Effects of blasting on the stability of paste fill stopes at Cannington Mine
暂无分享,去创建一个
Paste fill is a cemented backfill used to fill the void left by mining to provide stability to the
mine. It consists of tailings mixed with a small percentage of cement and water. As the mining
sequence progresses and stopes adjacent to the fill are mined, the fill is subjected to blasting
loads, and subsequently exposed. The purpose of this thesis was to study the effects of blast
loading on paste fill, and the research consisted of experimental and numerical modelling
components and some field work at Cannington mine.
The field work involved monitoring of paste fill during production blasts, in situ tests in paste
fill at Cannington mine and laboratory tests on the paste fill samples. Triaxial geophones were
installed in stope 4261 at Cannington Mine, which had previously been mined and filled with
paste fill. These geophones were used to measure the velocity waveforms produced in the stope
during the blasting in two adjacent stopes. The data collected as part of this field work resulted
in the estimation of a peak particle velocity at which paste fill begins to fail.
The in situ tests involved monitoring the explosion of 9 blast holes in paste fill. Triaxial
geophones were used to measure the velocity profile of each blast. The blast holes were
detonated individually in order to obtain separate velocity profiles. The results were used to
obtain a relationship between the peak particle velocity and the scaled distance from the blast.
The laboratory tests were conducted to measure the attenuation of a wave as it travels through a
column of paste fill. Paste fill was poured into a 2.7 m long column in which 4 accelerometers
were installed. A wave was induced in the column by striking the end of a column with a
hammer and the particle acceleration was measured. The results were used to show the effect of
paste fill mix on the attenuation of a wave.
The finite element method based numerical modelling package, ABAQUS/Explicit, was used to
model the behaviour of paste fill due to adjacent blasting in an underground mine. The first
numerical model consisted of a single column of explosive detonated in paste fill. The results
of this model were validated against the data obtained in the field tests. Once validated, the
model was run for different mixes of paste fill to observe the effect of cement and solids content
of the paste fill on its behaviour. A model of a single column of explosive in rock was also
developed and validated using the same method. The model was then extended to include a
single column of explosive detonated in rock adjacent to a paste fill stope. This model was run
for a variety of blasting conditions to observe the changes in paste fill behaviour due to different
blasting conditions. These different blasting conditions included varying distances between the explosive column and the rock/paste fill interface and various positions ofthe explosive column
in relation to the paste fill stope. The model was finally extended to include a row of explosive
columns parallel to the face of a paste fill stope. This model was run for a variety of blasting
patterns and delay intervals to determine their effect on damage to paste fill. The model results
showed that the peak particle velocity and therefore the damage to the paste fill reduced for
increased cement contents of the fill. Similar results were observed for increased solids content,
but to a lesser extent. The model results also indicated that the order of detonation and the delay
time between the detonation of blast holes has little effect on the damage to the paste fill.