Low Crossover of Methanol and Water Through Thin Membranes in Direct Methanol Fuel Cells

Low crossover of both methanol and water through a polymer membrane in a direct methanol fuel cell (DMFC) is essential for using high concentration methanol in portable power applications. A novel design of the membrane-electrolyte assembly (MEA) has been developed in this work to attain low methanol crossover, low water crossover, and high cell performance simultaneously. The anode catalyst layer, in the form of a catalyzed diffusion medium (CDM), serves as a methanol diffusion barrier to reduce methanol crossover. In addition, a highly hydrophobic cathode microporous layer (MPL) is employed to build up the hydraulic pressure at the cathode and hence drive the product water from the cathode into the anode to offset the water dragged by electro-osmosis. The new MEA, consisting of a CDM anode, a thin Nafion membrane, and a carbon cloth precoated with an MPL on the cathode, is shown to attain: (i) a net water transport coefficient through the membrane smaller than 0.8 at 60°C and 0.4 at 50°C; (ii) fuel efficiency of ∼80%; and (iii) a steady-state power density of 60 mW/cm 2 at ca. 0.4V and 60°C with low stoichiometric flow rates of ambient dry air and 3 M methanol solution.

[1]  E. Peled,et al.  0.5 W / cm2 Direct Methanol-Air Fuel Cell , 2004 .

[2]  Shimshon Gottesfeld,et al.  Electro-osmotic Drag of Water in Poly(perfluorosulfonic acid) Membranes , 2001 .

[3]  Chaoyang Wang,et al.  Development of high-power electrodes for a liquid-feed direct methanol fuel cell , 2003 .

[4]  Chaoyang Wang,et al.  Variations in interfacial properties during cell conditioning and influence of heat-treatment of ionomer on the characteristics of direct methanol fuel cells , 2005 .

[5]  John Davey,et al.  Recent advances in direct methanol fuel cells at Los Alamos National Laboratory , 2000 .

[6]  Chao-Yang Wang,et al.  Liquid Water Transport in Gas Diffusion Layer of Polymer Electrolyte Fuel Cells , 2004 .

[7]  Antonino S. Aricò,et al.  Investigation of direct methanol fuel cells based on unsupported Pt-Ru anode catalysts with different chemical properties , 2000 .

[8]  C. Pu,et al.  Carbon supported and unsupported Pt–Ru anodes for liquid feed direct methanol fuel cells , 1998 .

[9]  Chao-Yang Wang,et al.  Two-phase transport and the role of micro-porous layer in polymer electrolyte fuel cells , 2004 .

[10]  Novel Approach to Recycling Water and Reducing Water Loss in DMFCs , 2003 .

[11]  Shimshon Gottesfeld,et al.  High performance direct methanol polymer electrolyte fuel cells , 1996 .

[12]  Angelika Heinzel,et al.  A review of the state-of-the-art of the methanol crossover in direct methanol fuel cells , 1999 .

[13]  Antonino S. Aricò,et al.  Analysis of the high-temperature methanol oxidation behaviour at carbon-supported Pt–Ru catalysts , 2003 .

[14]  Antonino S. Aricò,et al.  Performance of DMFC anodes with ultra-low Pt loading , 2004 .

[15]  Fuqiang Liu,et al.  Water Transport Through Nafion 112 Membrane in DMFCs , 2005 .

[16]  W. Preidel,et al.  Status of the development of a direct methanol fuel cell , 1999 .

[17]  Kai Sundmacher,et al.  Limiting current behaviour of the direct methanol fuel cell , 1999 .

[18]  Antonino S. Aricò,et al.  DMFCs: From Fundamental Aspects to Technology Development , 2001 .

[19]  Emanuel Peled,et al.  Water-neutral micro direct-methanol fuel cell (DMFC) for portable applications , 2003 .

[20]  M. Hickner,et al.  Alternative polymer systems for proton exchange membranes (PEMs). , 2004, Chemical reviews.

[21]  Shimshon Gottesfeld,et al.  Methanol transport through Nafion membranes : Electro-osmotic drag effects on potential step measurements , 2000 .