tyre/road forces. The different observers are based on a prediction/estimation Kalman filter. The performance of this concept is tested and compared with real experimental data using a laboratory car. Experimental results show that the proposed approach is a promising technique to provide accurate estimation. Thus, it can be considered as a practical low-cost solution for calculating vertical and lateral tyre/road forces.

[1]  Ali Charara,et al.  Embedded estimation of the tire/road forces and validation in a laboratory vehicle , 2008 .

[2]  S. Glaser,et al.  Tire-road forces estimation using extended Kalman filter and sideslip angle evaluation , 2008, 2008 American Control Conference.

[3]  T. Başar,et al.  A New Approach to Linear Filtering and Prediction Problems , 2001 .

[4]  Laura R. Ray,et al.  Nonlinear Tire Force Estimation and Road Friction Identification: Simulation and Experiments, , 1997, Autom..

[5]  Ali Charara,et al.  Lateral load transfer and normal forces estimation for vehicle safety: experimental test , 2009 .

[6]  Aleksander B. Hac,et al.  Detection of Vehicle Rollover , 2004 .

[7]  Jeffrey K. Uhlmann,et al.  New extension of the Kalman filter to nonlinear systems , 1997, Defense, Security, and Sensing.

[8]  William F. Milliken,et al.  Race Car Vehicle Dynamics , 1994 .

[9]  Hans B. Pacejka,et al.  Tire and Vehicle Dynamics , 1982 .

[10]  Ali Charara,et al.  Experimental evaluation of tire-road forces and sideslip angle observers , 2007, 2007 European Control Conference (ECC).

[11]  Rajesh Rajamani,et al.  Vehicle dynamics and control , 2005 .

[12]  Kenneth J. Hunt,et al.  Roll dynamics and lateral load transfer estimation in articulated heavy freight vehicles , 2003 .

[13]  Ali Charara,et al.  An Estimation Process for Vehicle Wheel-Ground Contact Normal Forces , 2008 .

[14]  J. L. Roux.  An Introduction to the Kalman Filter , 2003 .

[15]  J. Christian Gerdes,et al.  EXPERIMENTAL STUDIES OF USING STEERING TORQUE UNDER VARIOUS ROAD CONDITIONS FOR SIDESLIP AND FRICTION ESTIMATION , 2007 .

[16]  Arjan van der Schaft,et al.  Non-linear dynamical control systems , 1990 .

[17]  A. Charara,et al.  An Observer of Tire–Road Forces and Friction for Active Security Vehicle Systems , 2007, IEEE/ASME Transactions on Mechatronics.

[18]  Martin Levesley,et al.  Use of an extended Kalman filter as a robust tyre force estimator , 2006 .

[19]  Jacob Svendenius,et al.  Tire Modeling and Friction Estimation , 2007 .

[20]  Paolo Bolzern,et al.  ESTIMATION OF THE NON-LINEAR SUSPENSION TYRE CORNERING FORCES FROM EXPERIMENTAL ROAD TEST DATA. , 1999 .

[21]  Lars Lidner.  EXPERIENCE WITH THE MAGIC FORMULA TYRE MODEL , 1992 .

[22]  Taehyun Shim,et al.  Understanding the limitations of different vehicle models for roll dynamics studies , 2007 .

[23]  Uwe Kiencke,et al.  Automotive Control Systems , 2005 .

[24]  Keith J. Burnham,et al.  Dual extended Kalman filter for vehicle state and parameter estimation , 2006 .

[25]  Ali Charara,et al.  Experimental evaluation of observers for tire–road forces, sideslip angle and wheel cornering stiffness , 2008 .