Effects of Hypervelocity Impacts on Silicone Elastomer Seals and Mating Aluminum Surfaces

While in space silicone based elastomer seals planned for use on NASA’s Crew Exploration Vehicle (CEV) are exposed to threats from micrometeoroids and orbital debris (MMOD). An understanding of these threats is required to assess risks to the crew, the CEV orbiter, and missions. An Earth based campaign of hypervelocity impacts on small scale seal rings has been done to help estimate MMOD threats to the primary docking seal being developed for the Low Impact Docking System (LIDS). LIDS is being developed to enable the CEV to dock to the ISS (International Space Station) or to Altair (NASA’s next lunar lander). The silicone seal on LIDS seals against aluminum alloy flanges on ISS or Altair. Since the integrity of a seal depends on both sealing surfaces, aluminum targets were also impacted. The variables considered in this study included projectile mass, density, speed, incidence angle, seal materials, and target surface treatments and coatings. Most of the impacts used a velocity near 8 km/s and spherical aluminum projectiles (density = 2.7 g/cm 3 ), however, a few tests were done near 5.6 km/s. Tests were also performed using projectile densities of 7.7, 2.79, 2.5 or 1.14 g/ cm 3 . Projectile incidence angles examined included 0°, 45°, and 60° from normal to the plane of the target. Elastomer compounds impacted include Parker’s S0383-70 and Esterline’s ELA-SA-401 in the as received condition, or after an atomic oxygen treatment. Bare, anodized and nickel coated aluminum targets were tested simulating the candidate mating seal surface materials. After impact, seals and aluminum plates were leak tested: damaged seals were tested against an undamaged aluminum plate; and undamaged seals were placed at various locations over craters in aluminum plates. It has been shown that silicone elastomer seals can withstand an impressive level of damage before leaking beyond allowable limits. In general on the tests performed to date, the diameter of the crater in either the elastomer, or the aluminum, must be at least as big as 80% to 90% of width of the bulb of the seal before significant leakage occurs.

[1]  Bruce M. Steinetz,et al.  Review of Seal Designs on the Apollo Spacecraft , 2008 .

[2]  M. Lambert,et al.  Hypervelocity impacts and damage laws , 1997 .

[3]  Burton G. Cour-Palais,et al.  Hypervelocity impact in metals, glass and composites , 1987 .

[4]  Bruce A. Banks,et al.  Environmental durability issues for solar power systems in low earth orbit , 1994 .

[5]  Bruce M. Steinetz,et al.  Assessing MMOD Impacts on Seal Performance , 2007 .

[6]  S Evans,et al.  Bounding the risk of crew loss following orbital debris penetration of the International Space Station at assembly stages 1J and 1E. , 2004, Advances in space research : the official journal of the Committee on Space Research.

[7]  Thomas H. See,et al.  Penetration experiments in aluminum 1100 targets using soda-lime glass projectiles , 1995 .

[8]  Tang Qingming,et al.  Experimental laws of cratering for hypervelocity impacts of spherical projectiles into thick target , 1994 .

[9]  Eric L. Christiansen,et al.  Meteoroid/Debris Shielding , 2003 .

[10]  Bruce M. Steinetz,et al.  Adhesion of Silicone Elastomer Seals for NASA's Crew Exploration Vehicle , 2008 .

[11]  Alan J. Watts,et al.  Dimensional scaling for impact cratering and perforation , 1995 .

[12]  Joel E. Williamsen,et al.  Review of Space Shuttle Meteoroid/Orbital Debris Critical Risk Assessment Practices , 2004 .

[13]  Eric L. Christiansen,et al.  Design and Performance Equations for Advanced Meteoroid and Debris Shields , 1993 .

[14]  P. Anz-meador,et al.  Orbital Debris Environment for Spacecraft Designed to Operate in Low Earth Orbit , 1989 .

[15]  James S. Wilbeck,et al.  Review of hypervelocity penetration theories , 1987 .

[16]  B. P. Denardo.  Projectile size effects on hypervelocity impact craters in aluminum , 1967 .

[17]  Bruce M. Steinetz,et al.  Characteristics of Elastomer Seals Exposed to Space Environments , 2007 .

[18]  D. Hastings,et al.  Spacecraft–Environment Interactions: Index , 1996 .

[19]  Christopher A. Gallo,et al.  Meteoroid and Orbital Debris Threats to NASA's Docking Seals: Initial Assessment and Methodology , 2009 .