Development of passive microwave antenna-feed systems for wide-band dual-polarisation receivers

This study presents the design and experimental results of a wide-band passive antenna-feed system developed for the C-band dual-circular-polarisation receiver of the Sardinia radio telescope (SRT). The latter is a 64 m diameter shaped radio-telescope under construction designed to operate with high efficiency from 300 MHz to over 100 GHz. The developed C-band antenna-feed system exhibits very high performances in a 30 band centred at 6.7 GHz, for example the return loss at all electrical ports is higher than 30 dB and the cross-coupling between the two polarisations is lower than 34 dB. The design solutions of all the feed-system components such as marker injector, polariser, transitions and the ortho-mode transducer (OMT) are reported in the study. In particular, the novel architecture of the OMT that provides an isolation between the two rectangular ports better than 70 dB is described in close detail. Computed and experimental results regarding both the complete system and its sub-assemblies are reported and discussed.

[1]  M. Miyazaki,et al.  A design of novel grooved circular waveguide polarizers , 2000, IMS 2000.

[2]  M. Miyazaki,et al.  Ultra-thin broadband OMT with turnstile junction , 2003, IEEE MTT-S International Microwave Symposium Digest, 2003.

[3]  Jens Bornemann,et al.  Analysis and design of circular ridged waveguide components , 1999 .

[4]  R. Tascone,et al.  The Sky Polarization Observatory , 2004 .

[5]  R. Tascone,et al.  Orthomode transducer for millimeter-wave correlation receivers , 2006, IEEE Transactions on Microwave Theory and Techniques.

[6]  J. M. Rebollar,et al.  CAD of corrugated circular-rectangular waveguide polarizers , 1993 .

[7]  R. Orta,et al.  Combined-Phase-Shift Waveguide Polarizer , 2008, IEEE Microwave and Wireless Components Letters.

[8]  R. Orta,et al.  Reduced-order optimized mode-matching CAD of microwave waveguide components , 2004, IEEE Transactions on Microwave Theory and Techniques.

[9]  J. Carlstrom,et al.  Finline ortho-mode transducer for millimeter waves , 1999 .

[10]  Christopher W. O'Dell,et al.  Calibration of millimeter-wave polarimeters using a thin dielectric sheet , 2002 .

[11]  R. Jackson,et al.  A planar orthomode transducer , 2001, IEEE Microwave and Wireless Components Letters.

[12]  R. Tascone,et al.  A novel design tool for waveguide polarizers , 2005, IEEE Transactions on Microwave Theory and Techniques.

[13]  R. Orta,et al.  Scattering matrix approach for the design of microwave filters , 2000 .

[14]  A. Gasiewski,et al.  Calibration and applications of polarization-correlating radiometers , 1993 .

[15]  R. Tascone,et al.  Full-wave design of broad-band compact waveguide step-twists , 2005, IEEE Microwave and Wireless Components Letters.

[16]  R. Tascone,et al.  On-board calibration system for millimeter-wave radiometers based on reference-polarized signal injection , 2006, IEEE Transactions on Microwave Theory and Techniques.

[17]  Giuseppe Virone,et al.  A microwave measurement procedure for a full characterization of ortho-mode transducers , 2003 .

[18]  A. Navarrini,et al.  Symmetric Reverse-Coupling Waveguide Orthomode Transducer for the 3-mm Band , 2009, IEEE Transactions on Microwave Theory and Techniques.

[19]  Ignasi Corbella,et al.  A calibration method for fully polarimetric microwave radiometers , 2003, IEEE Trans. Geosci. Remote. Sens..

[20]  R. Tascone,et al.  Optimum-Iris-Set Concept for Waveguide Polarizers , 2007, IEEE Microwave and Wireless Components Letters.

[21]  H. Rudolf,et al.  The ALMA Front End Optics—System Aspects and European Measurement Results , 2007, IEEE Transactions on Antennas and Propagation.