A Re-Look at the Asphalt Mixture Performance Test Protocols and Computational Algorithms

Asphalt mixture performance tests (AMPTs) are developed to complement the Superpave volumetric mix design procedure and to reliably measure the mechanical response characteristics of the asphalt mixtures. The AMPT protocols, such as dynamic modulus, flow time and flow number test protocols, and the computational algorithms for post-processing of data are in the development stages and require further refinement. In this investigation, AMPTs were carried out on asphalt mixtures with unmodified, polymer-modified, and crumb-rubber-modified binders. Dynamic modulus test was carried out for a wide range of temperatures and frequencies and master curves were constructed. It was observed that the American Association of State Highway and Transportation Officials (AASHTO) procedure for master curves does not take into account the influence of phase angle, and this could hinder the effective use of this input in pavement design and analysis. Flow time and flow number tests were carried out for an extended time of 100 000 s (cycles) rather than the currently practised 10 000 s (cycles) protocol. The test data was used in assessing the various algorithms for evaluating flow values. A wheel tracking test was also carried out and it was found that the response of mixtures could be correlated to wheel tracking test results in a qualitative manner to the flow time test.

[1]  E. Masad,et al.  Tertiary flow characteristics of asphalt mixtures , 2002 .

[2]  D. Lesueur.  The colloidal structure of bitumen: consequences on the rheology and on the mechanisms of bitumen modification. , 2009, Advances in colloid and interface science.

[3]  William R. Heller,et al.  Creep Of Engineering Materials , 1959 .

[4]  Emmanuel Chailleux,et al.  A mathematical-based master-curve construction method applied to complex modulus of bituminous materials , 2006 .

[5]  Ramon Bonaquist,et al.  Precision of the Dynamic Modulus and Flow Number Tests Conducted with the Asphalt Mixture Performance Tester , 2011 .

[6]  Audrey Copeland,et al.  Refinement of Flow Number as Determined by Asphalt Mixture Performance Tester , 2009 .

[7]  Ramon Bonaquist,et al.  SIMPLE PERFORMANCE TESTER FOR SUPERPAVE MIX DESIGN: FIRST-ARTICLE DEVELOPMENT AND EVALUATION , 2003 .

[8]  T. Pellinen,et al.  HIRSCH MODEL FOR ESTIMATING THE MODULUS OF ASPHALT CONCRETE , 2003 .

[9]  M. Shaw,et al.  Modelling the linear viscoelastic rheological properties of bituminous binders , 2011 .

[10]  Mohamed M El-Basyouny,et al.  SIMPLE PERFORMANCE TEST FOR SUPERPAVE MIX DESIGN , 2002 .

[11]  Bouzid Choubane,et al.  Suitability of Asphalt Pavement Analyzer for Predicting Pavement Rutting , 2000 .

[12]  Louay N. Mohammad,et al.  Characterization of Louisiana Asphalt Mixtures Using Simple Performance Tests , 2007 .

[13]  Haleh Azari,et al.  Permanent Deformation Characterization of Asphalt Mixtures by Using Incremental Repeated Load Testing , 2013 .

[14]  H. C. Booij,et al.  Generalization of Kramers-Kronig transforms and some approximations of relations between viscoelastic quantities , 1982 .

[15]  Fujie Zhou,et al.  Preliminary Field Validation of Simple Performance Tests for Permanent Deformation: Case Study , 2003 .

[16]  Dae-Wook Park,et al.  USE OF THE ASPHALT PAVEMENT ANALYZER AND REPEATED SIMPLE SHEAR TEST AT CONSTANT HEIGHT TO AUGMENT SUPERPAVE VOLUMETRIC MIX DESIGN , 2003 .

[17]  Geoffrey M. Rowe,et al.  Alternate Shift Factor Relationship for Describing Temperature Dependency of Viscoelastic Behavior of Asphalt Materials , 2011 .

[18]  Krishna Prapoorna Biligiri,et al.  Rational Modeling of Tertiary Flow for Asphalt Mixtures , 2007 .

[19]  James Grenfell,et al.  Rutting of bituminous mixtures: wheel tracking tests campaign analysis , 2011 .

[20]  K. Rajagopal,et al.  Review of the uses and modeling of bitumen from ancient to modern times , 2003 .

[21]  B. Underwood,et al.  Determination of the appropriate representative elastic modulus for asphalt concrete , 2009 .

[22]  R. Christopher Williams,et al.  Preliminary Dynamic Modulus Criteria of HMA for Field Rutting of Asphalt Pavements , 2010 .